Sungrow SH6.0RT Guida all'installazione

© 2021 Sungrow. All rights reserved. Subject to change without notice. Version 1.1

Sungrow Deutschland GmbH | Balanstr. 59 | 81541 München | www.sungrowpower.com

3-phase Hybrids-FAQ

Replacement or expansion of residential energy

storage battery module

Applicable to: SBR HV Batteries

Scenario:

1. If the customer needs to add more battery modules (for example, add two

battery modules to an existing SBR096).

2. If one battery module is faulty and new battery module needs to be

replaced.

3. If two battery modules need to be removed.

Solution:

For scenarios 1 and 2, the battery modules in use need to be charged or discharged

to SOC of the new battery. New battery’s SOC can be estimated with knowing

manufacturing date and storage time. (see below table)

© 2021 Sungrow. All rights reserved. Subject to change without notice. Version 1.1

Sungrow Deutschland GmbH | Balanstr. 59 | 81541 München | www.sungrowpower.com

Assume for example that the SOC of the new battery module is 20%, and the

battery on user site is 70%, please proceed as follows:

Select Compulsory Mode in the Energy Management Parameters and set Charge

as a charging command.

Apply the settings.

Set the SOC Upper Limit to 100% and the SOC Lower Limit to 20 % (calculated

value for the new battery). Apply the settings. By charging the battery to 100%, a

calibration is performed to improve the accuracy of SOC.

(This takes some time, can be omitted and the target SOC value can be directly set

and charged or discharged to the target SOC.)

© 2021 Sungrow. All rights reserved. Subject to change without notice. Version 1.1

Sungrow Deutschland GmbH | Balanstr. 59 | 81541 München | www.sungrowpower.com

After charging to 100%, select discharge and Apply the settings. The battery will

automatically discharge to 20% and stop.

Now the battery SOC on user site is the same as SOC of the new battery module

20%, so the installer can install the new battery module.

After replacement, stop Compulsory mode and reset Upper and Lower SOC Limit

to its original values. (default: SOC upper limit 100%, SOC lower limit 10%

For scenario 3, we can remove two modules directly, because the power of the five

modules is the same. If we remove two battery modules, the remaining three

battery modules will also work normally.

For further information, please download the user manual here.

© 2021 Sungrow. All rights reserved. Subject to change without notice. Version 1.1

Sungrow Deutschland GmbH | Balanstr. 59 | 81541 München | www.sungrowpower.com

This manual is intended for professional technicians who are responsible for

installation, operation, maintenance and troubleshooting of inverters, and users

who need to check inverter parameters. The inverter must only be installed by

professional technicians.

The professional technician is required to meet the following requirements:

•Know electronic, electrical wiring and mechanical expertise, and be familiar

with electrical and mechanical schematics.

•Have received professional training related to the installation,

commissioning and troubleshooting of electrical equipment.

•Be able to quickly respond to hazards or emergencies that occur during

installation, commissioning and troubleshooting.

•Be familiar with local standards and relevant safety regulations of electrical

systems.

•Read this manual thoroughly and understand the safety instructions related

to operations.

Questo manuale è adatto per i seguenti modelli

2

Indice

Altri manuali Sungrow Invertitore

Sungrow

Sungrow PVS-24MH Manuale utente

Sungrow

Sungrow PowerStack-ST535kWh-250kW-2h Guida utente

Sungrow

Sungrow SG2.0RS-S Manuale utente

Sungrow

Sungrow SG33CX Manuale utente

Sungrow

Sungrow SG250K3 Manuale utente

Sungrow

Sungrow ST4200KWH-2000 Guida utente

Sungrow

Sungrow SG2500U-MV Guida utente

Sungrow

Sungrow SH5K Manuale utente

Sungrow

Sungrow SG80KTL Manuale utente

Sungrow

Sungrow SG30CX Manuale utente

Sungrow

Sungrow SG2KTL-S Manuale utente

Sungrow

Sungrow SG30KTL-M Manuale del proprietario

Sungrow

Sungrow SG2K5-S Manuale utente

Sungrow

Sungrow SG75CX-P2 Manuale utente

Sungrow

Sungrow SG36KTL-M Manuale utente

Sungrow

Sungrow SG3KTL-EC Manuale utente

Sungrow

Sungrow SG80KTL Manuale utente

Sungrow

Sungrow SG125HV Manuale utente

Sungrow

Sungrow SG250HX-US Manuale utente

Sungrow

Sungrow SG110CX Manuale utente

Sungrow

Sungrow SG3.0RT Manuale utente

Sungrow

Sungrow SG3KTL-M Manuale utente

Sungrow

Sungrow SG250HX-IN-20 Manuale utente

Sungrow

Sungrow SG110CX Manuale utente

Manuali Invertitore popolari di altre marche

Fourgroup

Fourgroup Easy Manuale utente

Velleman

Velleman PI300M Manuale utente

WilTec

WilTec 61897 Manuale utente

SMA

SMA SUNNY BOY STORAGE 2.5 Manuale utente

Simplicity

Simplicity LANDLORD 316 Manuale utente

Santak

Santak SMAX 3000 Manuale utente

ATON

ATON RA.Store-3 Manuale utente

ZIEHL-ABEGG

ZIEHL-ABEGG FXET4AMQ Manuale utente

Tektronix

Tektronix CFG250 Manuale utente

Champion

Champion 200989 Manuale utente

Vanner

Vanner 20-500 Series Manuale utente

GE

GE GEP Manuale utente

Astrel Group

Astrel Group Power Reducer Guida rapida

MULTIQUIP

MULTIQUIP GDP-5H Guida

GoWISE

GoWISE PS1007 Manuale utente

Promate

Promate PM13500D ES Manuale utente

Mastervolt

Mastervolt WHISPER 3.5M3000 RPM Manuale utente

Mitsubishi Electric

Mitsubishi Electric FR-A7AZ Manuale utente