Touchboards PSD-VHS Manuale utente
PSD-VHS
TABLE TOP STAND
Step 1
Place the monitor on a soft and flat surface. Install the mounting
bracket to the plasma using the hardware supplied.
Step 2
Choose the place were the monitor would be located. Place the stand
on top of the table top. Install the (PDB-UWFB) Universal Wall Flat
Bracket (make sure that the arrow from the plate is facing up) to the
stand by using the four (4) M10 Slotted Hex Bolts (supplied).
Step 3
Mount the display to the stand (3 people required) hold the stand from
the back. Raise the display and insert the openings from the mounting
bracket to the slip lock flanges from the PDB-UWFB. Once insert
push to the left and down to lock.
The wall should be capable of supporting a weight of at least five (5) times the
plasma displays. If not, the ceiling must be reinforced. Proper installation procedure
by qualified personnel as outlined in the installation instructions must be adhered to.
Failure to do so could result in serious personal injury.
Description
A. PSD-VHS Stand
B. PSD-UWFB Universal Wall Flat Bracket
C. Mounting Bracket Hardware
D. Flat Mounting Bracket
E. Plasma Display
F. M10 Slotted Hex Bolts
For further information or ordering assistance
contact us at the address shown on the front of
this page.
Indice
Altri manuali Touchboards Rack e supporto
Touchboards
Touchboards peerless CPA100WALLARM Guida
Touchboards
Touchboards PANA-103MTV Guida
Touchboards
Touchboards CHIEF FCI Manuale utente
Touchboards
Touchboards PM2-S-XL Manuale utente
Touchboards
Touchboards peerless-AV PRS-KIT0811 Guida
Touchboards
Touchboards Black Box Network Services NBDEP-12 Manuale utente
Touchboards
Touchboards peerless-AV SR560M-AB Manuale utente
Touchboards
Touchboards peerless-AV LCZ-2F430B Guida
Touchboards
Touchboards peerless-AV SS560F Manuale utente
Touchboards
Touchboards Dewey DCS1A Manuale utente
