TreeGreen energyEGG Manuale utente
energyEGG Assembly
Instructions v6.0
Version : v6.0
Date : 4th May 2012
TreeGreen Limited
Digital Enterprise Centre,
CBLZ Building,
190 Cathedral St
Glasgow,
G4 OND
Stuart Henderson
07941 222 437
stuart@treegreen.net
1
energyEGG Assembly Instructions
Equipment Required
Phillips head screwdriver
Components
1 x EG-001 : Main Base
1 x EG-002 : Front Case
1 x EG-004 : Rear Case
1 x EG-005 : Button
1 x EG-006 : Dial
1 x Lens
1 x PCB (Printed Circuit Board)
4 x Screws
1 x Compliance Label
2
energyEGG Assembly Instructions
3
energyEGG Assembly Instructions
4
energyEGG Assembly Instructions
5
energyEGG Assembly Instructions
6
energyEGG Assembly Instructions
Before beginning assembly please note:
-Be careful when handling the PCB(Printed Circuit Board) as touching the
Sensor can seriously impair functionality.
-Be careful when handling the Lens as it is sensitive and easily scratched –
this can significantly diminish the functionality of the lens.
Step 1 : Insert Button (EG-005)
Insert Button (EG-005) into the slot at the top of the Main Base (EG-001) as
shown in Figure 1a. The Button should slide into the ledge as shown in Figure
1b.
Figure 1a - Insert Button in Main Base
7
energyEGG Assembly Instructions
Figure 1b - Slide Button into Ledge
The Button should sit flush in the Main Base when inserted correctly. When
inserted correclt, there should be no gap between the Button and Main Base
(See Figure 1c).
Figure 1c - There should be no gap between Button and Main Base
8
energyEGG Assembly Instructions
The Button should also be flush and parallel with the top of the Main Base
(See Figure 1d).
Figure 1d – Button should fit into the Main Base and not be angled
9
energyEGG Assembly Instructions
Step 2 : Prepare PCB
The first step of inserting the PCB is to tie a knot in the battery fly wire, around
5cm from the base of the PCB (see figure 2a)
Figure 2a - Tie knot in the battery fly lead
Altri manuali per energyEGG
1
Indice
