URC Total Control MRX-4SEN Manuale utente
Owner’s Manual
MRX-4SEN
Sensor Extender
MRX-4SEN Sensor Extender Owners Manual ©2013 Universal Remote
Control, Inc.
The information in this manual is copyright protected. No part of this
manual may be copied or reproduced in any form without prior written
consent from Universal Remote Control, Inc.
UNIVERSAL REMOTE CONTROL, INC. SHALL NOT BE LIABLE FOR
OPERATIONAL, TECHNICAL OR EDITORIAL ERRORS/OMISSIONS MADE
IN THIS MANUAL.
The information in this manual may be subject to change without prior
notice.
Total Control is a registered trademark of Universal Remote Control, Inc.
URC Control The Experience is a registered trademark of Universal Remote Control, Inc.
All other brand or product names are trademarks or registered trademarks
of their respective companies or organizations.
500 Mamaroneck Avenue, Harrison, NY 10528
Phone: (914) 835-4484 Fax: (914) 835-4532
TABLE OFCONTENTS
Introduction 1
Features and Benefits 1
Parts Guide 1
Front, Rear, and Bottom Panel Descriptions
2
Network Installation 5
Specifications 6
USA Limited Warranty Statement 7
End User Agreement 9
Federal Communication Commission
Interference Statement 10
Declaration of Conformity 11
MRX-4SEN SENSOR EXTENDER
Introduction
Thank you for purchasing the MRX-4SEN Sensor Extender. Expand
your MRX Advanced Network System Controller sensor coverage
beyond four ports by adding additional MRX-4SEN units throughout
the home or office.
Features and Benefits
•Expand Sensor Coverage
Add one or more MRX-4SEN throughout your home or office
to detect changes in a connected sensor, which may be used to
trigger system events.
• No Cables, No Mess, No Fuss
Connect a MRX-4SEN virtually anywhere in the home or office
without the mess of cables while communicating over URC’s
2.4GHz wireless connection.
• Compact Size
The small size of the MRX-4SEN allows it to easily fit behind
equipment or into places where a traditional base station would not.
Page 1
Parts Guide
The MRX-4SEN includes:
1 - MRX-4SEN Sensor Extender
1 - AC Power Adapter
4 - Mounting Screws
1 - Mounting Plate
1 - Owner’s Manual
Page 2
MRX-4SEN SENSOR EXTENDER
Front, Rear, and Bottom Panel Descriptions
Front Panel
The front panel consists of three indicator lights:
Power LED: The Power LED illuminates when the unit is powered.
Status LED: The Status LED color will vary depending upon its
connected state:
●Connected: Illuminates green
●Low Signal: Illuminates orange
●Not Connected: Not illuminated
Data LED: The Data LED flashes as the MRX-4SEN transmits data to
a MRX Advanced Network System Controller.
Page 3
Rear Panel
The rear panel consists of:
DC 12V Power: Plug in the included 12V DC 1A power supply.
Sensor Inputs: Connect the sensor’s 3.5mm plug to an available port.
The following URC sensors, with their respective model numbers, are
compatible with the MRX-4SEN:
● Voltage Sensor SEN-VOLT
●Video Sensor SEN-VID
●Contact Closure Sensor SEN-CCLS
●Light Sensor SEN-LITE
●Current Sensor (Magnetic Field) SEN-CMF
● Audio Sensor SEN-AUD
Mini USB connector: For future firmware upgrade use!
MRX-4SEN SENSOR EXTENDER
Page 4
MRX-4SEN SENSOR EXTENDER
Bottom Panel
The bottom panel consists of:
ZIGBEE Address Sticker: The ZIGBEE Address (16 characters) identifies
this wireless device when connected to the network.
Serial Number Sticker: The serial number, located at the bottom of the
unit, uniquely identifies the product.
Test button: Press to refresh the signal and test the signal strength
between the MRX Advanced Network System Controller and the MRX-
4SEN. While testing, the Status LED will update and display its current
connection setting. (Refer to page 2 for Status LED information.)
Reset button: Turns the unit OFF then ON again, and reconnects to
the URC 2.4GHz RF signal.
Page 5
Network Installation
WARNING!! Before proceeding, a Custom Professional is required
to install and configure your MRX-4SEN.
