Technotherm KBS 6/25 Manuale utente

KBS 6/25

KBS 8/35

KBS 10/45

KBS 12/55

KBS 14/65

Assembly and Operating Instructions

Pew Heat Radiator KBS

Please read attentively and keep in a safe place! Subject to alterations!

Issue 07/16

Id_no. 911 360 541

2 Updated: June 16

Assembly Instruction for the KBS Pew Heat-Radiator

1. General information about our heaters

This heater can be used by children aged from 8 years and above and by physically, sensory or

mentally restricted persons if they are supervised or given instructions on safe use and

understand the hazards involved as it does not require any experience or knowledge.

This is not a toy for children to play with. Cleaning and user maintenance shall not be

carried out by children without supervision.

The use of heat radiators is to be given a particular duty of care by supervisors.

Children under the age of 3 are to be kept away unless they are continually supervised.

Children between the age of 3 and 8 are only allowed to switch the heater on or off if they are

supervised or given instructions on safe use and understand the hazards involved, provided that

it has been placed or installed in its intended normal operating position. Children between the

age of 3 and 8 shall not plug in, regulate and clean the heater or perform user maintenance.

Caution: Some parts of the product can become very hot and cause burns. Pay particular

attention when children and vulnerable people are present.

Type

Dimensions

W x L x H [mm]

Connected load

[W]

KBS 6/25

600 x 100 x 90

250

KBS 8/35

800 x 100 x 90

350

KBS 10/45

1000 x 100 x 90

450

KBS 12/55

1200 x 100 x 90

550

KBS 14/65

1400 x 100 x 90

650

3 Updated: June 16

Assembly Instruction for the KBS Pew Heat-Radiator

Technical data:

Nominal voltage: 230V

Protection class: I = protective earth terminal

Installation: stationary

Protective system: without special protection against water

Area of application: In churches, acc. to DIN 4701, max. room temperature is 15°C

Test mark:

Surface: powder-coated, similar to RAL 1090

Distances:

Minimum distance to combustible material

80 mm from the front grid

50 mm on the front side between two heaters and distance to back rest

50 mm between the front edge of the bench and the heater

50 mm between the rear edge of the bench and the heater

The safety distances must be kept!

4 Updated: June 16

Assembly Instruction for the KBS Pew Heat-Radiator

Warning!

•To avoid overheating of the device, do not cover it.

•Do not install the heater directly below a wall outlet.

•The bench heaters may only be taken into operation by authorised electricians.

Installation

The bench heater can be mounted directly onto wood in most cases. Mount the heater

in the middle of the bottom of the bench. Do NOT mount the heaters next to each other

(two heaters parallel to each other under one bench).

If there is a danger of damage on painted benches or crack formation in damp wood,

mount a non-flammable insulation board (UPK) between the heater and the bench. If

the bench measures less than 30 mm in thickness, an insulation board has to be

mounted in any case.

Do not mount amplifiers on the bottom of the bench to avoid heat

build-up. Do not mount the heater directly to the bottom of

the bench. Should there be amplifiers, mount the heater

with the mirror at the same height as the amplifiers. If needed, we will supply spacers.

Do not mount the heaters to benches with a closed back.

5 Updated: June 16

Assembly Instruction for the KBS Pew Heat-Radiator

Electrical installation

Only authorised electricians may install and mount the bench heaters.

1) Fastening / cover

2) Cable grommet

3) Clamp

4) Fastening

5) Steatite piece

6) Quartz heating element

7) Aluminium reflector/ mirror

Remove the cover grid and mount the heater under the sitting surface (in the middle of

the bench). Mount the supply line on the bottom of the bench and lead it in on the front

side of the heater. The heaters are wired-through at 1.5 mm.

Should several heaters be mounted on one bench, one heater can be plugged into the

one opposite and fed into the next one. Heaters up to a total load of 3000 Watts can be

connected in series. The TECHNOTHERM church bench heater boasts a chromium-

nickel steel heating element.

The advantage: non-brittle and non-corrosive! After the electrical instalment, remount

the cover grid from below with the lock washer and the screw. The heaters have to be

completely (all poles) disconnectable from the mains power supply by using switches,

contactors or automatic disconnecting devices at a minimum distance of 3 mm between

contacts. Make sure the phase load is even. Use an electronic thermostat with variable

continuous contact for controlling. Install a heating time limit (set to 6 h) and a timer to

automatically start the heater.

We will gladly provide circuit diagrams tailored for your project listing the electrical

controls used.

6 Updated: June 16

Assembly Instruction for the KBS Pew Heat-Radiator

Electrical installation: Wiring diagram

Heater installation may only be performed by an expert in accordance with the wiring

diagram Pay strict attention to the latest electrical safety standards and the local

electricity supply company's safety instructions!

