4. Intended use
The mechanical sweeper is intended for sweeping level and dry areas such as entrance
drives, terraces, yards, etc.
The equipment may only be used for the tasks it is designed to handle. Any other use is
deemed to be a case of misuse. The user/operator and not the manufacturer will be liable
for any damage or injuries of any kind caused as a result of this.
Please note that our equipment has not been designed for use in commercial, trade or
industrial applications. Our warranty will be voided if the equipment is used in commercial,
trade or industrial business or for equivalent purpose.
5. Technical date
Working width 70cm
Debris collector 14l
Sweeping capacity (at 4km/h) max. 2800m3/h
Size 650x600x210mm
Weight 8.9kg
6. Assembly ( Fig. 2-5)
Note: you will find the feed-in brushes and the assembly material in the debris collector.
1. The feed-in brushes (8) are fastened to the locating plates with 3 screws (9) each.
2. Insert the push bar mounts (4a/4b) into the receiving slots.
3. Secure the push bar mounts (4a/4b) with the screws (6)
4. Push the bottom section of the push bar (2) onto the push bar mounts (4a/4b) and
secure with the two adjustment nuts (5).
5. Slide the top section of the push bar (1) onto the bottom section of the push bar (2)
and secure with two assembly screws (7) and two adjustment nuts (5).
7. Operation ( Fig. 7)
When the mechanical sweeper is pushed, the feed-in brushes (B) and the pick-up brushes
(C) are set in rotation by the belt drives (A). The rotating feed-in brushes (B) sweep the dirt
to the center. The two counter-rotating pick-up brushes (C) convey the dirt into the debris
collector (Fig. 1/6).
