Thecus N4800 Manuale utente
V1.2
Mar 09, 2015
N4800/W4000
MB & DRAM assemble steps
4304001111 背板螺絲 For BTN Board M3*4mm
Round Head,Ni Coating
Remove top cover 3 screws (RED )
Remove Li Battery slot panel screw(BLUE) (optional)
Remove 4 back panel screws
Remove 2 MB screws
4304001111 背板螺絲 For BTN Board M3*4mm
Round Head,Ni Coating
Remove FAN Cable (RED)
Remove SATA DOM/SSD/HDD cable (BLUE)
Remove 4Pin Power Cable (if) (Yellow)
1. Remove SATA &
SATA power cable from MB.
2. Slide MB out and replace
DRAM module
* If install single DRAM
module, it is must install
at upper DIMM slot.
SATA1
SATA2
SATA3
SATA4
SA
TA
1
After the MB is slid out, DRAM will be displayed.
Please note that DRAM is installed in the upper slot.
If replacing DRAM is needed, please spread out the DRAM lock latches.
So the DRAM will pops up.
Remove the original DRAM.
And then insert the new DRAM into the connection at an angle 45
degrees.
Press down on the DRAM so that it is secured with both memory lock
latches.
Additional check point 1
FPC
微動開關
CABLE
電池
CABLE
Additional check point 2
Altri manuali per N4800
2
Questo manuale è adatto per i seguenti modelli
1
Altri manuali Thecus Magazzinaggio
Thecus
Thecus N3200PRO Manuale utente
Thecus
Thecus N3200 Manuale utente
Thecus
Thecus N8900 series Manuale utente
Thecus
Thecus N8800 Manuale utente
Thecus
Thecus N4100 Manuale utente
Thecus
Thecus N7700PRO Manuale utente
Thecus
Thecus N7700 Manuale utente
Thecus
Thecus N5200 Manuale utente
Thecus
Thecus N7710 series Manuale utente
Thecus
Thecus N2310 series Manuale utente
