Toolots SPOA Manuale utente
Owner’s Manual
MODEL: SPOA / SPOB / SPOC
Outdoor Pizza Oven
1
Safety Information………………………………………………………………….................2
Exploded Diagram……………………………………………………………........................4
Assembly Instructions………………………………………………………..................……7
Gas Cylinder use………………………………………………………………….................13
Operating Instructions..…………………………………………………………..................14
Care and Maintenance…………………………………………………………...............…16
TABLE OF CONTENTS
2
Please read and understand this entire manual before attempting to assemble,
operate or install the product.
1. The installation of this appliance must conform with local codes or, in the absence of
local codes, with either the National Fuel Gas Code, ANSI Z223.1/NFPA 54, or Natural
Gas and Propane Installation Code, CSA/CGA-B149.1.
2. This oven is intended for use outdoors and should not be used in a building, garage
or any other enclosed or covered area.
3. This outdoor oven is not intended for installation in or on recreation vehicles and /or
boats.
4. A minimum clearance of 61 cm (24 inches) from combustible constructions to the
sides of the grill and 61 cm (24 inches) from the back of the grill to combustible
constructions must be maintained.This outdoor cooking gas appliance must not be
placed under overhead combustible construction.
5. The use of an electrical source requires that when installed, the grill must be
electrically grounded in accordance with local codes or, in the absence of local codes.
6. Inspect the hoses before each use for excessive abrasion or wear, or cuts that may
affect safe operation of the grill. If there is evidence of excessive abrasion or wear, or
the hose is cut, it must be replaced prior to the grill being put into operation. The
replacement hose assembly must be those specified by the manufacturer.
7. Keep your oven in an area clear and free from combustible materials
gasoline and other flammable vapors and liquids.
8. DO NOT obstruct the flow of combustion and ventilation air to this appliance.
9. Keep the ventilation openings of the tank enclosure free and clear from debris.
10. Check all gas connections for leaks with a soapy water solution and brush. Never
use an open flame to check for leaks.
11. Never use charcoal in the oven.
12. Never use the grill in windy areas.
13. Never use the grill without the drip tray installed and hung under the burner box.
Without the drip tray, hot grease and debris could leak downward and produce a fire
hazard.
14. Use only the gas pressure regulator supplied with this appliance.
15. The cylinder used must include a collar to protect the cylinder valve.
16. Do not store a spare LP-gas cylinder under or near the appliance.
17. Never fill the cylinder beyond 80 percent full.
18. If the information in “17”and “18”is not followed exactly, a fire causing death or
serious injury may occur.
19. The outdoor cooking gas appliance must be isolated from the gas supply piping
system by closing its individual manual shut off valve during any pressure testing of the
gas supply system at test pressures equal to or less than 1/2 psi (3.5 kPa).
20. CALIFORNIA PROPOSITION 65 WARNING: The burning of gas cooking fuel generates
some by products that are on the list of substances known by the State of California to
cause cancer, reproductive harm, or other birth defects. To reduce exposure to these
substances, always operate this unit according to the use and care manual, ensuring
you provide good ventilation when cooking with gas.
SAFETY INFORMATION
3
IMPORTANT: We urge you to read this manual carefully and follow the
recommendations enclosed. This will ensure you receive the most enjoyable and
trouble-free operation of your new gas grill. We also advise you retain this manual for
future reference.
WARNING: Your grill has been designed to operate using only the gas specified by
the manufacturer on the rating plate. Do not attempt to operate your grill on other
gases. Failure to follow this warning could lead to a fire hazard and bodily harm and
will void your warranty.
WARNING: Make certain your LP (propane) tank is filled by a reputable propane
dealer. An incorrectly filled or an overfilled LP tank can be dangerous. The overfilled
condition combined with the warming of the LP tank (a hot summer day, tank left in
the sun, etc.) can cause LP gas to be released by the pressure relief valve on the tank
since the temperature increase causes the propane to expand. LP gas released from
the tank is flammable and can be explosive. Refer to your Owner’s Manual for more
information concerning filling your LP tank.
1 2 3
5
4
6
7
8
9
10
36
35
34
33
32
31
28
26
27
25
23
30
29
11
13
15
12
22
19
18
17
20
16
21
14
24
37
38
4
Exploded Diagram
5
NO
PART NAME
QTY
1 CHIMNEY 1
2 OVEN DOOR HING 2
3 HEAT SPACER 4
4 BACK HEAT-SHIELD 1
5 BACK PANEL 1
6 EXTERIOR 1
7 INTERIOR ASSY 1
8 LATCH 1
9 GAS PIPE JOINT 1
10 GAS PIPE 1
11 WHEEL 2
12 CART SUPPORT 1
13 WHEEL AXLE 1
14 CHECK NUT 2
15 CART BOTTOM PLATE 1
16 CART FRONT PLATE 1
17 LEG R 2
18 LEG PLUG 2
19 LEG L 2
20 GREASE TRAY HOLDER 1
21 GREASE TRAY 1
22 HANDLE 1
23 GLASS DOOR HANDLE 1
24 KNOB 1
25 KNOB BEZEL 1
26 THERMOGRAPH 1
27 IHNITER 1
28 GLASS DOOR 1
29 VALVE 1
30 CONTROL FASCIA 1
31 OVEN FRONT PANEL 1
32 FASCIA HEAT SHIELD 1
33 PIZZA STONE 1
34 BOTTOM GRILL 1
35 BURNER 1
36
FLAME TEMPER 1 (optional accessories)
37 COOKING GRILL 2
38
SMOKER BOX ASSY 1 (optional accessories)
Exploded Diagram
6
Spare parts
Bolt:M6×10mm 2PCS
Nut:M6 2PCS
2PCS6
30PCS 26PCS
3PCS4PCS
Nut
M6
Bolt
M4×12mm
Check nut
1PCS7 8
1 2
43
5 2PCS
Bolt
M6×10mm
Bolt
M5×30mm
Wrench
Battery
7
Use screw M6*10×16 pcs and nut M6×16pcs to fix the 4pcs Leg to the Cart bottom plate
as shown. (Note: 2pcs leg with plug please fix on the Cart bottom plate left, 2pcs leg
without plug please fix on the Cart bottom plate right.)
STEP1
ASSEMBLY INSTRUCTIONS
Before beginning assembly of product, make sure all parts are present. Compare parts
with package contents list and hardware contents list. If any part is missing or
damaged, do not attempt to assemble the product.
Assembly tip! (Please lightly tighten the screws during assembly of the cart.
When the cart is completed THEN TIGHTEN ALL THE screws. This will make it
easier to make all the holes align properly)
8
Assemble the wheel and wheel axle with 2 pcs check nut as shown.
STEP2
STEP3
M6*10×6 pcs and nut M6×6pcs to Assemble the wheel and wheel axle as shown.
9
M6*10×4 pcs and nut M6×4pcs to Assemble the handle as shown.
STEP4
STEP5
Use M4*12×3 pcs to Assemble the chimney as shown.
Questo manuale è adatto per i seguenti modelli
2
Indice
