Sun Microsystems DLT4700 Manuale utente

Installation

9. Turn on the power to the peripherals and then to the workstation.

5. Set the SCSI address switch to the correct SCSI address.

7. Turn off the power to the workstation and the peripherals.

8. Connect the cables.

See the “Cable Connections” section.

4. Determine the SCSI address

(target ID) for the tape drive.

3. Shut down the operating system.

11. See Chapter 5 of the Quantum Tape Mini-Library Product Manual

for more information.

6. Set the voltage select switch to the correct voltage.

The auto-loader is set for 220V operation. If you are using 110V, you

must change the select switch. See the illustration on the next page.

1. Make sure that total length for each SCSI bus (including internal

cable lengths) is less than 6 meters (20 feet).

The internal SCSI cable length for this auto-loader is 0.35 meters

(14 inches).

Solaris Handbook for

SMCC Peripherals

Solaris AnswerBook™

on-line documentation

10. Conﬁgure the system.

Remember to reboot your system using boot -r

2. For Solaris™2.4, 2.5, and 2.5.1 operating systems, add the

following to the /kernel/drv/st.conf ﬁle.

(Note - There must be ﬁve spaces between “SUN” and “DLT”.)

tape-config-list=

“SUN DLT4700”, “Quantum DLT 4700 Mini-Library”, “QDLT”;

QDLT =1,0x36,0,0xD639,4,0x80,0x81,0x82,0x83,2;

Operation

Read the Quantum CompacTape Handling and Storage Guidelines, this guide, and

chapters 1, 2, and 5 of the Quantum Tape Mini-Library Product Manual, before

operating the auto-loader.

Note – Many of the illustrations and procedures in the Quantum Tape Mini-

Library Product Manual do not apply to the SPARCstorage 4700 Tape Auto-

loader. The illustrations and procedures in this guide take precedence over the

Quantum documentation.

System Diagnostic Support

SunVTSand SunVTS_PROsupport for Solaris 2.5.1 and prior operating

systems is available by applying patch-id number 103097-01 to your system.

Use your normal service channels to obtain this patch. This auto-loader is not

supported by SunDiag.

SCSI connectors SCSI address

switch

Power switch

Voltage select switch

Power connector

Density Speciﬁers

Density speciﬁers override the front-panel settings. Refer to the st man pages

for more information.

Software Commands

Brief descriptions of some commonly used software commands are in the

following table. Refer to the Solaris Handbook for SMCC Peripherals, man pages

or AnswerBook on-line documentation for more information.

Density

speciﬁers Cartridge Types and Capacities

CompacTape IV CompacTape IIIxt CompacTape III

l, h 20 Gbytes 15 Gbytes 10 Gbytes

m, c 40 Gbytes130 Gbytes120 Gbytes1

1Assumes a typical compression ratio of 2:1. The compression ratio will vary depending

upon the type of data being compressed.

Command Description

ufsdump Creates incremental or full backups. The -l option is used to

sequence tape cartridges for large back ups.

ufsrestore Retrieves data backed up using ufsdump

tar Creates tape archives and adds or extracts ﬁles

mt Sends commands to magnetic tape devices

st Acts as a device driver and interface to SCSI tape devices

tapetool OpenWindows™ tool that reads ﬁles from tape or archives ﬁles to tape

cpio Copies ﬁle archives in and out

The Network Is the Computer™

Sun Microsystems Computer Company

Tape Cartridge

Follow the guidelines in the Quantum CompacTape Handling and Storage

Guidelines.

In addition:

•Use only the labels that were supplied with the cartridge. The use of other

labels may cause the cartridge to jam in the tape drive.

•Do not move a SPARCstorage DLT 4700 tape auto-loader with cartridges

installed. Doing so can damage the auto-loader and the cartridges.

Cleaning

In normal operating conditions, this drive does not require periodic cleaning.

When cleaning is required, the front-panel “Use Cleaning Tape” LED will light.

Use a CleaningTape III or equivalent cleaning cartridge. Follow the instructions

included with the cartridge.

Cable Connections

This auto-loader was shipped with one 50-50 pin and one 50-68 pin SCSI cable.

If you are connecting the auto-loader with wide-SCSI devices (68 pin), then the

tape drive should go at the end of the chain.

If you are connecting the auto-loader with other narrow-SCSI devices (50 pin),

then placement is up to you.

Note – A SCSI terminator must be used if the last device in the chain does not

have automatic SCSI termination.

Ordering Sun Documents

The SunDocs Order Desk is a distribution center for Sun Microsystems

technical documentation. It accepts all major credit cards and company

purchase orders. You can order documentation in the following ways:

Reader Comments

Your comments and suggestions are important to us. Please let us know what

you think about the SPARCstorage 140-280 Gbyte DLT 4700 Auto-Loader

Installation and User’s Guide, part number 802-5688-10.

You can send detailed comments through email to [email protected] or a fax

to SMCC Document Feedback at 1-415-786-6443.

In the U.S.A. Outside the U.S.A.

