5
OPERATION PROCESS
1
、
Check whether the battery wiring contacts are good enough to prevent short circuit faults.
2
、
Turn on the machine with a key, and check whether the battery is sufficient, if the battery is too low,
don't continue using the machine, turn off the power immediately, and charge the battery.
3
、
Check that the brush pan or needle holder is properly installed.
4
、
Check whether the gripper is properly installed (The strip is installed).
5
、
Check to see if the wheels are working properly
6
、
Empty the waste water tank.
7
、
Fill the fresh water reservoir with clear water.
8
、
Check the amount of water in the water scale tube, if the amount of water is insufficient, add the
right amount of water first before the operation;
9
、
Check the top cover of the tank to make sure it is properly covered and creates a preliminary seal;
10
、
Check the sewage pipe cap and place it inside the sewage pipe clamp.
11
、
Check to lower the brush pan lifting handle, and lower the brush pan to the ground;
12
、
Check the solenoid valve, open the water valve switch, and adjust to the right amount of water;
13
、
Press the switch of the water absorption motor to start the water absorption motor, pay attention to
whether there is abnormal or abnormal sound, if abnormal, immediately turn off the power
14
、
Press the switch of the brush disk motor to start the brush disk motor, pay attention to whether
there is abnormal or abnormal sound, if abnormal, immediately turn off the power.
OPERATION CAUTIONS
1
、
When stopping cleaning work, please close the water valve first and keep the water scraper
working until all the sewage is absorbed clean, turn off the suction motor, lift the brush plate and
turn off the brush plate motor, and turn off the main power when the suction motor is completely
stopped.
2
、
When cleaning the ground, a large number of sewage stains suddenly appear behind, please drain
the sewage tank in time, so as to carry out normal operation.
3
、
Confirm that the machine does not make any abnormal noise when working. If there is any
abnormal noise, it should stop immediately and check the reason.
CAUTION! In order to better maintain the machine and improve the service life of
wearing parts, the total power supply must be turned off after the water absorption motor
is com
letel
sto
ed.