Connect the 3.5mm sensor plug to the rear of the MRX-4SEN. When
a change in the sensor’s state is detected, the MRX-4SEN sends a
signal to the MRX Advanced Network System Controller and triggers
a series of commands.
The example below showcases a voltage sensor connected to the
home’s doorbell and the MRX-4SEN. Whenever the door bell is
pressed, a signal is sent over URC’s RF 2.4GHz to the MRX
Advanced Network System Controller. The MRX unit, previously
programmed by the Custom Professional, will trigger a series of
commands or an event to gain your attention. A programmed
event, such as Watch Movie/TV, may pause the movie, mute the
audio and display the front door’s video camera.
MRX-4SEN SENSOR EXTENDER
Page 6
MRX-4SEN SENSOR EXTENDER
Specifications
Sensor : Four sensor ports support Video, Current, Contact Closure,
Ambient Light, Audio, and Voltage sensors from URC.
USB : Mini USB for future firmware upgrade use.
RF Range(radio frequency) : 50 to 100 feet, depending upon the
environment
RF Frequency : 2.405 ~ 2.480 GHz
Weight : 2.98oz
Size : 3.74” X 2.7” X 1.1”
Power : 12V DC 1A
Page 7
MRX-4SEN SENSOR EXTENDER
USA Limited Warranty Statement
1. Limited Warranty and Disclaimers
Universal Remote Control, Inc. (“URC”) warrants that the URC equipment
shall be free from defects in material and workmanship under normal usage
for one (1) year from purchase when such is purchased from URC. This
limited warranty is valid only in the United States of America. URC warrants
that the software will substantially conform in any material respect to its
functional specifications at the time of delivery. URC SHALL NOT BE LIABLE
FOR OPERATIONAL, TECHNICAL OR EDITORIAL ERRORS AND/OR
OMISSIONS MADE IN THE URC DOCUMENTATION. URC DOES NOT
WARRANT THAT THE URC SOFTWARE IS BUG-FREE OR ERROR FREE
OR THAT THERE ARE NO ERRORS/BUGS IN THE URC SOFTWARE.
URC warrants that at the time of purchase the URC equipment and the URC
software complied with all applicable regulations and policies of the Federal
Communications Commissions (“FCC”) regarding electromagnetic
interference caused by electronic/computing devices and to the extent that the
URC equipment and/or the URC software fails to so comply, URC shall, at its
own expense, take all reasonable measures to promptly cause such to
comply.
URC equipment purchases from other than an authorized URC dealer or
distributor are without warranty.
THIS LIMITED WARRANT DOES NOT COVER TECHNICAL ASSISTANCE
FOR HARDWARE OR SOFTWARE USAGE EXCEPT AS EXPRESSLY
PROVIDED FOR HEREIN, THE EQUIPMENT, SOFTWARE AND
DOCUMENTATION OF URC ARE SUPPLIED “AS IS” WITHOUT ANY
WARRANTY, EXPRESS, STATUTORY OR IMPLIED, OF ANY KIND. TO
THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, URC
EXPRESSLY DISCLAIMS ALL WARRANTIES, EXPRESS, STATUTORY OR
IMPLIED, INCLUDING BUT NOT LIMITED TO THE WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. URC
DOES NOT WARRANT, GUARANTEE, OR MAKE ANY
REPRESENTATIONS REGARDING THE USE OF, OR THE RESULTS OF THE
USE OF, THE EQUIPMENT, SOFTWARE OR DOCUMENTATION IN
TERMS OF CORRECTNESS, ACCURACY, RELIABILITY OR OTHERWISE.
EXCEPT AS EXPRESSLY PROVIDED FOR HEREIN, TECHNICAL SERVICES
ARE SUPPLIED “AS IS”, WITHOUT ANY WARRANTY, EXPRESS,
STATUTORY OR IMPLIED, OF ANY KIND. TO THE MAXIMUM EXTENT
PERMITTED BY APPLICABLE LAW, URC EXPRESSLY DISCLAIMS ALL
WARRANTIES, EXPRESS, STATUTORY OR IMPLIED, INCLUDING BUT
NOT LIMITED TO THE WARRANTIES OF QUALITY OR REASONABLE
Altri manuali per Total Control MRX-4SEN
2
Indice
Altri manuali URC Estensione
