Technika TSSUR52S Manuale utente
USER GUIDE
CONCEALED UNDERMOUNT
SINGLE SPEED RANGEHOOD
TSSUR52S
TECHNIKA.COM.AU
PG 3
PG 3
CONTENTS TABLE
For Your Safety
Safety Precautions 3
Before Connecting 3
Warnings 4
Use and Care
Use and Care 6
Controls 6
Cleaning your Rangehood 7
Troubleshooting 8
Disposal 8
Installation
Electrical Connection 9
Instructions for Installation 10
Dimensions 10
Warranty 12
PG 4
FOR YOUR SAFETY
Carefully read the following important information regarding installation safety and maintenance.
Keep this information booklet accessible for future reference.
The appliance has been designed for use in a Ducted installation.
Safety Precautions
Take care when the Range Hood is operating simultaneously with an open fireplace or burner
that depend on natural ventilation as the Range Hood removes air from the room, which a
burner or fireplace may need for combustion.
Provide adequate ventilation for safe operation of the Range Hood. Follow any local laws that
apply to external air evacuation.
Before connecting to the electricity network:
Look at the data plate (located inside the appliance) to ascertain that the voltage and power
correspond to the available power supply and the power outlet is suitable. If in doubt ask a
qualified electrician.
If the appliance is used intensively for a long period of time, you may need to open a window to
improve airflow.
PG 5
• Do not check the status of the filters while the Range Hood is operating.
• Do not touch bulbs or adjacent areas, during or straight after use.
• CAUTION: Accessible parts may become hot when used with cooking appliances.
• Do not flambé under the Range Hood.
• Avoid free flame, as it is damaging to the filters and can cause fire hazard.
• Constantly check food frying, overheated oil may become a fire hazard.
• Disconnect the electrical plug prior to any maintenance.
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• There shall be adequate ventilation in the room when the Range Hood is used at the same
time as appliances burning gas or other fuels.
• There is a fire risk if cleaning is not carried out in accordance with the instructions.
• WARNING: DO NOT penetrate any screws into the range hood as this may result in
electrical hazards.
• WARNING: Failure to install the screws or fixing device in accordance with these
instructions may result in electrical hazards.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
• The air must not be discharged into a flue that is used for exhausting fumes from appliances
burning gas or other fuels.
• The minimum distance between the cooktop hob and the lowest part of the range hood
shall be at least 60cm. If the instructions for installation of the gas hob specify a greater
distance, this has to be taken into account.
• Regulation concerning the discharge of air has to be fulfilled.
• 52cm rangehoods can only be installed above hobs with 4 or less burners / elements.
• 70cm rangehoods can only be installed above hobs with 5 or less burners / elements.
• 90cm rangehoods can only be installed above hobs with 6 or less burners / elements.
THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR DAMAGES CAUSED BY
BREACHING THE ABOVE WARNINGS.
LED Lamps
LED lamp assemblies are a spare part and are not repairable or replaceable by the customer.
If an LED lamp fails, it must be replaced by a suitably qualified technician.
Please call Glen Dimplex after sales service.
FOR YOUR SAFETY
WARNINGS!
PG 6
USE AND CARE
To ensure the Range Hood continues to operate eectively, regular maintenance and cleaning is
required. Clean the fan and other surfaces of the Range Hood regularly using a cloth moistened
with warm water or non-abrasive liquid detergent.
Controls
This rangehood has a single speed motor and is designed to be operated via the power point
or an isolation switch.
When the power is connected, the fan and light will operate at all times.
When the power is switched o, the fan and light will switch o.
Please see Electrical Connection on page 9 for further details.
PG 7
USE AND CARE
The proper function of the rangehood requires regular maintenance operations.
The anti-grease filters capture the grease particles suspended in the air, and are therefore subject
to clogging according to the frequency of the use of the appliance.
In order to prevent fire hazard, it is recommendable to clean the filter at a minimum of every 2
months by carrying out the following instructions:
- Remove the filters from the cooker hood and wash them in a solution of water and
neutral liquid detergent, leaving to soak.
