Teltonika FM3620 Manuale utente
3G Tracking Device Installation Manual
1
2
3
4
5
6
Color
Red
Yellow
Yellow
Black
Purple
Purple
Pin
1
2
3
4
6
5
Pin Name
10-30V DC (+)
Ignition
1-Wire Data
Ground (-)
1-Wire Power
Digital Output 1
Description
Power supply for module.
Digital input 1
Data channel for Dallas devices
Ground pin
+ 3,8 V output for 1-Wire®
Digital output. Open collector
output. Max. 150mA.
Most installations require only the first 3 wires. Red, Black and Yellow
(Power, Ground and ignition). Other wires are typically used for additional
monitoring
requirements, such as temperature monitoring or Driver ID.
Any un-used wires should ideally be coiled up and kept for potential future
use, but can be cut if necessary (if cutting, it is our recommendation that at
least a 3 – 6cm lead be left so as to supply a fly lead for future connection
of additional monitoring devices).
Installation best practices
• Wires should be connected while GPS device is not plugged in.
• Wires should be fastened to the other wires (excluding air bag wires)
or non-moving parts. Avoid heat emitting and moving objects near the
wires, modules or antennas.
• Wires should not impede, interfere, or interface with any components of
the vehicles air bag systems, nor cause any hardware or wires to come in
contact with or run directly in front of any air bag equipment or deploy-
ment pathways.
• If the wires are placed in the exterior or in places where they can be
damaged or exposed to heat, humidity, dirt, etc., additional isolation
should be applied.
• Wires must not be connected to on-board computers or control units.
Connecting ignition wire
Connection to the ignition wire is necessary in order to capture when trips
start and finish.
• Confirm the ignition wire – power does not disappear while starting the
engine.
• Confirm the wire is not an ACC wire (when key is in the first position,
most electronics of the vehicle are available).
• Confirm power is still available after turning oany of vehicles devices
(e.g. radio).
Connecting the power source
Check if the power is still available on the vehicle’s power wire, even after
the car computer falls asleep (which might take up to 30 minutes). When
the module is connected, check the voltage again. If it did not decrease it
is recommended to connect to the main power cable in the fuse box.
Placing antennas
• Avoid placing antennas under metal surfaces.
• Avoid easily reachable places.
• Antennas should be placed as horizontal as possible (GPS antennas in-
stalled on an angle greater than 30 degrees are considered incorrectly
mounted and may cause faulty signal reading).
• Ensure the GPS antenna is be placed with the sticker facing down.
• It is recommended to place the GPS antenna beneath the dashboard as
close to the window as possible. A good example of the GPS antenna
placement area is displayed in a picture below (area colored green).
Customer Responsibilities
1. The Customer/Installer shall review all supplied hardware product to
ensure all components have been shipped prior to commencing installa-
tion.
2. The Customer/Installer shall review all installation procedures prior to
commencing the installation. Should the Customer/Installer not under-
stand any aspect of the installation procedures, it is the recommenda-
tion of Fleetlog that the Customer engage one of Fleetlog’s Installation
Partners, or a qualified Auto Electrician to perform the installation.
3. The Customer accepts all responsibility for the installation of the hard-
ware product, and acknowledges that any damage to the hardware
product that should occur during the installation process is not covered
under the Lifetime Warranty.
If you have any questions, call us on 1300 798 826
or email support@fleetlog.com.au.
Altri manuali per FM3620
1
Altri manuali Teltonika GPS
Teltonika
Teltonika TFT100 Guida all'installazione
Teltonika
Teltonika TAT100 Manuale utente
Teltonika
Teltonika FMB930 Manuale utente
Teltonika
Teltonika FMM80A Guida all'installazione
Teltonika
Teltonika MH2000 Manuale
Teltonika
Teltonika FMB900 Manuale utente
Teltonika
Teltonika FMB1YX Manuale utente
Teltonika
Teltonika FM1000 ST Manuale utente
Teltonika
Teltonika FMC920 Guida all'installazione
Teltonika
Teltonika FMC125 Manuale utente
Teltonika
Teltonika GH5200 Manuale utente
Teltonika
Teltonika FMB110 Guida all'installazione
Teltonika
Teltonika FMB125 Manuale utente
Teltonika
Teltonika FMB003 Guida all'installazione
Teltonika
Teltonika FMP100 Guida all'installazione
Teltonika
Teltonika TAT240 Manuale utente
Teltonika
Teltonika GH120 Series Manuale di istruzioni
Teltonika
Teltonika FMC800 Guida all'installazione
Teltonika
Teltonika FMB920 Manuale utente
Teltonika
Teltonika FMC920 Manuale utente
