Techfury TF-3GSDI-CAM Manuale utente

3G-SDI camera user manual

Page 1

TF-3GSDI-CAM:

3G-SDI

Camera

User Manual

Megapixel CMOS Box & Module Camera

Version 1.4

www.techfury.com

sales@techfury.com

Page 2

3G-SDI Camera user manual

INFORMATION - This equipment has been tested and found to comply with limits for a Class A digital

device, pursuant to part 15 of the FCC Rules & CE Rules. These limits are designed to provide reasonable

protection against harmful interference when the equipment is operated in a commercial environment.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used

in accordance with the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference in which case

the user will be required to correct the interference at his/her own expense.

WARNING - Changes or modifications not expressly approved by the manufacturer could void the

user’s authority to operate the equipment.

CAUTION - To prevent electric shock and risk of fire hazards:

Do NOT use power sources other than those specified.

Before You Start

This manual should help you in the installation and set-up of the camera; and we recommend that you

carefully follow the instructions described. To ensure that your warranty remains valid, please read the

manual carefully before using the camera.

Precautions

- Please DO NOT disassemble, modify or repair the camera. There are no user serviceable parts inside

and disassembling the camera may void the warranty. For prevention of fire or electric shock, DO NOT

removes screws or covers from the camera. (Only TF-3GSDI-CAM)

- Operation in a wet environment is NOT recommended. The camera SHOULD NOT be exposed to rain

or moisture.

3G-SDI camera user manual

Page 3

- For prolong life and the protection of the camera’s image sensor, do not point the camera directly at

the sun or a strong spotlight which may result in image sensor blooming and permanent damage.

- DO NOT operate the camera beyond the operation temperature range stated and AVOID usage in

conditions exceeding 90% humidity.

- DO NOT use an unregulated power supply source to prevent damage to the camera’s circuits.

- Use soft materials such as lens tissue or cotton tipped applicator with ethanol for image sensor

faceplate cleaning ONLY when necessary and AVOID contact with fingers or any hard object. Do not

use solvent, abrasives or detergent when cleaning the camera body.

- Warranty shall be voided for improper use of the camera caused by the user; or damage caused by

other equipment due to negligence.

Warranty

TECHFURY warrants the original components free of defects for one year from the purchase date. This

warranty covers failures and damage due to defect, which may occur during normal use. It does not

cover damages or failure resulting from mishandling, abuse, misuse or modification. An RMA number

must be obtained in advance for every repair or replacement.

All the materials in this document are protected by copyright and other laws for intellectual property.

They are not allowed to be copied, reproduced or modified for any use without the permission of

TECHFURY. TECHFURY reserves the right to make changes in specifications, functions or designs at any

time and without any notice. The company names in this document may be the trademarks and trade-

names of their respective owner; and are hereby acknowledged.

Page 4

3G-SDI Camera user manual

1. Main Features

▶1/3” CMOS sensor

2.2M Pixels (Total) / 2.1M Pixels (Active)

▶Full HD Resolution

1920x1080@30/25p, 1920x1080@60/59.94/50i

1280x720@30/25p, 1280x720@60/59.94/50p,

1920x1080@60/59.94/50p

▶WDR (Wide Dynamic Range)

WDR allows a camera to filter the intense back light surrounding a subject and thus enhances the

ability to distinguish features and shapes on the subject.

▶DNR (Digital Noise Reduction, 2D/3D-NR)

DNR technology will supply you with outstanding clear images by reducing noise of picture. DNR

technology has excellent disk-saving effect. TECHFURY supports brilliant DNR technologies like

DNR, 3D-NR and 2D+3D.

▶AGC (Automatic Gain Control)

AGC is circuit that automatically adjusts the incoming signal to proper level for display or recording

and the sensitivity of pick-up object to render the most pleasing images. It improves performance

in low light conditions.

▶2 Auto (AE/AWB) Control

Slow Shutter control (Sens-Up), Color temperature Range (1800K ~ 10500K).

▶Dynamic Motion Detection (8 separable areas, Up to 1980-blocks, variable block size

control)

Motion can be detected and displayed in appointed area. It is possible to set up motion detection

zones user wish.

▶Privacy Zone Masking (8 Polygon windows)

The privacy zone function makes it possible to make specific areas of the scene from view.

