ttingandthelowermanifoldhosetothelowerwheel
motortting(Figure7).Ifthehosesarenotproperly
routedtheymaycomeincontactwiththetiresorrear
bumperwhichwillcausedamagetothehoses.
Important:Donotcrossthehydraulichosesas
theyareroutedfromthemanifoldtothewheel
motors.
Figure7
1.90degrees2.10degrees
3.Repeattheprocedurefortherightwheelmotor.
PositionthehosesasshowninFigure8andtighten
allthehosettings.
Figure8
1.90degrees2.10degrees
4.Reinstallthereartiresandtorquethelugnutsto85-100
ft-lb.
Important:Checkthehoseroutingtoensure
thereisproperclearancewhentheaxleisoscillated
andwhenthesteeringwheelisoperatedinafull
rightandleftlockturn.Theminimumtiretoaxle
clearanceshouldbe1/2inch(13mm).
4
InstalltheManifoldTubes
Partsneededforthisprocedure:
1Hydraulictube,partno.108-7624
1Hydraulictube,partno.108-7625
1Hydraulictube,partno.108-7626
3Bulkheadlocknut
2Tubeclamphalves
1Capscrew(5/16x1-1/2inches)
1Flatwasher(.344x.688)
1Locknut(5/16inch)
Procedure
1.Routethehydraulictube,partno.108-7624,fromthe
leftmanifoldttinglabeled“RF”totherightholein
therightframebulkheadbracket(Figure9).
2.Securetherearofthehydraulictubetothemanifold
ttingandthefronttothebulkheadwithabulkhead
locknut(Figure9).
3.Routehydraulictube,partno.108-7626,fromthe
centermanifoldttinglabeled“REV”totheholein
theleftframebulkheadbracket(Figure9).
4.Securetherearofthehydraulictubetothemanifold
ttingandthefronttothebulkheadbracketwitha
bulkheadlocknut.
5.Routehydraulictube,partno.108-7625,fromtheright
manifoldttinglabeled“LF”totheleftholeinthe
rightframebulkheadbracket(Figure9).
6.Securetherearofthehydraulictubetothemanifold
ttingandthefronttothebulkheadwithabulkhead
locknut.
7.Securethe2rightbulkheadlinestogetherwiththetube
clamphalves,capscrew(5/16x1-1/2inches),at
washer(.344x.688)andalocknut(5/16inch)(Figure
9).
5
