4
1.1 Attention, please read this
This user manual contains important information regarding installation of the Telic Camera module in an STD35.
Read it carefully before attempting to start working with the STD35 if the Camera module will be used.
The warranty will be null and void should damage occur due to non-compliance with these instructions for use.
We cannot accept any responsibility for consequential loss.
We cannot be held responsible for material loss or personal injury that is due to incompetent use or non-
compliance with the safety instructions. The warranty will be null and void in such circumstances.
The STD35 and optional camera contain highly integrated components which can be damaged by electrostatic
discharge.
•All wiring work has to be done in a voltage free state only
•All cables and wires which are energized and connected to the device the module or components have to be
checked regularly for any damage to the isolation shielding or fractures in the cables. If the supply cables are
visibly damaged the device has to be taken out of operation immediately until the faulty cable has been
exchanged
•Before putting a device into operation it has to be clarified whether this device or module is appropriate for
the field of application. In case of doubt ask a specialists or the manufacturer of the device.
•Please note that we are not responsible for any errors in usage or connection. Therefore we cannot accept
any responsibility for consequential loss.
•Before opening the device always disconnect the mains adapter or make sure that the device is disconnected
from the power supply.
•Components modules or devices have to be built into a housing before they are put into operation. During
installation they should not be connected to any power supply.
•You should only use tools on components modules or devices if they are disconnected from the power
supply and residual electric charge (which may still be stored in some components inside the device) has
been discharged.
•When using components or modules it is necessary to strictly observe the specification given in the
corresponding description of these components.
•If a description for a private end-customer does not clearly state which electric data is valid for a component or
a module how to wire the device which external components or additional devices can be connected or
which parameters these components are allowed to have a specialist must be contacted.
•Devices which operate with greater than 35 Volts have to be connected by a specialist.
•Before putting the device into operation it should be checked that there is no current leakage on the housing.
•In case measurements with the opened housing are necessary an isolating-transformer has to be used for
safety reasons. Alternatively the voltage can be supplied by an appropriate power supply which complies with
the safety regulations. All wiring work has to be done in a voltage free state only.
