TOMZON A24 Manuale utente
A24
User Manual • Uživatelský manuál •
Užívateľský manuál • Használati utasítás •
Benutzerhandbuch
2
English
3 –17
Čeština
18 –32
Slovenčina
33 –47
Magyar
48 –62
Deutsch
63 –77
3
Dear customer,
Thank you for purchasing our product. Please read the following instructions carefully
before first use and keep this user manual for future reference. Pay particular attention
to the safety instructions. If you have any questions or comments about the device,
please contact the customer line.
www.alza.co.uk/kontakt
✆+44 (0)203 514 4411
Importer Alza.cz a.s., Jankovcova 1522/53, Holešovice, 170 00 Praha 7, www.alza.cz
Safety Reminder
•It is forbidden to use all types of drones within a radius of 5000 metres from
centre point areas of airfield runways, in order to guarantee the electromagnetic
environment requirements of the aviation radio. No remote control and drone
shall be used when radio control instructions are issues by relevant state
authorities.
•Please use the drone indoors, or in a warm, sunny, and windless weather
outdoors. It is forbidden to use it in high temperature, low temperature, strong
wind, thunderstorm, and other bad weather conditions.
•Please keep a safe distance from people, pets, wires, and other obstacles when
using the drone indoors or outdoors and keep the drone within your line of sight
to avoid accidents.
•Once the drone is started, do not touch the parts such as high-speed gears and
propellers to avoid injury.
4
Product Description
Tip: The aircraft has two types of propellers (“A” and “B”), marked A and B. Please match
the Mark “A” or “B” while replacing the propellers.
Forward motor
(corresponding to propeller A)
Tilt motor
(corresponding to
propeller B)
Indicator light
Propeller A
Propeller B
Battery
Propeller A
Propeller B
Power switch
5
Remote Control
Tips: The drone supports two control modes: Mode 1 and Mode 2.
•Mode 1: Use the left joystick to make the drone fly up and down, rotate left and
right; use the right joystick to make the drone go up, down, left, and right.
•Mode 2: Use the left joystick to rotate to front, rear, left, and right; use the right
joystick to make the drone fly up, down, left, and right.
Note: Mode 1 is the default setting. Please press Speed switch button and turn on the
remote control to switch to Mode 2. Take Mode 1 for example to introduce the control
method of the drone.
Right joystick
WASD fine-tuning
Calibrate
Power
Left joystick
One buton takeoff /
landing
Speed switch
Headless mode
Emergency
stop
360° rotation
Battle mode
Orbit flight
Rotation
6
Battery
Battery Installation and Charging
First, place the battery in the drone and buckle it as shown in the picture below.
Then, recharge the battery as shown in the picture below. USB charger indicator turns
red during charging. Once charging is done, the charger indicator turns off.
Notes:
•Please use the original charger for charging. Do not use other chargers.
•Keep the battery away from high temperature, open fire, or electric heaters.
Otherwise, damage or explosion may occur.
•If the product has been idle for too long, please charge it once every two months
to keep the battery in active condition.
•Do not charge the battery on carpets, and other flammable items, in order to
avoid fire hazard.
7
Battery Installation of Remote Control
Open the battery cover of the remote control and install three AAA batteries (not
included in the package) as shown in the picture below.
Tips:
•Be sure that the batteries of the drone and remote control are fully charged
before flying. Otherwise, the drone cannot take off in low battery mode.
•It is not recommended to mix use of acid and alkaline batteries. Please take out
the batteries when drone is to be idle for too long.
8
Quick Start
Frequency Match
Long press the power button on the upper cover to turn on the drone, the indicator
flashes. Then place the drone on a horizontal ground.
Turn on the remote control, it will pair with the drone automatically. The pairing is
complete when the remote control beeps. At this time, the indicator lights of the remote
control and the drone are always on.
Calibration
Press the calibration button to start calibration. The indicator light flashes rapidly during
calibration and after the calibration is completed, the indicator light is always on.
When the drone falls, please calibrate it again. Don’t forget to place the drone on a
horizontal solid ground during calibration.
9
Takeoff and Landing
Method 1
As shown in the picture below, press the takeoff/landing button to take off. When the
drone is in the air, press the button again to make it land.
Method 2
As shown in the picture below, push both joysticks simultaneously to unlock the drone,
then push the left one upwards to takeoff. After the drone takes off, push the right one
downwards to land.
Emergency Stop
In case of emergency, press and hold the STOP button for one second, the drone stops
working and falls.
Tip: The motor should only be stopped in case of emergency to reduce the risk of
damage.
Unlock
Takeoff / Landing
10
Flight
In the following instructions, remote control Mode 1 is being used.
High Speed and Rotation
Use the left joystick to control the height and rotation of the drone during flight.
Front/Rear, Left/Right
Use the right joystick to control the left/right direction of the drone during flight.
Indice
Lingue:
Altri manuali TOMZON Drone
