UFactory uArm Controller Manuale utente
uArm Conveyor User Manual V1.0.0
Part Lists
Hardware:
1. Conveyor Belt * 1
2. 12V Power Adapter * 1
3. Screwdriver * 1
4. Seeed Grove Sensor Cable * 4
5. LCD * 1
6. USB Type C Cord * 2
7. USB Cable * 1
8. Control Board * 1
9. uArm Swift Pro Stator * 2
10.Target Object（Red & Green & Yellow Cube）* 1
11.uArm 30P Bottom Expansion Plate * 2
12.uArm Power Cable * 1
13.Material Slide * 1
14.Connection Plate * 1
Software:
1. Arduino IDE
2. conveyor_belt.ino for Arduino Mega 2560
3. UArmSwiftPro_2ndUART.hex for uArm
1.Software installation
1) Download the hex
2) Download and extract XLoader.
3) Open XLoader and select your uArm's COM port from the drop down menu
on the lower left.
4) Select the appropriate device from the dropdown list titled "Device".
5) Check that Xloader set the correct baud rate for the device: 115200 for Mega
(ATMEGA2560).
6) Now use the browse button on the top right of the form to browse your hex
file.
7) Once your hex file is selected, click "Upload" The upload process generally
takes about 10 seconds to finish. Once completed, a message will appear in the
bottom left corner of XLoader telling you how many bytes were uploaded. If
there is an error, the total bytes uploaded will be shown instead. (Please check
if the parameters are the same as shown in the picture below, except COM port
may different)
2.Hardware installation
1) Install the uArm Stator
Fix the uArm stator on the conveyor belt.
2) Install Main Control Board
Fix the control board on the base of the conveyor belt.
3) Install another uArm Stator
Fix another stator on the conveyor belt.
4) Install the Material Slide
Use the connection plate to connect the stator and material slide.
5) Connect the Ultrasonic Sensor
Insert the ultrasonic sensor cable into the D10-D11 port of the control board.
6) Connect the Line Finder
Insert the line finder cable into the D12-D13 port of the control board.
7) Connect the color sensor
Insert the color sensor cable into the IIC port of the control board.
8) Connect the LCD
Insert the LCD cable into the IIC port of the control board.
9) Connect the Conveyor Belt
Insert the conveyor belt motor 8PIN cable into the motor drive port of the control
board.
10)Install the uArm Swift Pro
Place the uArm Swift Pro on the stator tightly.
Place the other uArm Swift Pro the same way.
11)Connect the COM of uArm Swift Pro
Connect the uArm Swift Pro to the control board with the TYPE-C cable. The
TYPE-C interface on the left side of the control board is connected to the uArm
Swift Pro on the left, and the TYPE-C interface on the right is connected to the
uArm Swift Pro on the right.
12)Connect the Power Supply of uArm Swift Pro
Link the two uArm Swift Pro to the power terminal.
13)Overview
3.Operation
1）Press the uArm power button
2）Use 12V power adapter to power up the whole system
3）Press the reset button of the control panel to reset the system
Altri manuali per uArm Controller
4
Indice
Altri manuali UFactory Accessori
