Techno
CNC Router Systems
In Business Since 1986
Inc.
HTT04810809
LC SERIES BASIC
SETUP INSTRUCTIONS
VI. TOUCHPAD INTERFACE SETTINGS
The following setup will require you to load an actual cutting tool
into the spindle and touch it to the touchpad. See Appendix A-Proper
Colleting Guidelines for instructions on how to load a tool properly.
The settings for the Touchpad need to be tested
and/or configured in the Techno CNC Interface
prior to using the machine.
STEP 1: From the main menu click Setup>
Advanced>Touchpad & Remote, click the
Button. The message “Pick up the
touchpad and touch it to the tip of the tool in
the spindle...” should then appear. Follow the
on screen prompts.
If the “test passed” screen appears, click “ok”,
the test has indicated that the Touchpad is
functioning properly. Exit the setup menu and
return to the main menu.
If the test failed (nothing happened), you need
to click where indicated “click here”. The “test
cancelled” screen should appear, click “ok.” Repeat
the touchpad test again. If it fails once more, turn
off power, check all connections and call Technical
Support for further assistance.
VII. E-STOP START/STOP BOX INTERFACE SETTINGS
The green button is the START button, hit this button to resume
the machine program after having hit the black PAUSE button.
The PAUSE button temporarily stops the machine. PUSH THE
EMERGENCY STOP (E-STOP) BUTTON WHENEVER YOU
NEED TO STOP THE MACHINE IMMEDIATELY. To reset the
Start/Stop Box E-stop, twist the E-Stop button clockwise. The
machine will not work if the E-Stop is still pushed in.
The settings for the E-Stop Start/Stop Box need
to be entered and/or configured in the Techno
CNC Interface prior to using the machine.
STEP 1: From the Main Menu, go to Setup>
Advanced>Touchpad & Remote. Click on the
Button. Follow the on screen
prompts.
SCREEN CAPTURE 5: Touchpad & Remote
PICTURE 7: Touchpad to Tip of Tool in Spindle
&
&
PICTURE 8: Mounted Start/Stop Box
&
