Swiftech MCW5000-PX Manuale utente

Swiftech Inc., 1703 E. 28th St., Signal Hill, CA 90755 T. (562) 595-8009 F. (562) 595-8769

Parts list

Parts QTY PARTS QTY

MCW5000-PX™ assembly 1 Arctic Alumina Thermal compound 1

Tube inserts 4

Tube removal tool 1

This product is intended for expert users. Please consult with a qualified technician for installation. Improper installation may result in

damage to your components. Swiftech assumes no liability whatsoever, expressed or implied, for the use of these products, nor their

installation. The following instructions are subject to change without notice. Please visit our web site at www.swiftnets.com for updates

1. Before you install the MCW5000-PX™water-block:

a. Prepare two pieces of tubing of sufficient length to connect to

the rest of your circuit. The cuts must be square as shown in figure

1 or leaks may occur:

b. Install the provided plastic tube inserts at each end of the tubes,

as shown in figure 2: these inserts are absolutely imperative when

using any kind of soft tubing, such as vynil, ClearFlex, Taigon, etc...

Square cut

Figure 1 Figure 2

Figure 3

Figure 4

Figure 5

c. Spread a little bit of grease or soap (Vaseline,

dishwashing liquid, etc..) around the tubing. It helps

pushing the tubes in, particularly with Clearflex

tubing, which features a very “sticky” surface.

d. Fully insert both tubes into the fittings. The tip of the plastic tube inserts should

be flush with the inlet and outlet openings, as shown in figure 4 above. Inserting the

tubes requires a firm push, accompanied by a twisting motion.

2. Preparing your Motherboard

 Remove the existing heat sink

 Carefully clean the CPU.

 Lightly coat the CPU with the provided thermal compound. Only a paper-thin coat is necessary. It should be applied using

preferably a razor blade, or a credit card, held between thumb and index at a 45-degree angle.

3. MCW5000-PX™ water-block installation diagram

The MCW5000-PX water-block installs using Intel’s validated retention clips. Please use the retention clips, and

installation guide provided with your motherboard for installation of the water-block onto the CPU.

Page 1 of 2

Swiftech Inc., 1703 E. 28th St., Signal Hill, CA 90755 T. (562) 595-8009 F. (562) 595-8769

4. Connecting the water-block(s) to the cooling circuit.

FAQS:

 Inlet and outlet are interchangeable.

 In Multi-Processor environments, optimal water-block performance will be achieved by connecting them in series (outlet

of one connected to the inlet of the other).

 Recommended coolant: distilled water+ algaecides & corrosion inhibitors are mandatory (automotive antifreeze).

5. Final inspection

Once the installation is completed, it is always a good idea to test the circuit for leaks, prior to powering up the computer.

Troubleshooting help is available on our web site at www.swiftnets.com, or by calling customer support at 562-595-8009.

Note concerning removal of the tubing: Push in collet squarely against face of fitting. A tube removal tool is provided with

the MCW5000 block. With the collet firmly held against the face of the fitting, the tube can be safely pulled out. Do not attempt to pull

the tube out without pushing squarely against the collet. This may result in damaging the fitting. Further details for using quick-connect

fittings are also available here: http://www.johnguest.com/install_6.shtm#disconnect:

Page 2 of 2

Indice

Altri manuali swiftech Hardware per computer

swiftech

swiftech Maelstrom 5 1/4 Dual Bay Reservoir Series Manuale utente

swiftech

swiftech MCW5000-P Manuale utente

swiftech

swiftech MCX370-A Manuale utente

swiftech

swiftech MCW40-T Manuale utente

swiftech

swiftech MCP35B Manuale utente

swiftech

swiftech MCW20-A Manuale utente

swiftech

swiftech Stealth Manuale utente

swiftech

swiftech MCW5000-PX Manuale utente

swiftech

swiftech Obsidian Manuale utente

swiftech

swiftech MCB120 Radbox Manuale utente

swiftech

swiftech MCP35X RESERVOIR Manuale utente

swiftech

swiftech MCW5000-64 Manuale utente

swiftech

swiftech MCW5000-64RH Manuale utente

swiftech

swiftech Stealth Manuale utente

swiftech

swiftech POLARIS Series Manuale utente

swiftech

swiftech MCW82 Manuale utente

swiftech

swiftech MCW5000-64 Manuale utente

swiftech

swiftech MCX462+ Manuale utente

Manuali Hardware per computer popolari di altre marche

EMC2

EMC2 VNX Series Manuale del proprietario

Panasonic

Panasonic DV0PM20105 Manuale utente

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Manuale utente

Gigabyte

Gigabyte B660M DS3H AX DDR4 Manuale utente

Raidon

Raidon iT2300 Manuale utente

National Instruments

National Instruments PXI-8186 Manuale utente

Hauppauge

Hauppauge WinTV-HVR-2250 Manuale utente

Kontron

Kontron CP6002 Manuale utente

Manhattan

Manhattan 702843 Manuale utente

Aphex

Aphex 230 Manuale utente

AMD

AMD Phenom II Manuale operativo

Intel

Intel NUC 12 Pro Manuale utente

dbx

dbx Zone Pro 1260 Manuale utente

Galaxy

Galaxy GHDX2-2430S-24F4D Manuale utente

Intel

Intel AXXRMFBU4 Manuale utente

Kontron

Kontron DIMM-PC/MD Manuale utente

ST X-NUCLEO-SAFEA1B Istruzioni operative

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Manuale utente