AWC7813 motion controller user manual
3.14.2 Example analysis................................................................................51
3.14.2.1 Wavy lines appear when cutting arcs.....................................51
3.14.2.2 Wavy lines appear at the beginning and corners of the cutting52
3.15 Common Parameters Settings......................................................................52
3.15.1 Work Mode........................................................................................52
3.15.1.1 Go Origin After Reset............................................................. 53
3.15.1.2 Origin Mode........................................................................... 53
3.15.1.3 Go Back Position.....................................................................54
3.15.1.4 Count Mode............................................................................54
3.15.2 Common Parameters.........................................................................54
3.15.2.1 AutoFocus Distance(mm)....................................................... 55
3.15.2.2 KeyMove’Speed(mm/s)..........................................................55
3.15.2.3 RunBox’Speed(mm/s).............................................................55
3.15.2.4 CutBox’Speed(mm/s)............................................................. 56
3.15.2.5 Blow Open Delay(s)................................................................ 56
3.15.2.6 Blow Close Delay(s)................................................................ 56
3.15.3 Axis Speed Parameters...................................................................... 56
3.15.3.1 Z Work Speed(mm/s)..............................................................57
3.15.3.2 XY Home Speed(mm/s).......................................................... 57
3.15.3.3 Z Home Speed(mm/s)............................................................ 57
3.15.4 Rotate Engraving & Cutting............................................................... 58
3.16 Manufacturer Parameters Settings.............................................................. 61
3.16.1 Axis Parameters(take X axis as an example)......................................61
3.16.1.1 Distance Per Pulse(um).......................................................... 62
3.16.1.2 Valid Pulse Edge......................................................................65
3.16.1.3 Datum Direction..................................................................... 65
3.16.1.4 Key Direction.......................................................................... 65
3.16.1.5 Limit-Switch Valid Level..........................................................66
