TomTom 1EE0.052.01 Manuale utente

TomTom ONE

What’s in the box1.

What’s in the box

* Not included with all products.

EasyPortTM holder

Car Charger

RDS-TMC Traffic Receiver*

Documentation pack

USB cable

TomTom ONE

Getting started2.

Getting started Install your TomTom ONE in your car following the instructions on the

installation poster at the start of this book.

To switch on your TomTom ONE, press and hold the On/Off button for 2

seconds. The first time you switch on your device, it may take a short while to

start.

You have to answer a few questions to set up your device.

Having problems?

In rare cases, your ONE may not start correctly or may stop responding to

your taps.

First, check that the battery is charged properly. To fully charge the battery,

you need to charge it for at least 2 hours.

If this doesn’t work, you can reset your device. To do this, press and hold the

Power button for fifteen seconds. Release the Power button when device

begins to restart.

Charging your TomTom ONE

Before you use your ONE for the first time, it’s a good idea to charge it fully

using the home charger, which takes about 2 hours.

There is no charging light on your ONE. To check the battery status and see

when your ONE is charging, switch on your device and tap the bottom right-

hand corner of the screen in the Driving View. The battery status is shown on

the next page.

Improving reception

If your TomTom ONE takes longer than 5 minutes to find your current

position, make sure that the device is in an open space away from tall objects,

such as buildings or trees.

When you connect your TomTom ONE to your computer, you can use

TomTom HOME to download information about GPS satellite positions during

the next 7 days. This helps your ONE to find your position faster.

Important: Some vehicles have heat reflective shielding in the windscreen.

This may prevent your ONE from locating your current position.

Take care of your TomTom ONE

Never leave your TomTom ONE or accessories on view when you leave the

car or they may become an easy target for thieves.

You can set a password for your TomTom ONE which must be entered every

time you start your ONE.

It is important to take care of your ONE.

• Your ONE is not designed for use in extreme temperatures and any such

exposure may cause permanent damage.

• Do not open the casing of your ONE under any circumstances. Doing so

may be dangerous and will invalidate the warranty.

• Wipe or dry the screen of your ONE using a soft cloth. Do not use any liquid

cleaners.

Driving View3.

Driving View When your TomTom ONE starts, you are shown the Driving View along with

detailed information about your current location.

Tap the centre of the screen at any time to open the Main Menu.

Note: The Driving View is shown in black and white until your ONE locates

your current position.

ATap + and - to zoom in and out.

BYour current position.

CThe name of the next major road or road sign information, if applicable.

DTraffic bar - requires an RDS-TMC Traffic Receiver (available as an

accessory).

ENavigation instruction for the road ahead.

Tap this area to repeat the last spoken instruction and to change the

volume.

FThe name of the street you are on.

GInformation about your journey such as journey time, remaining distance

and arrival time.

To change the information shown, tap Status bar preferences in the

Preferences menu.

HGPS signal strength.

Making your first journey4.

Making your first journey Planning a route with your TomTom ONE is easy. To plan your first route,

follow the steps below.

Important: You should always plan your journey before you start driving. It is

dangerous to plan a route while driving.

1. Tap the screen to bring up the Main Menu.

Note: The buttons on your ONE are shown in full colour unless a button is

currently unavailable. For example, the button named Find alternative... in

the Main Menu is not available until you have planned a route.

2. Tap Navigate to...

3. Tap Address.

When you enter an address, you can choose from the following options:

•City centre - tap this button to set your destination as the centre of a city

or town.

•Street and house number - tap this button to set an exact address as your

destination.

•Postcode - tap this button to enter a postcode as your destination.

Note: You can enter a postcode for any country. In the UK and the

Netherlands, postcodes are detailed enough to identify a house on their own.

In other countries you can enter a postcode to identify a town or area. You will

then have to enter a street and house number.

•Crossing or intersection - tap this button to set your destination as the

point where two streets meet.

In this example, we will enter an exact address.

4. Tap Street and house number.

Note: When planning a trip for the first time your ONE asks you to choose a

country. Your choice is saved and used for all routes you plan.

You can change this setting at any time by tapping the country flag.

5. Start to type the name of the town where you want to go.

As you type, the names of the towns that match what you have typed are

shown. When your destination appears in the list, tap the name of the town

to set the destination.

6. Start to type the name of the street and select it when it is shown.

As with the name of the town, the names of the streets that match what you

have typed are shown. When your destination appears in the list, tap the

name of the street to set the destination.

7. Now enter the house number of your destination and then tap Done.

8. Your ONE asks if you need to arrive at a particular time. For this exercise,

tap NO.

The route is calculated by your ONE.

9. When the route has been calculated, tap Done.

Your ONE will immediately begin to guide you to your destination, using both

spoken instructions and on-screen directions.

Arrival times

When you plan a route, your TomTom ONE asks you if you need to arrive at a

particular time.

Tap YES to enter a preferred arrival time.

Your ONE calculates your arrival time and shows you whether you will arrive

on time.

You can also use this information to work out when you need to leave. If your

ONE shows that you will arrive 30 minutes early, you can wait and leave in 30

minutes time, rather than arrive early.

Your arrival time is constantly recalculated during your journey. The status bar

shows whether you will arrive on time or if you are going to be late, as shown

below:

You will arrive 55 minutes before the arrival time you entered.

