techtron Lite 2000 Manuale utente
Lite 2000
Instruction Manual
2
Ethos
Welcome to techtron® by combining passion, drive and
intellect with market leading research and cutting-edge
technology, we innovate and deliver premium quality
products that excite, inspire and challenge the sector.
Striving for perfection, embracing new ideas and
investing in the future is our ethos.
Future Tech. Today
3
Contents
Product and Accessories 4
Assembly 6
Charging 8
Functions 10
Smart App 12
Maintenance and Warranty 14
Rider Guidance, Safety and Specications 15
4
Product and Accessories
ABrake lever
BAccelerator
CFolding hook
DCollar clamp
EFolding pedal
FAtmosphere lights
GKickstand
H Power button
I Charge port
JMotor wheel
K Rear brake
L Reector
G
B
C
I
K
L
A
D
F
J
H
E
5
Product and Accessories
Charging adaptor x1M6 hex key x1
6
Assembly
3
Park with the
kickstand. Step on
the footboard, hold
the handlebar and
push forward to
unfold the scooter.
Insert the
standpipe into
the collar clamp.
2
Slightly loosen
the hex bolts
on the collar
clamp with the
M6 hex key
1
7
Assembly
Tighten the bolts on
the collar clamp with
the M6 hex key.
4
5
If the brake is too tight or loose,
you can thread in/out the brake
cable adjuster.
8
Charging
To charge the techtron® eScooter, simply open the rubber stopper on the side of the
footboard and connect the power supply. Then plug in the power supply and switch
on the power. Please allow three hours for the eScooter’s battery to fully charge.
When the eScooter’s battery is fully charged, the charge indicator on the plug will
change from red to green. After charging, please ensure you replace the stopper
to prevent water damage.
Children should be supervised at all times and should not touch the device
whilst charging.
9
Charging
10
Functions
Factory default settings
Riding mode Maximum speed Power light
Turbo 14km/h Fast blinking
Cruise 7km/h Slow blinking
Accelerating and decelerating
Action Cruise mode Turbo mode
Accelerate Kick o to go, then press the accelerator
Decelerate Use front/rear brakes Release accelerator or use front/rear brake
Power button
To power the eScooter ON/OFF, press and hold the main power button located
on the side of the footboard for two seconds.
The atmosphere lights along the side of the scooter can also be controlled with
a single press of the power button.
Riding modes
The techtron® Lite 2000 comes with two factory default riding modes: Turbo and
Cruise. These can be determined by the power light status, detailed in the table
below. In Cruise mode the scooter will hold it’s speed without the need for the
accelerator to be pressed. With Turbo mode activated the scooter will gradually
slow and stop if the accelerator is released.
For added safety, the techtron® smart app can be used to limit each speed mode,
in order to best suit your child’s age or ability. As they further advance their riding
skills the scooter’s speed can then be increased to the Lite 2000 model’s actual
maximum: 18km/h.
Indice
Altri manuali techtron Scooter