- Rinse thoroughly with warm water and leave to dry.
- The filters may also be washed in the dishwasher.
The aluminum panels may alter in color after several washes. This is not cause for customer
complaint nor replacement of panels.
Clean the fan and other surfaces of the cooker hood regularly using a cloth moistened with
denatured alcohol or non abrasive liquid detergent.
Keep motor and other parts free from water as this will cause damage to the appliance.
Cleaning your rangehood
PG 8
USE AND CARE
Disposal
By ensuring this product is disposed of correctly, you will help prevent
potential negative consequences for the environment and human
health, which could otherwise be caused by inappropriate waste
handling of this product.
The symbol on the product indicates that this product may not be
treated as household waste. Instead it shall be handed over to the
applicable collection point for the recycling of electrical and electronic
equipment.
Disposal must be carried out in accordance with local environmental
regulations for waste disposal.
For more detailed information about treatment, recovery and recycling
of this product, please contact your local city council oce.
Troubleshooting
Problem Possible reason Solution
Hood doesn’t work No electricity supply Check the plug is connected
Check that the main switch/
circuit breaker/safety switch is
turned on
Poor airflow Aluminum grease filters
clogged
Clean the filters and replace
when dry
Motor running but no airflow Butterfly valve jammed Contact service department
Motor turns o after a few
minutes
High temperature safety
device activated
The kitchen is not suciently
ventilated
The hood is installed near the
cooktop
The hood must be at least
600mm from the top of the
cooktop
Oil dripping onto stove Aluminum grease filter
saturated
Wash the aluminum grease
filters
Whirring sound Something in contact with fan
blade
Contact service agreement
PG 9
INSTALLATION
Assembly and electrical connections must be carried out by authorised personnel.
Electrical Connection
The Range Hood is fitted with a power cord and 3 pin plug. Install the Range Hood so that the
plug is easily accessible. Plug the 3- pin plug into a properly earthed, 10A general purpose power
outlet.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a
similarly qualified person in order to avoid a hazard.
The appliance has been manufactured as a class I, therefore earth cable is necessary.
The connection to the mains is carried out as follow:
IEC227 North America
L = Live Brown Black
N = Neutral Blue White
E = Earth Green/Yellow Green
NOTE:
When controlling the rangehood to switch on and o with an electric cooktop, the power point
may be controlled by an isolation switch in conjunction with the cooktop power.
In this case, the power point for the rangehood must still be accessible by the customer after
installation.
It is the installer’s responsibility to ensure and any relevant installation standards from the
Wiring Rules AS/NZS3000 are adhered to.
An omnipolar switch with a minimum aperture of 3mm between contacts, in line with the
electrical load and local standards, must be placed between the appliance and the network in
the case of direct connection to the electrical network.
PG 10
INSTALLATION
Instructions for Installation
Recommended Clearances
Rangehood
650-750
Cooking Surface
Install Range Hoods in accordance with the manufacturer’s
instructions. For optimum performance, we recommend that all
Range Hood clearances be a minimum of 650mm to a maximum
of 750mm between the top of the cooking surface to the
underside of the Range Hood. The distance may be reduced to
600mm to align with AS/NZS 5601.
WARNING: DO NOT penetrate any screws into the range hood
as this may result in electrical hazards.
WARNING: Failure to install the screws or fixing device in
accordance with these instructions may result in electrical
hazards.
If a connection flue composed of two parts is used, the upper part
must be placed outside the lower part.
Exhaust air must not be discharged into a flue which is used for
exhausting fumes from appliances burning gas or other fuels.
Installation must comply with any local regulations concerning the
discharge of exhaust air.
Before proceeding with the assembly, remove the anti-grease
filter so that the unit is easier to handle. Prepare the hole in the
ceiling or wall for the evacuation of the air.
Dimensions
520
Indice
Altri manuali Technika Cappa di ventilazione
