SAFETY
• Never leave equipment unattended without shutting o the engine.
• Only operate in well-lit conditions.
• Do not operate when there is a risk of lightning.
• Do not run the engine in a building without adequate ventilation.
• Do not touch the engine or the muer while the engine is running or immediately after stopping the
engine. These areas may be hot enough to cause a burn.
• Do not change the engine governor settings or over-speed the engine. Operating the engine at
excessive speed may increase the hazard of personal injury.
• To reduce the hazard of re, keep the engine, and muer areas free of grass, leaves, excessive
grease, and other ammable materials.
• Clear working area of objects that might be hit or thrown from the machine.
• Keep people and pets out of working areas.
• Know the work area well before operation. Do not operate where traction or
stability is questionable.
• Reduce speed when you are operating over rough ground.
• Equipment can cause serious injury
and or death when improperly used.
• Before operating understand the
operation and safety of the power unit
and attachment being used.
• Do not operate the machine if you are not in good physi-
cal and mental health, if you will be distracted by personal
devices, or are under the inuence of any substance that
may impair decision, dexterity, or judgement.
• Children are attracted to machine activity. Be aware of children and do not allow them in the working
area. Turn o the machine if a child enters the work area.
• The tractor is not designed to have riders of any kind on the tractor, attachments, or attached tools.
• Use full width ramps for loading the machine into a truck or trailer.
• Always secure the power unit and/or attachment to the transporting vehicle securely using straps ,
chains, cable, or ropes.
• Both front and rear straps should be directed down and outward from the machine.
• Shut o fuel supply to the power unit during transport on a truck or trailer.
• Keep all safety decals legible. Remove all grease dirt, and debris from safety decals and instruc-
tional labels.
• If any decals are faded, illegible, or missing, visit www.tilmor.com.
• When new components are installed, be sure that current safety decals are axed to the replacement
components.
• If any component requires replacement use only original Tilmor replacement parts.
• Keep all bolts, nuts screws and other fasteners properly tightened.
• Always ensure the kickstand is lowered or the power unit is supported, and shut o engine. Make
sure all moving parts have come to a complete stop before cleaning, inspecting, adjusting, or repair-
ing.