If the estimated arrival time is more than five minutes before

the time you entered, it is shown in green.

You will arrive 3 minutes before the arrival time you entered.

If the estimated arrival time is less than 5 minutes before the

time you entered, it is shown in yellow.

You will arrive 19 minutes late.

If the estimated arrival time is later than the time you entered,

it is shown in red.

Status bar

preferences

Tap Status bar preferences in the Preferences menu, to enable or disable

arrival time notifications.

Select the required options on the first menu screen and then tap Done.

To enable arrival time notifications, select Show leeway to arrival time.

What are the other navigation options?

When you tap Navigate to..., you can set your destination in many ways, not

just by entering the address. The other options are listed below:

Planning a route in advance

You can also use your ONE to plan journeys in advance by selecting both your

starting point and your destination. You could, for example, do the following:

• Find out how long a journey is going to take before you start.

• Check the route of a journey you are planning.

Home

Tap this button to navigate to your Home location.

You will probably use this button more than any other.

Favourite

Tap this button to select a Favourite as your destination.

Address

Tap this button to enter an address as your destination.

Recent

destination

Tap this button to select your destination from a list of places you have

recently used as destinations.

Point of

Interest

Tap this button to navigate to a Point of Interest (POI).

Point on map

Tap this button to select a point on the map as your destination using the

map browser.

Latitude

Longitude

Tap this button to enter a destination using latitude and longitude values.

Position of

last stop

Tap this button to select your last recorded position, as your destination.

• Check a route for someone who is coming to visit you, so that you can

explain the route to them.

To plan a route in advance, follow these steps:

1. Tap the screen to bring up the main menu.

2. Tap the arrow button to move to the next menu screen and tap Prepare

route.

3. Select the starting point for your journey in the same way that you would

select your destination.

4. Set the destination for your journey.

5. Choose the type of route that should be planned.

•Fastest route - the route which takes the least time.

•Shortest route - the shortest distance between the locations you set. This

may not be the quickest route, especially if the shortest route is through

a town or city.

•Avoid motorways - a route which avoids motorways.

•Walking route - a route designed for making the journey on foot.

•Bicycle route - a route designed for making the journey on a bicycle.

•Limited speed - a route for a vehicle which can only be driven at a limited

speed. You have to specify the maximum speed.

6. Your TomTom ONE plans the route between the two locations you

selected.

More information about a route

You can access these options for the route you last planned by tapping the

Details button on the route summary screen.

You can then select from the following options:

Prepare route

Browse as

text

Tap this button for a list of all the turn instructions on the route.

This is very useful if you need to explain a route to someone else.

Browse as

images

Tap this button to see each turn in the journey. Tap the right and left arrows

to move forwards and backwards through the journey.

Tap the screen to turn off the 3D display and view the map from above.

Browse map

of route

Tap this button to see an overview of the route using the map browser.

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali TomTom GPS

TomTom

TomTom TNS400 Manuale utente

TomTom

TomTom XXL 530S - Widescreen Portable GPS Navigator Manuale utente

TomTom

TomTom ONE Car GPS Receiver Manuale utente

TomTom

TomTom XL 540S - Widescreen Portable GPS Navigator Manuale utente

TomTom

TomTom GO 740 LIVE Manuale utente

TomTom

TomTom START Manuale utente

TomTom

TomTom navigation module Manuale utente

TomTom

TomTom Golfer Manuale utente

TomTom

TomTom GO Professional 6250 Manuale utente

TomTom

TomTom GO 510 Manuale utente

TomTom

TomTom Blue&Me- Manuale utente

TomTom

TomTom One XLS Manuale utente

TomTom

TomTom Start 60 Manuale utente

TomTom

TomTom navigation module Manuale utente

TomTom

TomTom GPS Receiver Manuale utente

TomTom

TomTom RDS-TMC Manuale utente

TomTom

TomTom LTO 200D Manuale utente

TomTom

TomTom LINK 201 Manuale utente

TomTom

TomTom GO Manuale utente

TomTom

TomTom Blue&Me- Manuale utente

TomTom

TomTom VIA Manuale utente

TomTom

TomTom PRO 7100 Manuale

TomTom

TomTom One XL Manuale utente

TomTom

TomTom XXL 550TM Manuale utente

Manuali GPS popolari di altre marche

Raven

Raven Cruizer II Manuale

Hama

Hama 53118 Manuale utente

Garmin

Garmin SOUNDER 125 Manuale utente

Garmin

Garmin DEZL 580 Manuale utente

Jigabot

Jigabot EX Manuale utente

Pointer

Pointer Cellocator CelloTrack XT LTE Guida all'installazione

Queclink

Queclink GV55LITE Manuale utente

Voxson

Voxson Voxtrack GPS500 Manuale di istruzioni

Garmin

Garmin ECHOMAP PLUS Manuale utente

Starcom Systems

Starcom Systems Kylos Compact Manuale utente

Garmin

Garmin 15 H Series Manuale utente

Cobra

Cobra Marine MC 600Ci Manuale utente

Cellocator

Cellocator CelloTrack T Manuale utente

Enfora

Enfora Mini-MT GSM2228UG001 Manuale utente

Magellan

Magellan eXplorist 100 Manuale utente

LTE

LTE G50B Manuale utente

Garmin

Garmin DEZL OTR500 Manuale utente

SkyGolf

SkyGolf SkyCaddie SG1 Manuale utente