Troy Lighting B3562 Manuale utente
11/29/20131
B3562,B3563,B3564 INSTALLATION INSTRUCTIONS
WARNING
DISCONNECT POWER BEFORE RELAMPING OR WIRING THE FIXTURE.
READ ALL INSTRUCTIONS COMPLETELY BEFORE STARTING INSTALLATION.
CAUTION
•TO AVOID THE RISK OF FIRE OR SHOCK, FIXTURE MUST BE INSTALLED IN COMPLIANCE WITH ALL APPLICABLE NATIONAL AND LOCAL
ELECTRICAL/BUILDING CODES.
•INSTALLATION AND MAINTENANCE OF THIS UNIT REQUIRES AN ELECTRICIAN OR CERTIFIED FACTORY TRAINED TECHNICIAN.
•I
f
an existing fixture is being replaced, remove it and note to which o
f
the wires in the outlet box the fixture was attached.
DO NOT SEPARATE ANY OTHER WIRES THAT MAY BE IN THE BOX.
DO NOT DAMAGE THE INSULATION OF OLDER WIRING.
In regular circumstances the BLACK wire will be the "Hot" lead and the WHITE wire will be the "Neutral" or "Common" lead.
A GREEN or BARE COPPER wire is the "Ground".
In older buildings it is always good practice to reconfirm the polarity of the wiring.
NOTICE
•The important safeguards and instructions outlined on this sheet cannot cover all possible conditions and situations
that may occur.It must be understood that common sense, caution and care are factors that cannot be built into any product.Caution and care
must be supplied by the person(s) installing, operating and caring for this lighting fixture.
•This fixture is designed to be mounted on a correctly installed standard round or octagon box or athrough wiring box
with a plaster frame. The box must be securely mounted to the structure of the building.
The crossbar and hardware supplied should be used. Directly mounting the fixture to the outlet box may make it impossible to correctly align
the fixture.
FIXTURE PREPARATION
Remove the fixture, parts and parts bag(s) from the carton.
NOTICE:
Before discarding the carton, double check to make certain that all parts are found.
FIXTURE INSTALLATION
1. (Starting at the back), thread the 2screws into the mounting ring.
(The green ground screw is the front ). Attach the mounting ring to the outlet box.(The green screw should face out).
Using the level make certain that the screws are horizontal.
2. Thread the small hex nuts onto the screws.Adjust the screws so that they extend 3/16" beyond the back of the fixture,
Lock the hex nuts against the crossbar.
3. Fasten the ground wire to the green or bare copper wire 。in the outlet box (if outlet box is plastic)
or to the green screw on the crossbar
WARNING
Never fasten the ground wire to the black or "hot" wire!
Failure to follow this instruction could result in
serious injury or death!
4. Fasten the white fixture lead to the white wire in the outlet box.
Fasten the wires together with an approved fastener (wire nut).
Starting about 1' below the fastener, tightly wrap the connection
with electrical tape so that the connection seals the end of the fastener.
11/29/20132
WARNING
Make sure that there is no exposed wire or strands that
could cause a dangerous short circuit !
5. Connect the black fixture lead to the black wire in the outlet box.
Fasten the joined wires as in step 4
.6. To prevent water from flowing into the outlet box put a bead of weatherproof
caulking or silicone sealant around the inside edge of the back.
DO NOT PLUG THE DRAIN HOLE !
7. Using the half balls and sealing washers, fasten the fixture to the outlet box
8.remove the lock ball ,Remove the bottom screws from the cage .
Removethecagefromtheroof.
9. Install the candle cover and lamps ( light bulbs).
NOTE: This fixture is rated for 60 watt type B, BA, C or CA lamps.
WARNING
DO NOT EXCEED RECOMMENDED WATTAGE!
10. Place the glass into the cage.
11. Carefully reassemble the cage to the roof .
12. place thebottom cover and decorative part. With the lock ball
13. Restore power to circuit at breaker or fuse box
electrical tape
approved fastener
(
wire nut
)
Candle cover
Lam
p
Roof
Glass
Cage
Bottom cover
Lock ball
Deorative part
Back plate
Half ball
Ground screw
Mountn
g
rin
g
Nipple
Bottom screw
Questo manuale è adatto per i seguenti modelli
2
Indice
Altri manuali Troy Lighting Luce esterna
Manuali Luce esterna popolari di altre marche
Lindby
Lindby 9949029 Manuale utente
HEPER
HEPER DOGO Side LW6048.585-US Istruzioni per l'installazione e il funzionamento
HEPER
HEPER LW8034.003-US Istruzioni per l'installazione e il funzionamento
Maretti
Maretti VIBE S 14.6080.04.A Manuale utente
BEGA
BEGA 84 253 Manuale
HEPER
HEPER MINIMO Istruzioni per l'installazione e il funzionamento
LIGMAN
LIGMAN BAMBOO 3 Manuale utente
Maretti
Maretti TUBE CUBE WALL 14.4998.04 Manuale utente
Maxim Lighting
Maxim Lighting Carriage House VX 40428WGOB Manuale utente
urban ambiance
urban ambiance UQL1273 Manuale utente
TotalPond
TotalPond 52238 Manuale utente
Donner & Blitzen
Donner & Blitzen 0-02661479-2 Manuale utente