Thermoplan BLACK&WHITE 3 FOX2 Manuale utente

REV-0 6.1

CTM / CBTM SECTION 6

Technical Manual

DISPLAY MESSAGES

FOX2

REV-0 6.2

1 X

2 X

3 X

4 X

5 X

6 X

7 X

8 X

9 X

10 X

11 X

012345678910 012345678910

012345678910

Page

REVISION

Page

REVISION

Page

REVISION

SECTION 6

Technical Manual

X Changes in content, corrections S New paging

Overview modication

Modication journal

Revision: Date: Modications Initials:

0 2010-01-20 First edition, new document SO

Document: Display messages

REV-0 6.3

SECTION 6

Technical Manual

Index

User messages Index 6.4

Picture messages 6.5 - 6.7

Text messages 6.8. - 6.11

REV-0 6.4

SECTION 6

Technical Manual

INDEX

Picture messages

Cold start rinse

Drawer missing

Empty grounds drawer

Fill hopper

Milk empty

f. Command desk open

Automatic cleaning interrupted

Standby mode

Product out

Text messages

j. Ready

Please wait while heating up

Fill hopper M1 / Fill hopper M2

Bean hopper missing or command unit up

Please clean unit

Please rinse unit

Please add milk

Powder error

Cleaning break, Inert tablet

Cleaning key missing, Please insert

Cleaning, Press cleaning key

Voltage high 109%

Voltage low 91%

For the following text messages the picture „Product out!“ appears on the touchscreen. Enter code „111111“ to see the message.

Flow error

Change water lter

Piston error

NTC

aa.

Service required

ab.

Drain tub

ac.

Overtime error

The following messages can appear during the daily operation.

User messages

If the machine had to be shut down, wait for 10 seconds before restarting.

REV-0 6.5

SECTION 6

Technical Manual

User messages

Picture messages Solution

a. After a longer downtime of the ma-

chine you have to rinse the machine

before operating.

b. Controll drawer and insert it correctly.

Control the entry „Drawer available“

in the service menu „system test“.

c. Push outlet up to remove the grounds

drawer. Empty it and put it back after-

wards. To reset the counter auto-

matically, wait for 5 seconds before

reinserting.

REV-0 6.6

SECTION 6

Technical Manual

User messages

Picture messages Solution

d. Open the cover of the hopper and rell

it with fresh coffee beans.

e. Open refrigerator and rell milk con-

tainer with milk.

f. Pull down the command desk and

close it.

REV-0 6.7

SECTION 6

Technical Manual

User messages

Picture messages Solution

g. Empty the milk container, reinsert it

put the suction tube back inside.

h. After the cleaning the machine enters

the standby mode.

Press continue to go back to the

product screen.

i. A serious error occured. Contact the

service technician.

REV-0 6.8

SECTION 6

Technical Manual

User messages

Text message Reason / solution

j. Ready • Coffee machine is ready

k. Please wait

while heating up

• Coffee boiler has not reached set temperature

– Allow machine to heat about four minutes.

• High limit switches have tripped

– Reset the high limit switches by rmly pushing them in. You must hear a click.

• Bad heating element

– Check boiler heating

• Change hydraulic module

l. Fill hopper M1

(left)

Fill hopper M2

(right)

• Bean hopper out of beans or hopper gate closed

– Behälter füllen oder verriegeln

• Bean hopper or grinder outlet is obstructed

– Remove bean hopper and clear obstruction

• Defective 24V piston motor

• Defective grinder motor or capacitor

• Toothed belt or pulley is loose

– check

• Change mechanic module

m. Bean hopper missing

or command unit up

• Bean hopper or command unit not correctly mounted

– Lift command unit up and check the lever of the bean hopper

– Close command unit (snaps in audibly)

• Defective solenoid switch of command unit or bean hopper

– Check solenoid switches

n. Please

clean unit

• No cleaning was performed since 24 hours

– Perform daily cleaning

REV-0 6.9

SECTION 6

Technical Manual

User messages

Text message Reason / solution

o. Please

rinse unit

• Cold start rinse has to be performed to ensure that the system is lled

with water

– Press rinse key

• Flowmeter not working correctly

– Check owmeter

• Change hydraulic module

p. Rell milk • Milk container is almost empty, dispensing of products still possible

– Rell milk container with milk

q. Powder Error • Too much coffee is ground, exceeding the ll capacity in brew chamber

– Check the powder quantity and adjust the grinder ner

• Defective 24V piston motor

• Drive screw or brew chamber contaminated

• Change mechanic module

r. Cleaning break

insert tablet

• Cleaning was interrupted (power outage during cleaning)

