foil easier for you.
• Unscrew the back wing and remove the wedges from the back of the
mast fuselage connection.
• Remove the M6 screw from the front wing assembly and bump the front
wing forward by hand, or using a soft rubber mallet, until it slides off the
fuselage.
• Now unscrew the mating screw set and slide the fuselage forward out
of the mast. Never slide it back, it will get stuck because the fuselage is
tapered.
Care and Maintenance:
• The foil is manufactured from reinforced composites, epoxies, carbon
fibres and stainless steel. Although these are reasonably durable
materials, care and maintenance are required to maintain your foil's
performance and appearance.
DO NOT LEAVE THE FOIL IN DIRECT SUNLIGHT, A HOT CAR, OR
ANYWHERE ELSE WHERE IT MAY BE EXPOSED TO HEAT OR
SUNLIGHT. DOING SO COULD CAUSE DAMAGE.
• Avoid placing the foil on hard surfaces that are sharp or abrasive, as this
may damage the finish.
When not in use, cover the foil and place it in a shaded area.
•
Rinse the hydrofoil with fresh water after every use.
•
• Once a week, remove the front wing and lightly grease the screws and
bolts before reinserting them.
• Ensure that sand, salt and other materials do not accumulate or block
the holes for the screws. Damage will occur to the threaded areas if you
screw them back in with sand or other debris.
Warranty:
The foils are covered by a limited warranty.
• We warrant all products to be free from major defects in materials and
workmanship for 6 months from the date of purchase by the original owner.
• This warranty applies to the original owner for purchases made directly
from Foil-Smart or our authorised dealers, and is not transferable.
• In the event that damage is due to a material or manufacturing defect,
we will determine whether to repair or replace the product or
component in question. The owner is responsible for all associated shipping
charges.
