15
K580M
10 - 12 PHOTOCELLS
opening in order to allow the obstacle to be removed (if dip switch
IN SERIES.
Note: the photocell transmitter must always be supplied by
terminals no. 13 - 15, since the safety system test (photo-
test) is carried out on it. To override the testing of the safety
system, or when the photocells are not used, set dip-switch
no. 6 to OFF. If the photo-test is not successful, the control
unit will not operate.
13 - 14 RX
PHOTOCELLS
13 - 15 TX
PHOTOCELL
16 - 17 GATE OPEN
LED
18 - 19 2nd RADIO
CHANNEL
Warning: to connect other devices to the 2nd Radio Channel
(area lighting, pumps, etc.), use an additional auxiliary relay.
20 - 21 AERIAL
M1 LIMIT
SWITCH
(CLS),
(OLS)(COM)
M2 ENCODER (GND),
(+5V)(ENC)
FS1 - FS2 CAPACITOR
M3 230V AC
MOTOR
(M-COM) (M-CL)
(M-OP).
LOGIC ADJUSTMENTS
TRIMMER
FR.
Turning the
trimmer clockwise (+) increases the motor torque, turning it anticlockwise (-) re-
duces it.
SENS Adjustable only with ENCODER enabled (DIP 11 ON).
Note: by rotating the TRIMMER FR. clockwise the sensitivity to obstacles of the
operaor decreases vice-versa, by rotating it
anti-clockwise, the sensitivity to obstacles of the operator increases and therefore
the thrust force decreases.
WARNING: with the trimmer at maximum, the obstacle detection is disabled!!
T.C.A.
Dip switch
1AUTOMATIC
CLOSING
On after opening, the gate automatically closes when the delay set on the
Off automatic closing disabled.
ENGLISH