Fax 1-801-373-6798 Fax 1-801-373-6798

Call 1-800-247-0250 Call 1-801-342-3450

World Wide Web: http://www.sun.com/sundocs/catalog.html

1996 Sun Microsystems, Inc., 2550 Garcia Avenue, Mountain View, California 94043-1100 U.S.A.

Inc. in the United States and other countries. All SPARC trademarks, including the SCD Compliant logo, are trademarks or registered

trademarks of SPARC International, Inc. in the United States and other countries. SPARCstation is licensed exclusively to Sun

Microsystems, Inc. Products bearing SPARC trademark are based upon an architecture developed by Sun Microsystems, Inc.

THIS PUBLICATION IS PROVIDED “AS IS” WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED,

INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR

PURPOSE, OR NON-INFRINGEMENT.

1996 Sun Microsystems, Inc., 2550 Garcia Avenue, Mountain View, Californie 9043-1100 U.S.A.

Inc. aux Etats-Unis et dans certains d’autres pays. Toutes les marques SPARC, y compris le logo SCD Compliant, sont des marques

déposées ou enregistrées de SPARC International, Inc. aux Etats-Unis et dans d’autres pays. SPARCstation est exclusivement licenciée

à Sun Microsystems, Inc. Les produits portant la marque SPARC sont basés sur une architecture développée par Sun Microsystems,

Inc.

CETTE PUBLICATION EST FOURNIE "EN L’ETAT" SANS GARANTIE D’AUCUNE SORTE, NI EXPRESSE NI IMPLICITE, Y

COMPRIS, ET SANS QUE CETTE LISTE NE SOIT LIMITATIVE, DES GARANTIES CONCERNANT LA VALEUR MARCHANDE,

L’APTITUDE DES PRODUITS A REPONDRE A UNE UTILISATION PARTICULIERE OU LE FAIT QU’ILS NE SOIENT PAS

CONTREFAISANTS DE PRODUITS DE TIERS.

Part No.: 802-5688-10 Revision A January 1996

140-280GbyteSPARCstorage

™

DLT4700Auto-Loader

InstallationandUser’sGuide

Altri manuali Sun Microsystems Magazzinaggio

Sun Microsystems

Sun Microsystems Sun StorEdge 5210 NAS Manuale

Sun Microsystems

Sun Microsystems Sun Fire E25K Manuale utente

Sun Microsystems

Sun Microsystems StorEdge 3000 Series Guida all'installazione

Sun Microsystems

Sun Microsystems Sun Blade 100 Manuale utente

Sun Microsystems

Sun Microsystems StorEdge D2 Guida all'installazione

Sun Microsystems

Sun Microsystems TIMBERWOLF 9740 Manuale

Sun Microsystems

Sun Microsystems StorEdge Series Manuale utente

Sun Microsystems

Sun Microsystems StorageTek SL500 Manuale utente

Sun Microsystems

Sun Microsystems StorEdge S1 Array Manuale

Sun Microsystems

Sun Microsystems Blade 6000 Manuale utente

Sun Microsystems

Sun Microsystems StorEdge N8200 Manuale di installazione e funzionamento

Sun Microsystems

Sun Microsystems Sun StorEdge A1000 Guida all'installazione

Sun Microsystems

Sun Microsystems StorageTek T9840 Istruzioni per il montaggio

Sun Microsystems

Sun Microsystems StorageTek StreamLine SL8500 Istruzioni per l’uso

Sun Microsystems

Sun Microsystems Ultra Enterprise 6000 Systems Istruzioni operative

Sun Microsystems

Sun Microsystems Sun StorEdge T3 Istruzioni operative

Sun Microsystems

Sun Microsystems Sun Fire B1600 Administration Manuale elenco delle parti

Sun Microsystems

Sun Microsystems SPARCstorage DLT 4000 Manuale utente

Sun Microsystems

Sun Microsystems StorEdge 6920 System Istruzioni originali

Sun Microsystems

Sun Microsystems Enterprise 4000 Manuale di istruzioni per l'installazione

Sun Microsystems

Sun Microsystems StorEdge 3900 Series Manuale utente

Sun Microsystems

Sun Microsystems StorEdge 3510 Manuale utente

Sun Microsystems

Sun Microsystems Sun Storage J4200 Manuale elenco delle parti

Sun Microsystems

Sun Microsystems StorEdge N8600 Filer Manuale di installazione e funzionamento

Manuali Magazzinaggio popolari di altre marche

QNAP

QNAP TS 32PXU Series Manuale utente

LaCie

LaCie RUGGED RAID Manuale utente

Freecom

Freecom CLS DOCK Manuale utente

PNY

PNY Attache P-FD64MBATT3 Manuale utente

HP StorageWorks MSL2024 Manuale utente

OLT

OLT 6x6 Maximizer Manuale utente

Transcend

Transcend JetFlash 160 Manuale utente

LaCie

LaCie RUGGED MINI Manuale utente

Thunderbolt

Thunderbolt 600 Manuale utente

Panasonic

Panasonic LB-DH8 series Manuale

Intel

Intel RAID High Availability Manuale utente

LaCie

LaCie 12big Thunderbolt 3 Manuale utente

Spectra Logic

Spectra Logic T-Series Spectra T50e Manuale utente

Panasonic

Panasonic LKM-F931-1 Manuale utente

Tabernus

Tabernus Enterprise Erase E2400 Manuale utente

Rocstor

Rocstor COMMANDER 3F series Manuale utente

HP P9000 Manuale utente

Western Digital

Western Digital Ultrastar Data60 Manuale utente