– Start daily cleaning again

s. Cleaning key missing

Please insert

• Cleaning key is not correctly mounted

– Insert cleaning key and turn it 90° clockwise

• Defective solenoid switch of cleaning key

t. Cleaning

Press cleaning key

• Cleaning has to be started again

u. RF temp

too low

• Info message, refrigerator temp is lower than 4 °C

– if on short notice, only as info

– if permanent, check refrigerator for freezing

– Check the refrigerators temperature sensor

REV-0 6.10

SECTION 6

Technical Manual

Text message Reason / solution

v. RF temp

too high

• Info message, refrigerator temp is higher than 4 °C

– if on short notice, only as info / check if refrigerator door is closed

– if permanent, check refrigerator for function (place hand on left inner side)

– Check the refrigerators temperature sensor

w. Flow error • Flow meter impeller is not rotating

– Obstruction inside ow meter or water path

• Flow meter sensor does not read magnetic contacts on impeller

– Pins on electrical plug are not connected or corroded

• No water pressure on machine

– Check water pressure

• Change hydraulic module

x. Change lter • Water lter is saturated.

Dispensing of products still possible.

– Change water lter

– Reset counter

y. Piston Error • Obsturcted 24V piston motor

– Check brew chamber and shaft for contamination or obstruction

• 24V piston motor has no impulse

• 24V piston motor has no 24VDC

• Change mechanical module

z. NTC Coffeeboiler

open

• CPU does not read NTC probe signal

– Check for defective wiring on hydraulic module NTC probe

Note: „NTC Coffeeboiler Open” message automatically appears on the display

when the machine is on and the hydraulic module is removed.

• Change hydraulic module

aa. PM required • Machine has reached a preprogrammed number of brew cycles

– Perform preventative maintenance as required

– Reset counter

User messages

Altri manuali Thermoplan Macchina per il caffè

Thermoplan

Thermoplan Black & White BW3-CTMC Manuale utente

Thermoplan

Thermoplan Black&White3 123.929 CTM Manuale utente

Thermoplan

Thermoplan BLACK&WHITE ONE BWone-CTM Manuale di installazione

Thermoplan

Thermoplan TIGER Manuale del proprietario

Thermoplan

Thermoplan Black&White3 CT Manuale di servizio

Thermoplan

Thermoplan BW4c-CTM Manuale utente

Thermoplan

Thermoplan AGUILA AG220 Manuale utente

Thermoplan

Thermoplan AGUILA AG220 Manuale utente

Thermoplan

Thermoplan AGUILA AG220 Manuale utente

Thermoplan

Thermoplan Aguila AG440 Manuale utente

Thermoplan

Thermoplan TIGER Manuale utente

Thermoplan

Thermoplan Black&White 3 CTMC Manuale utente

Thermoplan

Thermoplan BLACK&WHITE ONE BWone-CTM-RF Manuale utente

Thermoplan

Thermoplan BLACK&WHITE 3 Series Manuale utente

Thermoplan

Thermoplan Black&White 3 CTM-RF Manuale utente

Thermoplan

Thermoplan Black&White 3 CTS Manuale utente

Thermoplan

Thermoplan BLACK&WHITE3 FOX1 Manuale utente

Thermoplan

Thermoplan Black&White3 CT Manuale utente

Thermoplan

Thermoplan Black&Whute3 CT Istruzioni operative

Thermoplan

Thermoplan Black&White 3 CBT Manuale utente

Thermoplan

Thermoplan Black&White 3 CTS Manuale utente

Thermoplan

Thermoplan NESPRESSO AGUILA 440 Manuale utente

Manuali Macchina per il caffè popolari di altre marche

Taurus

Taurus Livorno 6 Manuale utente

Delta-q

Delta-q QUICK Manuale utente

Bunn

Bunn LCA-1 Guida alla risoluzione dei problemi

Black & Decker

Black & Decker BLACK DECKER HOME DE790 Istruzioni per l'installazione

Saeco

Saeco Vienna Plus Sup 018M Manuale utente

DeLonghi

DeLonghi DC300 Manuale utente

INCAPTO

INCAPTO BXCO1470E Manuale utente

Bosch

Bosch TASSIMO finesse TAS16B Series Manuale utente

Exido

Exido 245-072 Manuale utente

Animo

Animo OptiVend Choco Manuale utente

Siemens

Siemens TQ505DF Series Manuale utente

DeLonghi

DeLonghi ECI341 Manuale utente

Krups

Krups KT406511 Manuale utente

Cimbali

Cimbali M32 Classic Manuale utente

Philips

Philips HL3844N Manuale utente

Bosch

Bosch TES 515 SERIES Manuale utente

Tekmatix

Tekmatix TMFM - 65 Manuale utente

Scarlett

Scarlett SC-CM33005 Manuale utente