United Technologies interlogix TruVision TVB-2402 Manuale utente
TruVision High
Definition TVI
Bullet Camera Installation
Guide
TVB
-2402/TVB-4402
TVB-2404/TVB-4404
P/N 1072938-EN • REV A • ISS 10MAR15
2 Installation Guide
Product overview
This is the TruVision High Definition TVI Bullet
Camera Installation Guide for models TVB-
2402/TVB-4402 and TVB-2404/TVB-2404. This
guide describes a standard installation.
Package contents:
Camera with power
and video output
cables
4 screws and 4
anchors for wall or
ceiling installation
Back box
Screws M4.8 ×18,
4pcs to attach the
back box
Installation Guide 3
Template
Hex wrench
•WEEE and Battery
Disposal
CD
Ceiling Mounting
11
11
2
22
2
1:Screw Hole for
Bracket
2:Screw Hole for
Mounting Base
4 Installation Guide
Camera description
1. CVBS output cable
(black)
2. TVI output cable
(grey)
3. Power cable
4. Camera body
5. Sun shield
6. Lens cover
7. Mounting bracket
8. Back box
Note:
Please check the camera output settings before
setting up a system. The TVI video output can be
only connected to DVR with TVI signal input. The
8
2
7
3
1
5
6
4
Installation Guide 5
CVBS output supports the standard monitor, test
monitor, encoder and DVR.
For TVB-2402 / TVB-4402, the CVBS and TVI
output can not be performed at the same time, you
can use the built-in DIP switch to select the camera
video output.
For TVB-2404/TVB-4404, the built-in DIP switch is
used to enable/disable WDR feature, when WDR
feature is enabled, the CVBS output will be blocked
out.
DIP switch
Menu button
6 Installation Guide
Installation
To install the camera:
1. Using the template, place it level against the
mounting surface and mark the position of the
mounting holes.
2. Following all local codes, drill and prepare the
mounting holes.
3. (Optional) Install the back box on the wall.
Ceiling Mounting
11
11
2
22
2
1:Screw Hole for
Bracket
2:Screw Hole for
Mounting Base
Installation Guide 7
4. Route the cables to the cable hole and connect
the corresponding cables. Using a 75-ohm
coaxial video cable, connect the camera TVI
video output and a TVI DVR, and connect a
12 VDC or 24 VAC power supply to the power
cable.
5. Secure the camera to the ceiling or wall with
the screws.
8 Installation Guide
6. Loosen the three screws and adjust the camera
according to the figure below to get an optimum
angle. Tighten the screw after completing the
adjustment.
Questo manuale è adatto per i seguenti modelli
3
Indice
Altri manuali United Technologies Telecamera di sicurezza