7 Updated: June 16

Assembly Instruction for the KBS Pew Heat-Radiator

Insulation board mounting

The insulation board can be mounted directly onto wood in most cases (if load-bearing

surface). Mount the insulation board between the bottom of the sitting surface and the

heater. See diagram page 4! For good appearance, mount the printed side of the

insulated board facing the wood. You can mount the insulation board with nails or with

staples. For both ways of mounting make sure the nails or staples are long enough (at

least 20 mm). Do not drive the nails or staples through the wood to avoid creating holes.

If you use nails, make sure the nailhead is big enough (at least 4 mm). Do not use less

mounting points than indicated in the table. After mounting the insulated board, mount

the heater in the middle.

Type

Sizes [W x L x H]

Minimum number of

fastening points

Suitable devices

UPK 6/3

600 x 250 x 3

KBS 6/25

UPK 8/3

800 x 250 x 3

KBS 8/35

UPK 10/3

1000 x 250 x 3

KBS 10/45

UPK 12/3

1200 x 250 x 3

(two parts)

21 KBS 12/55

UPK 14/3

1400 x 250 x 3

(two parts)

24 KBS 14/65

Data:

Type: UPK 3

Installation: stationary

Area of application: in churches acc. to DIN 4701

Surface: Mineral fibre, similar to RAL 1013 pearl white

Classification temperature: 800°C

thermal conductance: 0.13 (W/mK) at 400°C

Breakdown voltage: 10 kV (average)

Thickness: 3 mm

6. After-sales service

Your electric heating device was carefully manufactured and checked repeatedly before

dispatch. If you should nevertheless encounter a problem or have questions concerning

handling, feel free to contact us.

Lucht LHZ Elektroheizung GmbH & Co. KG

Obere Hauptstr. 61

09232 Hartmannsdorf, Germany

Ph. ++49 3722 63370

Fax: ++49 3722 633720

E-mail: inf[email protected]

web: www.technotherm.de

TECHNOTHERM After-sales service:

Ph. ++49 911 93 78 32 10

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Technotherm Stufa

Technotherm

Technotherm Frost Guard FW 501 Manuale utente

Technotherm

Technotherm TT-KS S Manuale utente

Technotherm

Technotherm VPS 1000 Manuale utente

Technotherm

Technotherm VPS series Manuale utente

Technotherm

Technotherm VPS Design 1500 RF Manuale utente

Technotherm

Technotherm PH SlimLine Manuale utente

Technotherm

Technotherm KS DSM Manuale d'uso e manutenzione

Technotherm

Technotherm ISP Design S 350 Manuale utente

Technotherm

Technotherm ISP-W 350 Manuale utente

Technotherm

Technotherm VPS-Design B 1000 Manuale utente

Technotherm

Technotherm TT-KS 500 S X4 Manuale utente

Technotherm

Technotherm TT-KS LT Manuale utente

Technotherm

Technotherm PH Ultraslim Manuale utente

Technotherm

Technotherm SM 2004 Manuale utente

Technotherm

Technotherm CHM 500 E Manuale utente

Technotherm

Technotherm ISP-W 450 Manuale utente

Technotherm

Technotherm ISP 350 Manuale utente

Technotherm

Technotherm Q 1201 Manuale utente

Technotherm

Technotherm CPH 1000 E Manuale utente

Technotherm

Technotherm TT-KS 1500 S X4 Manuale utente

Technotherm

Technotherm CPH 1000 Manuale utente

Technotherm

Technotherm TTS 200 Manuale utente

Manuali Stufa popolari di altre marche

oventrop

oventrop Regucor Series Manuale utente

Blaze King

Blaze King CLARITY CL2118.IPI.1 Manuale utente

ELMEKO

ELMEKO ML 150 Manuale utente

BN Thermic

BN Thermic 830T Manuale utente

KING

KING K Series Guida

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Guida rapida

Well Straler

Well Straler RC-16B Manuale utente

EUROM

EUROM 333299 Manuale utente

Heylo

Heylo K 170 Manuale utente

Eterna

Eterna TR70W Manuale utente

Clarke

Clarke GRH15 Manuale di istruzioni

IRSAP

IRSAP The Radiator Company Ovali Manuale utente

Empire Heating Systems

Empire Heating Systems WCC65 Manuale utente

Wetekom

Wetekom 92 86 43 Manuale utente

Desa

Desa SPC170-F Manuale utente

Watlow

Watlow Watrod Electric Tubular Heaters Manuale utente

Haverland

Haverland ECO-DRY GPS Series Manuale elenco delle parti

Stelpro

Stelpro ASILVC2060 Series Manuale utente