
T22/T22i Installation Guide
© 2007 - 2011 Tramigo Ltd. All rights reserved. Under the copyright laws, this manual cannot be reproduced in any form
without the prior written permission of Tramigo. Page 3
1Preface
Failure to comply with the following warnings and safety information may
invalidate warranty, certification or type approval of this product.
This equipment should not be operated in hazardous environments i.e. areas that contain
explosive materials or flammable vapours.
This equipment should not be operated in aircraft or in close proximity to medical equipment.
Internal components containing beryllium oxide may be used in this equipment. Dust from this
material is a health hazard if inhaled or allowed to come into contact with the skin. Great care
must be taken when handling these components.
Unauthorised modification to this equipment or associated accessories is forbidden without the
express permission and agreement from the product manufacturer.
Safety Information
Please adhere to the following Safety and Installation information at all times.
Supply Voltage: +6V minimum to +32V maximum
Fuses : Power – fit a 1A inline fuse (included in T22-CAR)
Ignition – fit a 1A inline fuse.
Note: Fuses should be placed in all power lines and as close as possible to the vehicle supply
source.
THE RATINGS OF THESE FUSES SHOULD NOT BE EXCEEDED AT ANY TIME
WARNING!
This equipment may only be located in a position where it cannot interfere with
the normal operation of the vehicle or present a hazard to the driver or
passengers. Care must also be taken in the routing of all cables so that the
insulation does not become worn or damaged.
Installation Information
All installation and service work must be carried out in accordance with MPT 1362, MPT 1372,
RQAS, VSIB, 95/54/EC, ISO 21609 and / or any other statutory guidelines or Directives currently
in force.
Therefore it is strongly recommended that the T22 unit is installed and commissioned by suitably
trained and qualified Installation Personnel i.e. in the UK those who are accredited and registered
by the Vehicle Systems Installation Board (www.vsib.co.uk).
Important Notes!
Unauthorised changes or alterations to the equipment or the installation will invalidate
certification issued by the Approved Accreditation Body and may also affect the vehicle
manufacturers warranty.
Under no circumstances may any part of the T22 system be installed inside the engine
compartment area.