3. Setting Up
*To set up AL-100 for IIC-460 application, please refer to the IIC-460 instruction.
*To set up AL-100 for MDM-100Z FD3S), please refer to the instruction for MDM-100Z.
AL-100’s warning LED and b zzer will work at preset val e on one of the following items.
٨
Speed
٨
Engine RPM
٨
Water Temp.
٨
Air Flow Meter (Air Flow Meter is not available on MDM-100 for Toyota)
ALARM ENABLE SET
O F F
ALARM ENABLE SET
O N
Activate Alarm f ncti on
3. After entering 10th n mber, press and hold SELECT
b tton ntil Alarm settin g screen comes p.
4. By si n g UP or DOWN b tt on to enable alarm f nction
ON.
5. Press and hold SELECT b tton ntil alarm ite m selection
screen comes p.
A L A R M S E T U P
SPD Km/h
E N T E R C O D E
CODE= OOOOOOOOOOO
E N T E R C O D E
CODE= 0 0 3 4 8 9 9 4 9 6
Inp t Co de
1. Press and hol d SELECT b tt on then t rn the ign i tio n ON.
2. Release the b tto n when co de inp t screen com es p.
Enter the code by sing UP and Down b tton to set the
n mber, press SELECT to move to next n mber.
[CODE=0034899496]
A L A R M S E T U P
SPD Km/h
Alarm Set p
6. Choose the item yo want to enable alarm f nction.
7. Af ter selec tin g the item , press and hol d SELECT b tton
then c rrent setting val e for warning comes p in front
of the nit.
8. Use UP and DOWN b tt o n t o c han ge the val e to where
yo wa nt to alarm to be activate d.
9. Press and hol d SELECT b tton ntil MDM goes back to
normal operati n g mode.
A L A R M S E T U P
SPD>= 2 Km/h
A L A R M S E T U P
SPD>= 100 Km/h
Disable Alarm F ncti on
When yo need to disable alarm f nction, disable the
f nction by select in g OFF at alarm e na ble set screen.
Then yo may disconnect AL-100 if yo need to.
(Disconnecting Al-100 witho t disabling alarm f nction
may ca se da mage to M DM )
ALARM ENABLE SET
O N
ALARM ENABLE SET
O F F
4. Trouble S ooting
If AL-100 is not functioning properly, shut power off immediately and check the
connection of connectors and cable. If cause of problem is unknown, please contact
the dealer for technical support.
