L i n e A m p s : 1 2 . 0
T r i p P t : ( 1 5 . 0 )
Overload Trip Screen: Displays the current drawn by the pump motor and the overload trip
point.
Line Amps:This feature eliminates the need for an ammeter, and will help determine if
the pump is drawing acceptable amperage.
Overload Trip Point:This level will be 125% of the current seen by the PumpSaver®at
the time of calibration. If the amperage drawn by the pump motor exceeds this level, the
PumpSaver®will trip on overload (after the trip delay). Excessively high or low voltage, a
worn pump, or a jammed impeller may cause overload.
L i n e V o l t s : 2 3 0
C a l . V o l t s : ( 2 3 0 )
Calibration Voltage Screen: Displays the line and calibration voltages.
Line Voltage:Displays the line voltage to the pump motor. If the voltage displayed is less
than 190VAC or greater than 265VAC on a 230 volt system, or is less than 95VAC or
greater than 132VAC on a 115 volt system, the power company should be contacted.
Calibration Voltage:Displays the line voltage at the time the PumpSaver®was calibrated,
providing a point of reference when line voltage fluctuations are a problem. If a large
difference in voltage exists (greater than 15%) between line voltage and calibrated
voltage, the power company may need to be contacted.
R s t D l y S e t : 3 0 m
R s t D l y : 1 2 m 1 8 s
Restart Delay Screen*: Displays the restart delay setting and the restart delay time remaining
before the PumpSaver®Plus will reset.
C T S i z e : n / a
P u m p S t a r t s : 2 1 3
CT Size and Number of Pump Starts Screen*: Displays the size of the CT used (if
applicable), and the number of pumps starts**.
T o t a l R u n T i m e :
2 7 d 1 6 h 3 3 m
Total Run Time Screen*: Displays the total run hours** of the motor.
*PumpSaver®Plus models only.
**Run hours, number of pump starts, and fault history can be cleared—refer to the PumpSaver®Plus
installation instructions for details.
