Swann SR11040 Manuale utente
Installation and User Guide
For model: SR11040 (all colours)
Swan Service Helpline
0845 610 4118
Retro Tall Freezer
SR11040_IM.indd 1 30/01/2014 11:00
22
Table of Contents
3. Your Refrigerator
4. Important Safeguards
5 - 6. Installation Notes
6. First Time Use
7. Food Storage Tips
8. Cleaning & Maintenance
9. Troubleshooting
10. Service & Spares, Specification, BS Plug Wiring
11. WEEE Directive, Warranty
SR11040_IM.indd 2 30/01/2014 11:00
3
Your Freezer
Flap
Middle drawer
Large drawer
Bottom drawer
Thermostat Service label
Adjustable feet
SR11040_IM.indd 3 30/01/2014 11:00
4
Important Safeguards
• Do not connect your appliance to the electricity
supply until all packing and transit protectors
have been removed.
• Leave to stand upright for at least 4 hours
before switching on to allow compressor oil
to settle
• This product must only be used for its intended
purpose i.e the storing and freezing of edible
foodstuff.
• Do not dispose of the appliance on a fire. Your
appliance contains non CFC/HFC natural
substances in the cooling system and in the
insulation, which are potentially flammable if
exposed to fire. Therefore, take care not to
damage, the cooling circuit or pipes of the
appliance in transportation and in use. In case
of damage do not expose the appliance to fire
or potential ignition source and immediately
ventilate the room where the appliance is
situated.
• See installation section for information on
suitable location.
• On delivery, check to make sure that the
product is not damaged and that all the parts
and accessories are in perfect condition.
• Ensure that the plug remains readily
accessible. Do not use multiple adaptor or
extension cables.
• Failure to observe these instructions may
invalidate your right to free service during the
guarantee period.
• Keep ventilation openings, in the appliance
enclosure or in the built-in structure, clear of
obstruction.
WARNING: Keep ventilation openings, in the
appliance enclosure or in the built-in structure,
clear of obstruction. Do not use mechanical devices
or other means to accelerate the defrosting
process, other than those recommended by the
manufacturer.
GAS WARNING CAUTION RISK OF FIRE: Due
to the flammable refrigerant (R600a) and/
or the flammable insulation blowing gas used,
this gas is natural gas with high environmental
compatibility that is, however, also combustible.
When transporting and installing the appliance,
care should be taken to ensure that no parts of the
refrigerating circuit are damaged.
Refrigerant and/or insulation blowing gas
squirting/leaking out of the pipes or body of
appliance could ignite or cause an eye injury. If leak
is detected, avoid any naked flames or potential
sources of ignition and air the room in which the
appliance is standing for several minutes. Servicing
and repair of R600a refrigerant shall be done by
qualified service technicians. Do not damage the
refrigerant circuit.
WARNING: Do not use electrical appliances inside
the food storage compartments of the appliance,
unless they are of the type recommended by the
manufacturer.
• We suggest you keep these instructions in a
safe place for easy reference.
• This appliance can be used by children aged
from 8 years and above if they have been
given supervision or instruction concerning
use of the appliance in a safe way and if they
understand the hazards involved. Cleaning
and user maintenance shall not be made by
children unless they are older than 8 and
supervised. Keep the appliance and its cord
out of reach of children aged less than 8 years.
• If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.
CAUTION: In order to avoid a hazard due to
inadvertent resetting of the thermal cutout, this
appliance must not be supplied through an external
switching device, such as a timer, or connected to
a circuit that is regularly switched on and off by the
utility company
This appliance should only be connected to an
earthed, switched mains socket. Do not use an
extension cord with this appliance
SR11040_IM.indd 4 30/01/2014 11:00
5
Installation Notes
1. The appliance should not be tilted more than 45 degrees when you move it. Do
not use force on any part such as the condenser, the door or handle. They could dis-
tort and affect the operation of the refrigerator. Ensure ALL packaging is removed
before installation
2. Make sure there is enough ventilation space around refrigerator.
3. The appliance should not be installed near external heat sources eg direct sun-
shine - or external moisture sources.
It is important that upon receipt you stand your appliance upright for at least 4
hours before switching on to allow the system to settle. Please note that the door
cannot be reversed on this product.
3cm
2cm
2cm
2cm
SR11040_IM.indd 5 30/01/2014 11:00
6
Installation Notes
4. Ensure the supply voltage of socket is same as rating label.
5. The plug must be properly inserted to the wall socket.
6. The mains supply socked must be earthed - preferably with a switch. If it is not
earthed, do NOT install this appliance there. Do not use an extension cord
7. The product is equipped with adjustable feet. Once the product is in place, adjust
these to ensure the fridge is level and doesn’t rock.
DO NOT SITE THE PRODUCT WHERE THE AMBIENT TEMPERATURE IS LIKELY TO
DROP BELOW 5 DEGREES CENTIGRADE - EG: GARAGE OR SHED
1. It is important that upon receipt you stand your appliance upright for at least 4 hours
before switching on to allow the system to settle. Remove all packaging & any transit tapes
2. Clean the inside of the cabinet with a soft, dry cloth prior to switching on
3. When using the product for the first time, set the thermostat inside the product to 1
without any food inside. When it starts, you will hear the quiet hum of the compressor. You
may also hear the circulation of liquids and gases in the refrigeration system. This is normal
on first start up, Generally it will take 3 hours for the appliance to reach temperature. Once
temperature has been reached then put the food inside.
