P9/12
The Modular Ringlight works in manual control and
continuous working (CW) mode by default. To use
theremote control, youneed to connect the 8 pin cable
and apply PNP signals to the relevant pins. TheModular
Ringlight has Teach and Run mode.
keypad conTrol
Colour and Sector Selection
• Program settings: push the 2 buttons together
for 3 - 4 seconds,
• Change settings: 1 push of Colour and / or
Sector button(s) until desired configuration
is selected,
• Save settings: push the 2 buttons together
for3 - 4 seconds.
User saFeTy
Do not modify or dismantle all or part of the product.
Respect the power supply voltages and the connection terminals.
Ensure power supply is switched off whilst connecting product and turn on only once product
isfully connected. Failure to do this may damage the product and invalidate theWarranty
Do not stare at the lighting source directly.
Follow advice below for installation to minimise operator exposure to the light source.
INSTALLATION GUIDANCE:
• Forbid or limit the direct access to the lighting source (exposure into the radiation axis).
• Establish a security perimeter to prevent the operators from approaching the lighting source beyond therecom-
mendations of the manufacturer.
• If the workstation permits it, introduce a lter that will stop the lighting radiation under a xed or adjustable
frame between the source and the operator. When these measures cannot be implemented, supply theoper-
ators with glasses (class 4) available from TPL Vision, or with a dedicated protective mask, that will stop
thelighting radiation.
It is the responsibility of the persons installing this product to ensure that all means possible (such as those stated
above) have been implemented to reduce exposure of the machine operators to the light emitted from this product.
Colour selection
Sector
selection
