1-5
1. Introduction
2.
Safety Precautions
ES/EC
2-3 Safety precautions
While the actuator is operating or
operable, do not enter the working
area of any moving part including
the load.
Doing so may cause you to touch the
moving part and get injured.
If the product fails or any abnor-
mality is observed, shut down the
power of the driver controllers TSC
and TLC.
Such abnormality may cause a mal-
function of actuator, resulting in dam-
age or injury.
Do not touch the internal part of
driver controllers TSC and TLC.
Doing so may cause electric shocks.
Do not damage, tuck, or apply ex-
cessive stresses on the cable.
Doing so may cause electric shocks.
Do not modify, disassemble, or al-
ter the product.
Doing so may cause injury or fault.
Prohibited
Obligatory
Caution -
Electrical shock
Do not
disassemble
During the operation, or for a while
after turning the power off, do not
touch the driver controller TSC,
TLC, or motor cover because they
should be hot.
Doing so may cause burns.
Do not impact the product and
do avoid rough handling such as
throwing it.
Doing so may cause the fault or dam-
age that leads to injury.
Do not grasp the strip seal of this
product.
It may injure you.
Some parts of the strip seal may be
sharp. Take care not to cut your hands
or fingers.
Also, the strip seal must be replaced
when it is scratched, pitted or dented.
Use of the strip seal in this state may
cause early breakage or other damages.
Do not frequently switch the power
between on and off.
Doing so may generate heat from the
internal part of driver controller TSC or
TLC, which results in fault or burns.
Do not set the speed or accelera-
tion setting or place the load on
the table that exceed the actuator
specification.
Doing so may cause motor failure,
which leads to unexpected accidents
or damages.
If an alarm is generated, remove
the cause, check the safety, de-
activate the alarm, and restart the
operation.
Failure to do so may result in failure,
which leads to injury.
Caution –
High temperature
Prohibited
Obligatory
Caution
