Thule 9027 Manuale utente
QUICK START GUIDE for: APEX SWING AWAY 9027
DO
DO NOT
• Attach swing arm and upright
assembly as shown (STEP 1).
• Pull back on Auto Pin to engage in
receiver hole. Use knob to tighten.
Lock (STEP 3).
• Load heaviest bike first - front to
the right (STEP 7).
• Alternate bike direction.
• Secure bicycle to rack with rubber
straps and black safety strap
through the frames and around
the mast of the rack (STEP 9).
• Check tightness of all bolts
and knobs periodically
(every 6 months).
• Check rubber straps for wear
and replace if worn.
• Install on a trailer or other towed
vehicle.
• Put more than 2 bikes on a class
1 hitch.
• Do not “overstretch” the straps.
• Use the rack while traveling on dirt
roads.
• Use the rack to carry tandems or
recumbents.
• Put more than the intended number
of bikes on the rack.
APEX SWING AWAY 9027
part
description
part number
qty.
AApex Swing Bike Carrier / — 1
Bcradle overmold / 8523503001 8
Cswing arm assembly / — 1
DM8 lock knob / 753190902 1
EApex 2” hitch adaptor / 8523134001 1
F1/2" lock nut / 853558402 2
Gwasher 12mm / 951122454 4
H1/2 - 13 bolt x 5.5"/ 8535583 2
Ihitch tool / 8535524 1
Jripple strap / 8523006001 12
Kanti-sway with overmold / 8523037001 4
Lanti-sway angled extension / 8523108001 2
Mbuckle strap / 753203017 1
N.75 open end wrench / 8523138001 1
Olock, 2 cylinders, 2 keys per each part / — —
Plock cylinder change key / 8531251 1
QM8 X 30 flat head screw / 8523136001 2
A
LQ N O P
M
ED
B
F G H I J K
C
PARTS INCLUDED
1CARRIER ASSEMBLY /
• Position stinger assembly in bracket of swing arm assembly as illustrated.
• Install 1/2 – 13 x 5.5" bolt, flat washer and lock nut as illustrated.
• Tighten firmly using Thule tools provided.
• Position upright assembly in swing arm assembly bracket as illustrated.
• Engage lock-up pin and loosely thread lower locking handle.
• Install 1/2 – 13 x 5.5" bolt, flat washer and lock nut as illustrated.
• Tighten firmly using Thule tools provided.
2TRANSPORTING CARRIER /
• Carrier can be easily handled / carried using handhold at the back of the carrier.
A
B
WARNINGS / LIMITATIONS •
• Number of bicycles should not exceed designated
carrying capacity for your specific Apex Swing Away.
• 9027 (4 bike) max carrying capacity = 140 lbs.
• Check tightness of all bolts and knobs periodically.
• Check straps for wear and replace if worn.
• Not intended for off-road use.
• Not intended for tandems or recumbents.
• Failure to use strap may result in loss of bicycles.
• Your vehicle must be equipped with a 2" receiver.
4BICYCLE TRANSPORTATION /
• Lift Hitch Switch
Lever as illustrated.
• With the other hand lift bike arm
assembly upward until the Hitch
Switch “clicks” into position.
•
Reverse operation to store or when
traveling with no bike attached.
AB
3STINGER INSTALLATION /
FOR 2" RECEIVERS ATTACH 2" ADAPTER
• Attach carrier to receiver by pulling back
gently on Auto Pin while sliding stinger
into receiver.
• Using hex key attach adapter sleeve to
stinger with two M8 x 30 flat head screws.
• Once Auto Pin clears receiver lip, release
Auto Pin so that it rests against receiver.
• Push carrier in until Auto Pin engages
with the receiver hole as illustrated.
• Install lock cylinder into lock knob on
stinger assembly with Change Key.
NOTE: Knob will not tighten fully
without lock cylinder inserted.
• Firmly tighten locking knob to secure
carrier in receiver.
A
C
E
B
D
F
7
• Load heaviest bike first onto the inner most cradles - handle bars facing passenger side of vehicle.
• Fasten cradle straps.
• Use Thule Frame Adaptor (#982XT, sold separately) for bikes without traditional top tubes.
A B
5
• Attach cradle straps to cradles and anti-sway cages.
6
• Attach anti-sway angled extension to underside of cradles 1 and 4 as illustrated.
A B C
1
24
3
8ATTACHING HOLD FAST ANTI-SWAY CAGES
• To attach anti-sway cage, hold horizontal with smooth edge facing down and slide C-slot opening onto Anti-Sway Extension / Cradle. Swing down to vertical position.
Place smooth curved surface against bicycle and attach strap as shown.
• Mount bikes in alternate directions.
A B
9
• Secure bikes to mast of carrier with black strap.
10 REAR COMPARTMENT ACCESS /
• Loosen lower locking
handle completely
and pull pin to open
carrier.
• While pushing bottom half of bike
arm assembly open, rotate upright
assembly as illustrated. In full open
position lock-up pin will engage
bracket.
A B
lock-up pin
broche de verrouillage
pasador de cierre
lower locking handle
poignée de
verrouillage inférieure
asa inferior de cierre
11 OPENING CARRIER /
• Insert hold-open pin into locking position when fully open to prevent carrier from swinging closed.
hold-open pin
AB
12 CLOSING CARRIER /
• Pull Lock-up pin to release upper arm assemby and
rotate bike arms to stop position.
• Close carrier. Lock-up pin will click into
closed position.
• Tighten lower locking handle firmly.
WARNING: Before operating
your vehicle, tighten
locking handle firmly.
AB
lower locking handle
lock-up pin
13 SECURITY
INSTALLING END CAP LOCK CORE
• Install lock cylinder into locking end cap with
Change Key.
USING LOCKING CABLE /
• Lock bikes to carrier with cable lock.
A
A
B
B
Indice
Altri manuali Thule Accessori per biciclette
Thule
Thule Pack ’n Pedal 100061 Manuale utente
Thule
Thule 9003 RACEWAY Manuale utente
Thule
Thule 12080111 Manuale utente
Thule
Thule Pack 'n Pedal Manuale utente
Thule
Thule Yepp Nexxt Mini 12080101 Manuale utente
Thule
Thule 976 Manuale utente
Thule
Thule Sprint 569 Manuale utente
Thule
Thule Sidearm 594XT Manuale utente
Thule
Thule RideAlong Lite 100109 Manuale utente
Thule
Thule Yepp Mini Manuale utente
Thule
Thule coaster xt Manuale utente
Thule
Thule YEPP RACK Manuale utente
Thule
Thule Pack ’n Pedal Tour Rack 100016 Manuale utente
Thule
Thule RideAlong 100106 Manuale utente
Thule
Thule HangOn 974 Manuale utente
Thule
Thule Yepp Nexxt Maxi Manuale utente
Thule
Thule Small Adventure Pack n Pedal Manuale utente
Thule
Thule Kit 2021 Manuale utente
Thule
Thule Pack 'n Pedal Sport Manuale utente
Thule
Thule 973-24 Manuale utente
