Trakm8 T8 Manuale dell'operatore
Page 1 of 27 Company Confidential
Version 1.0
The AA Ltd
AA Signs Division
Installation Documentation
Ford Transit
Page 2 of 27 The AA Signs– Company Confidential
Version 1.0
Overvie
The Signs division of The AA Ltd require Trakm8 to provide a telematics solution that will monitor, collate and stream data
including:
CAN us data to show fuel usage
Beacons– input zero to monitor when the eacons are operational
Green/red switch enclosure – input 1 and input 2 to monitor when sign(s) deployed and collected
GPS tracking
Driver Feed ack
Please note that driver identification (dallas key) is no longer required on The AA Signs. Disconnect the driver id receiver from the
T8 premium iring loom (2 molex connectors) but DO NOT remove it from the vehicle panel.
This document has een produced to provide exact instructions on how this equipment is to e installed, input location and
any interfaces have een agreed with The AA Ltd and under no circumstances should e deviated from without written
permission.
Please note that you are not insured to drive / move The AA Ltd vehicle during the installation process.
Ensure the ignition remains s itched OFF at all times during the installation. Any connections made ith po er to the Trakm8
unit ill cause faults on the vehicle ECU.
Hardware required for Ford
Transit
•Trakm8 T8
•Premium Wiring Loom
•GPS Antenna
•Fuse Kit (2 x Holder + 1 Amp
and 2 Amp fuse)
•T-Piece
•T-Piece Bracket
•T-Piece CAN Extension Ca le
Hard are continued on page 4
Page 3 of 27
Hardware for
Ford Transit
The AA Signs– Company Confidential
Version 1.0
Trakm8 Install Ford Transit
Hardware required for Ford
Transit
•Push utton enclosure
- GREEN (Deployed)
- RED (Collected)
•Single LED Driver Feed ack
Module
•Buzzer
•1K Resistor
Page 4 of 27
Hardware for Ford
Transit
The AA Signs– Company Confidential
Version 1.0
Trakm8 Install Ford Transit
Complete kit
(Pre-installation)
OBD
Trakm8 CAN us (T-Piece) Install
Page 5 of 27 Version 1.0 The AA Signs– Company Confidential
This image shows the wires
required for installation
(Also see wiring notes on
page 26)
•Red = Live (12volts on
vehicle)
•Blue = Ignition on vehicle
•Black = Earth to a
chassis olt on vehicle
•Green/White (part of
twisted pair) = CAN us
High
•Blue/White (part of
twisted pair) = CAN us Low
The purpose of this
information is to provide
a guide and specification
for the installation of the
TrakM8 telematics unit
into a Ford Transit.
This instruction is
specific to the Ford
Transit.
Page 6 of 27
Purpose Of
Information
The AA Signs– Company Confidential
Version 1.0
Trakm8 Install Ford Transit
The key points are:
•Buzzer
•Main TCU location
mounted under glove ox
ehind clocks.
•Power pick up points in
loom under glove ox
ehind clocks.
•Driver Feed ack Module
in front of clocks
•GPS Antenna location
a ove heater vent.
•Push utton enclosure
•CAN us pick up from T
Piece at OBD socket.
Page 7 of 27
Overview
The AA Signs– Company Confidential
Version 1.0
Trakm8 Install Ford Transit
•The Driver Feed ack Module
(DFM) is located onto the left
hand side of the driver
instrument console as shown.
•Thoroughly clean the surface
and adhere the DFM to the
surface with the adhesive pad
supplied.
Page 8 of 27
Secure the Driver
Feed ack Display
The AA Signs– Company Confidential
Version 1.0
Trakm8 Install Ford Transit
•Attach DFM Molex connectors to
the corresponding female Molex
connectors the T8 main loom:
BLACK/WHITE to BLACK/WHITE
BLACK/BROWN to BLACK/BROWN
•Neatly store any excess ca le
alongside the unit.
Page 9 of 27
Connect the DFM to the
Trakm8 Unit
The AA Signs– Company Confidential
Version 1.0
Trakm8 Install Ford Transit
•Remove the lower dash
panel y carefully
releasing from the metal
clips
•Remove the original OBD
connecter y removing 2
philips screws.
Page 10 of 27
Locate the vehicle
OBD socket
The AA Signs– Company Confidential
Version 1.0
Trakm8 Install Ford Transit
Altri manuali per T8
1
Indice
Altri manuali Trakm8 Accessori per automobili
