Trango Systems Flacon Plus Manuale utente
Falcon PLUS™ SERIES
5.8 GHz Wireless Video/Audio/Alarm/Data
Transmission System
Installation and Operating
Instructions
Copyright © 2000 Trango Systems, Inc. (All rights reserved)
1
(This Page Intentionally Left Blank)
Copyright © 2000 Trango Systems, Inc. (All rights reserved)
2
Quick Start Guide
1• Verify proper operation of camera and monitor/event
recorder using coaxial cable prior to installing wireless link.
2• Install transmitter (VTX5900) and receiver (VRX5900) units
to a steel pole in desired location per installation drawing
(see Figure 1A). The pole must be securely mounted so that
it does not move, and may be from 1.5” to 3” in diameter.
3• Install antennas above the enclosures.
WARNING
USE EXTREME CARE WHEN INSTALLING ANTENNAS
NEAR POWER LINES.
4• Slide heatshrink over antenna cable. Tighten antenna cable
to receiver and transmitter. Heat the heatshrink until it
contracts around the connector junction.
5• Connect video, audio, power, alarm, PC interface cables as
needed to units through flanges. Tighten flanges to allow
small air gap at bottom of enclosure.
IMPORTANT NOTE:
Power adapter must be kept dry.
6• Verify that LEDs are lit up and transmitter and receiver are
on same channel.
7• Tighten lid of enclosure.
8•To help protect against potential lightning damage, use a
lightning surge arrestor in line with all cabling entering a
structure and at the antenna input.
Copyright © 2000 Trango Systems, Inc. (All rights reserved)
3
CAUTION
DO NOT APPLY POWER TO THE TRANSMITTER UNLESS
THE ANTENNA IS CONNECTED. PERMANENT DAMAGE
MAY RESULT.
Copyright © 2000 Trango Systems, Inc. (All rights reserved)
4
Your Trango Wireless Video System
Congratulations on choosing Trango Systems, Inc. to fulfill your
wireless video needs. Unpack your system carefully. If any items
are missing, notify your sales representative. If an item appears to
be damaged from shipment, replace it in its packing material and
notify the shipper.
Save the packaging for further storage of the equipment.
Service:
If the unit ever needs repair service, contact a Trango
Systems, Inc. distributor for return authorization and
shipping instructions.
FCC Information:
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy, and if not installed and used in
accordance with these instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to correct the interference by one of more of the following
measures:
1) Reorient the receiving antenna;
Copyright © 2000 Trango Systems, Inc. (All rights reserved)
5
2) Increase the separation between the affected
equipment and the receiver;
3) Connect the affected equipment to an outlet on a
different circuit from that
which the receiver is connected to;
4) Consult the dealer and/or experienced radio/TV
technician for help.
VTX5900: # NCYVTX5900
CANADA: VTX5900: 29451031885
VRX5900: 29451031885A
IMPORTANT NOTE:
Intentional or unintentional changes or modifications not
expressly approved by the party responsible for
compliance must not be made. Any such modifications
could void the user’s authority to operate the equipment
and will void the manufacturer’s warranty.
Copyright © 2000 Trango Systems, Inc. (All rights reserved)
6
System Description:
The Falcon PLUS™ Wireless Video System is a
professional quality system designed for sending composite
NTSC or PAL video, audio, and alarm signals using 5.8 GHz
wireless technology. The typical Falcon PLUS™ system
consists of a VTX5900 transmitter and antenna, VRX5900
Receiver and antenna, and power adapters. The system is
ideal for permanent or temporary video links due to its
portable nature and easy installation. It is not designed for
operation while in motion.
Figure 1a shows the most common connection diagram for
setting up a wireless video link using the Falcon PLUS™.
Audio connections are not shown. The default channel
selection is Channel 1.
Figures 1b and 1c show the orientation of the antennas and
mounting of the enclosures. Since the antennas are
directional, they must be aligned towards each other as
shown.
NOTE: Make sure that your camera and monitor/recorder
work properly hardwired before attempting to install the
wireless link.
Copyright © 2000 Trango Systems, Inc. (All rights reserved)
7
• Figure 1a•
Copyright © 2000 Trango Systems, Inc. (All rights reserved)
8
• FIGURE 1b •
Copyright © 2000 Trango Systems, Inc. (All rights reserved)
9
• FIGURE 1c •
Indice