▶Output

3G-SDI / HD-SDI (NTSC / PAL)

3G-SDI camera user manual

Page 5

2. Name and Function of Each Part

2.1. TF-3GSDI-CAM

Side

Name Function

▶Holder For attaching a bracket to the camera

▶Lens Mount Adaptor ring is tightened for C or CS mount lens

Rear

Name Function

▶RS-485 ▶RS485_A_D+ ▶RS485_A_D-

I/O Port ▶Trigger Signal Input(Act: High)

(Trigger Input Image Masking or Freeze/Play selectable)

▶Motion/Trigger Common GND

▶-

▶Motion Signal Output(Act: High)

Power ▶DC Power (+) ▶DC Power (-) Ground (DC12V ~ 24V)

▶HD-SDI Video Output BNC connector for HD-SDI video signal output

▶SETUP Switch Camera function control switch

Press and hold the switch for more than 2 seconds, then the main menu

will appear on the screen.

②

①

③

▶▶▶▶▶▶

▶ ▶

Page 6

3G-SDI Camera user manual

▶/▶Move from left side to right side, then the menu is moved

to upper menu or the parameter is changed

▲/▼Move up and down, then the menu is moved up and down

■Press and the feature is set

Press it, then it is moved to sub menu

2.2. TF-3GSDI-CAMS

3G-SDI camera user manual

Page 7

3. Other Device Connection

3.1. Monitor Connection

Connect the HD-SDI output of the monitor to the BNC connector of the camera by Coaxial

cable. The connector of TF-3GSDI-CAM is consist of MMCX(Board side) and BNC(Monitor side).

If the monitor does not support HD-SDI output, you must use HD-SDI converter.

Video output type could be set as NTSC or PAL.

3.2. Video Cable Connection

Refer to following table regarding the cable. If the distance between the camera and the

monitor is over maximum video transmission distance, separate video amp is required to use.

* Maximum HD-SDI transmission distance depends on cable manufacturer and installation

environment.

Maximum Transmission Distance Cable Requirement

100 ~ 140m 5C2V, 75ohm

200m L-6CHD, 75ohm (HDTV-SDI Cable)

3.3. Power Connection

For easy installation, TECHFURY provides special power cable to connect DC jack type of power

adapter. Connect the camera to the device, which its power is turned off.

* Camera operation guarantees power: DC 12V ~ 24V ±10%

HD-SDI

Monitor

Power Adaptor

I/O Port(N/A)

RS 485 Wire

HD-SDI

Monitor

OSD Joystick

Power Adaptor

2nd

Video(Analog)

RS 485

Trigger Input

Motion Output

TF-3GSDI-CAMS

TF-3GSDI-CAM

Page 8

3G-SDI Camera user manual

3.4. RS-485 Connection

Using RS-485 communication, it can be possible to control OSD menu and some features in

external device. Regarding features to control by RS 485, refer to register control document.

3.5. I/O Port Connection

Using Input Port, User can get triggered captured image with image marking and motion

output signal. Or according to firmware version, user can get freeze/play image.

4. OSD Menu

Press the OSD joystick of cameras rear side 1~2 seconds. Then OSD menu is shown up on

the screen.

LENS

INDOOR(Default TF-3GSDI-

CAM),OUTDOOR

Select DC Iris Lens(Not supported)

P-IRIS AUTO, MANUAL Select P-Iris Lens(Not supported)

MANUAL(Default TF-3GSDI-CAM)

Select Manual Iris Lens

VIDEO Select Video Iris Lens use(Not supported)

2. EXPOSURE

SHUTTER

AUTO(Default)

Select Auto Shutter Speed

FLK

Select in Flickering

1/30~1/50000

x2 ~ x30

Shutter Speed Manual Control

AGC Level 1-15 Adjust Auto Gain Level

SENS-UP

OFF, AUTO(Default)

The camera automatically detects the light

level

in night or dark area

x2~x30

Select the level of desired Sens-up

RIGHTNESS

0 ~ 100(Default: 40)

Adjust the screen brightness

D-WDR OFF(Default),LOW,MIDDLE,HIGH Adjust the level of dynamic range

DEFOG OFF(Default),ON

Adjust the level of defog function

Position/Size/Gradation adjustable

BACKLIGHT

OFF(Default)

WDR

GAIN Low / Middle / High

WDR OFFSET

Select the level 0~255

BLC GAIN

High / Middle / Low

3G-SDI camera user manual

Page 9

AREA

Select Position & Size

DEFAULT

BLC Factory Reset

HSBLC

SELECT

Select the area (AREA1~AERA4)

DISPLAY Select the area maintain/remove (ON/OFF)

LEVEL

Select the level 0~100

MODE

Select the activation time(ALL DAY / NIGHT)

BLACK MASK

Select the black mask (ON/OFF)

DEFAULT

HSBLC Factory Reset

WHITE BAL

ATW(Default)

Auto Tracking White Balance

AWC →SET

Set the real environment white balance.