4. The temperature of the freezer can be adjusted by rotating the disc of the thermostat. The
higher the value on the setting of the thermostat, the colder it will be
5. Do not put too much food in the freezer. Avoid opening the doors too frequently as this will
waste energy and can cause excessive frost build-up.
First Time Use
SR11040_IM.indd 6 30/01/2014 11:00
7
Food Storage Tips
FREEZER COMPARTMENT
• Store food in small portions
• Seal food in containers with lids, in plastic wrap or in plastic bags to prevent drying and
the mingling of odours.
Wrapping food
• Pack the food in suitably sized portions for your household.
• Vegetable and fruit portions should be no heavier than 1 kg, while meat portions can be
up to 2.5 kg.
• Smaller portions freeze through more quickly and the quality is thereby maintained bet-
ter when defrosting and preparing the food.
• It is important to seal food in airtight bags or containers before freezing to prevent it
from losing flavour or dehydrating.
• Wrap the food, press out any air and seal it airtight.
Suitable wrapping materials:
• Plastic bags, cling-film, aluminium foil and freezer containers. These items are available
from any dealer.
Unsuitable wrapping materials:
• Wrapping paper, greaseproof paper, cellophane, bin bags or used carrier bags.
Suitable sealing materials:
• Rubber bands, plastic clips, string, freezer tape or similar.
• Plastic film and bags may be heat-sealed using a special sealing iron or press.
• Before placing a package in the freezer, it should be clearly labelled with the contents
and date of freezing
• Do not put warm/hot foods in the freezer
• Keep the seal clean so as not to lose cold air and overwork the compressor
• Try to leave enough air space around foodstuffs to allow good circulation of cold air
SR11040_IM.indd 7 30/01/2014 11:00
8
Cleaning & Maintenance
DAILY CLEANING
The outside of your refrigerator can be cleaned using a soft cloth moistened with a mild
detergent solution. Wipe dry with kitchen towel.
Do not use chemical or abrasive cleaners on any part of your refrigerator as these could
permanently damage or discolour the surfaces.
DOOR SEALS
Ensure that the door seals are kept free from debris at all times. If they don’t seal properly this
can waste energy and cause excessive ice build-up
PERIODIC MAINTENANCE & DEFROSTING
From time to time, it may be necessary to perform more extensive cleaning to keep your
refrigerator in top condition and to maintain energy efficiency.
Before performing any of these maintenance steps, switch off your refrigerator and remove
the plug from the mains socket. Allow the freezer section to defrost thoroughly.
DO NOT use metal objects to remove ice etc. Use the scraper provided with the product.
DEFROST PROCESS
• Remove all foods, ice cube tray and drawers
• Turn the thermostat to the OFF position
• Clean and wipe melted frost with a cloth
• After defrosting, turn the thermostat back to original position and replace the drawers
• Unless you can move the food to another freezer during the defrost process, it will not be
suitable for re-freezing!
SR11040_IM.indd 8 30/01/2014 11:00
9
Troubleshooting
1. If the refrigerator does not run:
Check the supply voltage is available at the socket and check that the power plug is
correctly connected.
2. If the refrigerator does not become cold enough:
a. is the thermostat is set too low?
b. is there enough space around the refrigerator?
c. is the door is opened too frequently or not closed properly? (check seals).
d. is there direct sun shine on the appliance or are there heat sources nearby?
e. is there too much food inside the compartment?
f. is there dust and debris built up on cooling matrix or compressor?
3. If the refrigerator operates noisily:
a. Check that the appliance is installed on a stable, level floor. Adjust the feet if nec-
essary. The refrigerator is too near the wall
b. The food stored in the refrigerator is not touching - particularly applies to glass
containers. The refrigerator creates very slight vibrations, which can be amplified
greatly with touching glass containers!
Note:
During high relative humidity environment, condensation may occur on the surface
of the refrigerator. This is not a malfunction. Simply clean the surface of condensa-
tion.
If the refrigerator is not working properly after all these checks, contact the service
centre without further delay.
SR11040_IM.indd 9 30/01/2014 11:00
10
Service and Spares
If you experience any problems at all with your refrigerator or require spare parts,
expert help is just a phone call away!
0845 610 4118
You will need to quote the model and serial number of your appliance. This is printed
on the service label just inside the door under the thermostat.
BS Plug Wiring
The wires in the mains lead are coloured in accordance with the following code:
BLUE NEUTRAL
BROWN LIVE
GREEN/YELLOW EARTH
As the colours of the wire in the mains lead of this appliance may not correspond with the colour markings
identifying the terminals on your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or
coloured black. The wire which is coloured BROWN must be connected to the terminal which is marked
with the letter L or coloured red. The wire which is coloured GREEN/YELLOW must be connected to the
terminal which is marked with the letter E or (earth symbol) and is coloured GREEN or GREEN/YELLOW.
WARNING: THIS APPLIANCE MUST BE EARTHED
Specifications
Freezer volume: 235 Litres
Freezing capacity: 15kg/24 hours
Energy A+
Classification: ****
Foaming agent: Cyclopentane
Refrigerant: R600a (95g)
Dimensions: (H)1808 x (W)590 x (D) 650
Power consumption: 0.73kW/24 hours
Voltage: 220-240V ~ 50Hz
Climate type: N/ST
Protection class: I
SR11040_IM.indd 10 30/01/2014 11:00
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali Swann Congelatore
