- 4 EQ controls HIGH, MID HIGH. MID LOW and LOW with ±15dB boost/attenuation.
- Gain for adjusting the input signal level.
The 2 outputs have great amplitude and can deliver up to +18dBu or 6.3Vac of distortion-free
signal.
- Level for output control.
All 3 inputs have independent controls for:
The Player accepts USB DRIVE up to 64GB size, containing MP3 and WMA audio les until
320Kbps bit rate (high quality). Its Bluetooth has the 4.0 version and operates under
SBC/A2DP protocol.
It has a 4-band equalizer that allows you to increase or decrease specic ranges of bass, mid-
bass, mid-high and treble, allowing professional control in any situation. Its outputs with
timed MUTE avoid undesirable noises (Pops) when turned on or off, dispensing with the
sequencing of activations, facilitating installation.
CHANNELS 2 and 3 feature shared L+R type RCA inputs with an RTS connector for greater
connection exibility.
With a total of 72 variable lighting effects, causing a different visual effect for the user. See
pages 08 and 09.
The mixer was designed for sound systems allowing the T 0302 PLAYER MULTICOLOR
mixing of several types of audio signals with high delity, ensuring the original dynamics of
the sound. It has a convenient MP3/WMA player, Bluetooth and FM built-in with long range
remote control.
The T 0302 FX MULTICOLOR features 3 input channels, CHANNEL 1 is balanced with two
shared connections, one XLR and one RTS. This is a high-sensitivity, wide-gain input, which
allows the use of a Microphone or LINE IN.
The sound mixer must be fixed in an easily accessible and
ventilated place. It is not recommended to install the
product on the sides of speakers, as vibrations can
damage their internal components.
In order to avoid noise captation, use good quality
shielded signal cables and connectors.
2 - Borne on the battery negative.
As protection, a fuse must be installed close to the positive
pole of the battery (2A fuse). check for more details on
pag. 16 of this manual. For the REMOTE connection, use
0.5 mm² wire.
1- Borne on the battery positive
Use the P4 adapter with terminal that comes with the
product to connect the power wires to the vehicle's 12V
battery. Use 1.5mm² gauge wires for both the positive and
negative wires. Screw the wires according to the following
instruction:
Presentation
Important recommendations
it is recommended to install a 2 Amperes fuse on the positive supply terminal.
Check power polarity and recommended gauge.
CAUTION
03
RGB EFFECTS
► USB
SD MP3
MHz
88 88
:
