3
1. Introduction
We are grateful for your decision to buy our Air Cooler FC-500.
It is fabricated by us especially for You in accordance with the
highest quality standards and tested by our experts on
compliance with EU directives presented in the Section
"Documents taken into account in production and
documentation" before shipping the equipment to you.
Despite the fact that the equipment is simple enough to use, we
strongly recommend that you read the instructions before
starting work, paying close attention to the Safety Instructions.
Air Cooler FC-500 was developed to secure PCB cooling speed
and can work as a separate aggregate. At the same time Air
Cooler FC-500 can be easily integrated into an Reworking
Soldering Center IR-650 Pro. To do this, simply connect the
device to the USB port of the computer and the "TERMOPRO -
Center" Program will automatically recognize it and will adjust a
desired rate of cooling in accordance with a predetermined
thermal profile. Cooler FC-500 is recommended to complete a
soldering set based on Pre-heating systems of NP Series, but
Cooler FC-500 is also often used for cooling circuit boards with
any other Pre-heaters.
1.1 Documents, taken into account in a process of
production and manual for use set up.
For EU Countries only:
OOO NTF “Techno Alliance Electronics” being the responsible
Manufacturer declares that Digital Bottom Pre-Heating and
Soldering System of NP Series with Characteristics presented in
Section 3.1 is a serial product and meets following EU Directives:
-Directive 2006/95/ECs relating to electrical equipment
designed for use within certain voltage limits.