Use the white color object and select SET button

INDOOR Select this for indoor application

OUTDOOR Select this for outdoor application

MANUAL Select this to fine-tune White Balance manually

DAY & NIGH

(

H/W- Only TF-

3GSDI

-CAM)

AUTO

DELAY Select the duration time about changing the day/night mode

D →N (AGC)

Select the percent about changing Day to Night mode(AGC based)

N →D (AGC)

Select the percent about changing Night to Day mode(AGC based)

COLOR Select the color mode

B/W

BURST Select the bust signal on/off

IR SMART

Adjust LEVEL(0~15) / AREA(Position & Size)

IR LED

Select On/Off(Not Available)

IR PWM

Select the level 0~100(Not Available)

DNR

2DNR Select On/Off

3DNR

SMART NR

Select the Smart NR mode

LEVEL

Select the level of 3DNR mode(0~100)

START. AGC

3DNR function Start percent(AGC based)(0~100)

END. AGC

3DNR function End percent(AGC based)(0~100)

SPECIAL

CAM TITLE Enter the camera title (ON/OFF)

D-EFFECT

FREEZE

Freeze the image (ON/OFF)

MIRROR

MIRROR Mirror the image (ON/OFF)

V-FLIP

Flip the image vertically

ROTATE

Flip the image horizontally

Page 10

3G-SDI Camera user manual

D-ZOOM

x2 ~ x62 / PAN&TILT / DEFAULT

SMART D-

ZOOM

AREA 1/2 / DISPLAY / SENSITIVITY (0~60) / D-ZOOM(x2~x62)

TIME (0~26) / DEFAULT (Not Available)

NEG. IMAGE Select the negative image (ON/OFF)

DIS

Not Available

MOTION

SELECT Select the area 1 ~ 4

DISPLAY

Adjust the position & size (ON/OFF)

SENSITIVITY

Select the sensitivity of motion recognition (0~100)

MOTION VIEW

Display masks on the motion detected area (ON/OFF)

DEFAULT

Motion Factory reset

PRIVACY

SELECT

Select the area (1~8)

DISPLAY

Display the privacy area on the screen (ON/OFF)

COLOR

Select the color 0~15

TRANS

Transfer 0~3

DEFAULT

Privacy Factory reset

LANGUAGE

ENG, JPN, CHN1,CHN2, KOR, GER, FRA, ITA, SPA, POL, RUS, POR, NED, TUR,

HEB, ARB

DEFECT

LIVE DPC

Select the dead pixel compensation mode in real time

(AUTO/OFF)

LEVEL (0~100)

STATIC DPC

Select the dead pixel compensation mode in static points

(ON/OFF)

START / LEVEL (0~60) / SENS-UP (x2 ~ x30)

BLACK DPC

Select the dead pixel compensation mode in black points

(ON/OFF)

START / LEVEL (0~255) / DIFT. TH (0~255)

RS485

CAM ID

Select the number of camera (0~255)

ID DISPLAY

Select the display of CAM ID (ON/OFF)

BAUDRATE

Select the baud rate (2400~38400)

VERSION Display the current Camera Version

ADJUST

SHARPNESS Adjust the level of sharpness (0~15)

MONITOR

LCD

GAMMA / ADAPT. LEVEL / BLUE GAIN / RED GAIN

CRT

BLACK LEVEL / BLUE GAIN / RED GAIN

Indice

Manuali Macchina fotografica digitale popolari di altre marche

Mercury

Mercury 350K Manuale utente

Pentax

Pentax Optio LS 465 Manuale utente

Sanyo

Sanyo VPC-S1085 Manuale utente

GE SMART A1255 Manuale utente

Point Grey

Point Grey Gazelle Manuale utente

Nikon

Nikon COOLPIX A Manuale utente

Pentax

Pentax P-5 Manuale utente

BlazeVideo

BlazeVideo A280 Manuale utente

Sony

Sony MCA-20 Manuale utente

Sony

Sony Alpha DSLR-A290 Manuale utente

ATIK Cameras

ATIK Cameras One Manuale utente

CohuHD Costar

CohuHD Costar 3930 Series Manuale utente

Leica

Leica M10-R Manuale utente

FujiFilm

FujiFilm FinePix A700 Manuale utente

Lorex

Lorex LNZ81P25 Series Manuale utente

GE J1470S Manuale utente

Sony

Sony A6700 Guida utente

Canon

Canon EOS ELAN7 Manuale utente

techfury TF-3GSDI-CAM Manuale utente

Manuali Macchina fotografica digitale popolari di altre marche