USB Interface installation 108498 - 05/16 7
Read Logger Data
To read the logger data from the USB stick proceed as follows:
1. Remove the USB stick from the AMI transmitter. Proceed according to section
“Remove USB Stick, Variant 1” on page 6.
Note: The function <Eject USB stick> has the following effect:
• the calibration history and the event history are copied to the USB stick
• the logger file will be completed (next time the USB stick is inserted a new logger
file will be created).
• the USB stick will be deactivated
2. Insert the UBS stick into the USB socket of your notebook or PC.
Depending on the Firmware there are 3 or more txt files which contain the logger
data. For example:
• Event history
• Calibration history
• Logger data
3. Copy the files to your notebook or PC.
4. Remove the USB stick and insert it into the USB interface of the AMI transmitter again
Load Firmware
To install a Firmware update from the USB stick proceed as follows:
1. Write down all customer-specific firmware settings (parameters for instrument op-
eration, configuration of signal outputs and relays etc.)
2. Download the logger data to the USB stick using the function <Eject USB stick> in
the menu Operation/Logger.
3. Remove the USB stick from the AMI transmitter. Proceed according to section
“Remove USB Stick, Variant 1” on page 6.
4. Leave the transmitter switched off.
5. Insert the USB stick into the USB socket of your notebook or PC.
6. Copy all files you need (“aout.a37”; *.hex) to the root directory of the USB stick.
7. Remove the USB stick from the USB socket of your notebook or PC
8. Insert the USB stick into the USB interface of the AMI transmitter again.
9. Close the transmitter housing.
10. Switch on power.
11. Navigate to <Installation>/<Miscellaneous>/<Load Firmware>.
12. Press [Enter] and select <yes>.
Miscellaneous 5.4.3
Language English
Set defaults no
Password
Load Firmware no
Sample ID ——————
Load Firmware
no
yes
