Setting 3: Wheel Diameter Settings
The “Set WD” setting is pre-set to the correct value for this eBike (26”). This cannot be adjusted.
Setting 4: Speed Limit Settings
Select “Set LS” to change the speed limit settings. When running faster than the speed limit,
the eBike power system will switch off automatically. The speed limit range is 12km/h (7.5mph)
to 40km/h (25mph). The default value is 29km/h (18mph).
To change this setting, press UP or DOWN to increase or decrease until the desired
speed limit is displayed.
Press MODE for 2s to store the selection and return to the general selections interface.
Setting 5: Battery Power Bar Settings
Select “Set Voltage” to change the power battery display settings. For example, VOL 1 is the
voltage value at which the battery display will drop from two bars to one. Voltage thresholds for
each of the 5 battery bars must be entered one at a time.
To set the voltage level for the first battery bar display, press UP or DOWN
To store a changed setting and access the next bar’s threshold, press the MODE button.
After the voltage value is entered for the fifth bar, hold MODE for 2s to confirm and
return to the general settings interface.
See Figure 3 at the end of this manual for the default battery power bar settings.
Advanced Settings
The advanced settings are preset to recommended parameters, and shouldn’t need to be
changed. Advanced settings can be used to adjust pedal assist power settings, slow start
settings, backlight brightness and the start up password for the eBike.
To access the advanced settings, hold the UP and DOWN buttons for 2s to enter general
settings. Enter “1 2 3 4” when prompted for a password, then hold the UP and DOWN buttons
for 2 more seconds to enter the advanced settings interface. Press the UP or DOWN button to
transition through the available settings, then press the MODE button to adjust the selected
setting.
6
