Premier Elite Com300 &Com2400 Installation Manual
8INS175-5
Programming the Com300 and Com2400
To program the Com300 or Com2400, proceed as follows:
1. Enter into the Engineers Menu .
2. Select the Program Digi menu and press .
•Select the required ARC set , or
•Select the Protocol i.e. Fast format, Contact ID, SMS Messaging
•Enter the Primary Number for the ARC or 1st Mobile phone number
•Enter the Secondary Number for the ARC or 2nd Mobile phone number
SMS Text Messages will always be sent to both numbers
•Enter the Account Number (NOT required for SMS)
•Enter the number of Dialing Attempts(minimum=1)
•For Fast format select the Reporting channels
•For Fast format select the Restoring channels
•For Fast format select the Open/Close channels
•For all other formats select the Areas that will report events
•For all other formats select the types of events that will be Reported
•Select any Config. Options that may apply
3. To exit from the Program Digi menu press .
4. Select the Digi Options menu and press .
•Select Digi is Enabled
•Select any other options that may be applicable i.e. If more than one set of ARC
information is being used i.e. ARC1 for Fast Format to Alarm Receiving Centre and
ARC2 for SMS Messaging to Mobile phones, Dial ALL Numbers should be
selected
5. To exit from the Digi Options menu press .
When using SMS text messaging, up to 16 characters of text can be
programmed as a site identifier if required. To do this, enter the Global
options menu then select System Text then program the
Printer Header with the required text.
