8
Important note – If you have circled anything other than “Shared” on the worksheet, you
must follow the instructions below to set each phone as you have marked on the worksheet.
Setting Up Private, Auxiliary and Unconnected Lines
To program:
1. Press PROGRAM.
The display will read “Program...”
2. Press the soft key under NEXT
repeatedly, until “Line Connections”
appears In the display, and then
press ENTER.
The display will show the current
line connection setting for Line 2.
3. Press the soft key under CHANGE
repeatedly, until the desired line
connection setting for Line 2 is dis-
played.
The choices are:
L2: SHARED (factory setting)
L2: PRIVATE
L2: L2 AUX1
L2: UNCONNECTED
4. Press the soft key under NEXT to
see the current setting for Line 3,
and repeat steps 3 and 4 to change
the settings for Lines 3-4.
5. Press PROGRAM to exit.
While you must share the same Line 1 telephone num-
ber at all the stations, you may choose to leave some
lines unconnected at particular stations or to connect
private or AUX1liary lines to Lines 2, 3 or 4 at particular
stations.
SHARED: This is the factory setting for all lines, and is
the setting you use if the particular line is connected at
this station to the same telephone number as the cor-
responding line at the other stations.
PRIVATE: Use this setting at any telephone that is con-
nected to a different telephone number than the cor-
responding line at the other stations. For example, you
may connect your private telephone number to Line 3
at your station instead of connecting your station to the
shared Line 3. In this example, you would set Line 3 at
your station as PRIVATE.
AUX: Use this setting if two or more stations are con-
nected to a different telephone number than the cor-
responding line at the other stations, but they share the
same number among them- selves. For example, you
may connect a group of stations to a separate Line 3
telephone number than the rest of the system, yet they
share that same Line 3 telephone number among them-
selves. In this example, you would set Line 3 at these
stations to “L3 AUX1.”
Note that you can have up to one auxiliary Line 2, one
auxiliary Line 3, and up to two auxiliary Line 4’s.
UNCONNECTED: Use this feature at any telephone that
is not physically connected to all of its lines. For ex-
ample, you may install an EPIC 4- line telephone in a
room that is currently wired for only lines 1, 2 and 3.
In this example, you would set Line 4 at this station as
UNCONNECTED.
Installing Your System
