V-tech Glitter Me Kitten 5424 Manuale utente
Instruction Manual
91-004021-000-006 US
2
2
2
INTRODUCTION
Thank you for purchasing the Glitter Me KittenTM.
The kitten’s lights will show you if it’s hungry, sleepy, gassy, bored or
itchy. Press its tummy to translate the meows into words. When you
pet the kitten’s head, it will place a magical glittery stamp on your
hand!
Off/Low Volume/High
Volume Switch
Stamping Map
Light-Up Head Button
Mouth Button
Back Button
Tummy Button
Ink Pad
3
3
3
INCLUDED IN THE PACKAGE
• Glitter Me KittenTM
• 1 milk bottle
• 1 ink pad for hand with cover
• 1 Quick Start Guide
• 1 stamping map (two pieces)
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy, and should be discarded for your child’s safety.
NOTE
Please save this manual as it contains important information.
ATTENTION
Pour la sécurité de votre enfant, débarrassez-vous de tous les
produits d’emballage tels que rubans adhésifs, feuilles de plastique,
attaches, étiquettes, cordons et vis d’emballage. Ils ne font pas partie
du jouet.
NOTE
Il est conseillé de conserver ce guide car il comporte des informations
importantes.
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the
bottom of the kitten, use a screwdriver to
loosen the screw and open the battery
cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 3 new AA batteries following the
diagram inside the battery box.
5. Replace the battery cover and tighten the
screw to secure.
4
4
4
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
•
Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES
• Remove rechargeable batteries from the toy before charging.
• Rechargeable batteries are only to be charged under adult
supervision.
• Do not charge non-rechargeable batteries.
Unlock the Packaging Locks
Rotate the packaging locks counterclockwise
90 degrees.
Pull out the packaging locks and discard.
5
5
5
To Begin Playing With Glitter Me KittenTM
When you play with Glitter Me KittenTM for the first time, slide the
switch from the High Volume position to the Low Volume position
and wait for more than one second to exit Try-Me mode. You will
hear three beeping sounds when you have exited Try-Me mode. You
can then press any button to activate the unit and start playing.
How to Install the Ink Pad For Hand
With the Glitter Me KittenTM, adult assembly is required.
Please note that the unit comes with a pink decorative cover on the
kitten’s paw. This cover will need to be removed and the ink pad for
hand installed so that the Glitter Me KittenTM can stamp hands.
1. Pull the decorative cover off the kitten’s
paw.
2. Take the ink pad for hand from the
aluminum packaging and remove the
plastic ink cover from the ink pad for hand.
3. Place the ink pad for hand on the kitten’s
paw, with the tip of the heart pointed toward
the paw.
4. Press down firmly on both sides of the ink
pad for hand. You will hear it click into place
when inserted properly. The ink pad for
hand is now ready to use.
5. Put the decorative cover and plastic ink
cover together by aligning their latches,
and store them on the bottom of the kitten,
with the cover’s latch facing Off/Low/High
Volume Switch and decorative cover
facing in.
6
6
6
6. When not using the ink pad for hand for an
extended period, we suggest taking it out,
putting the ink cover back on and storing it
in a cool, dry location.
7. Clean the stamp holder with a wet cloth to
remove any ink and place the decorative
cover back on the kitten’s paw.
8. The ink is safe and washes off with soap
and water.
WARNING
The ink pad is ONLY for stamping paw prints onto your hand. It is not
intended for any other use. Please read all of the safety warnings in
this manual before use.
NOTE: Before using the ink pad, please test a small amount of ink
on the inside of your wrist to ensure there is no reaction or skin
sensitivity.
PRODUCT FEATURES
1. Off/Low/High Volume Switch
To turn the unit On, slide the switch
from Off to the Low Volume or High
Volume position. To turn the unit Off,
slide the switch to Off position.
7
7
7
2. Light-Up Head Button
Press the Head Button for three
responses:
a) Press and hold for 2 seconds and the
kitten will move her paw to give you a
stamp.
b) Press once to hear cute kitten sounds
or listen for hints on how to respond to
what the kitten needs.
c) Press two times to hear the kitten sing
songs. Keep an eye on the colors of the
lights on her head, as they indicate the
kitten’s mood.
3. Tummy Button
a) After pressing the Back Button, Head
Button or Mouth Button, press the
Tummy Button to hear what the kitten
said.
b) When the kitten meows, press the
Tummy Button to translate the purrs or
meows into a human voice.
c) If you want to hear different voice lines,
you can press the Back Button, Head
Button or Mouth Button again and then
press the Tummy Button.
8
8
8
4. Back Button
a) Press to hear different kitten sounds.
b) Quickly press 2 times to hear the kitten
sing playful songs.
c) When the kitten is itchy, this button and
the Head Button are great spots to
scratch!
5. Mouth Button and Milk Bottle
a) Press to hear different kitten sounds.
b) Press 3 times or press and hold for
several seconds to feed your kitten
when she feels hungry.
c) Use the Milk Bottle to feed your kitten
anytime or when your kitten feels
hungry. Be careful to not feed her too
much, or she will get the hiccups or
need to burp.
6. Stamping Map
The Stamping Map shows the best
position for your hand to receive a
stamp. Put the two pieces of the map
together on a desk or flat surface. Then
place the kitten and your left hand on
the map and press the kitten’s head for
2 seconds.
7. Automatic Shut-Off
To preserve battery life, the Glitter Me KittenTM will shut off
automatically after several minutes without input. The unit can
be turned on again by sliding the Off/Low/High Volume Switch
or by pressing any button. The unit will also automatically turn
off when the batteries are very low.
9
9
9
ACTIVITIES
Glitter Me KittenTM has five different statuses. When you play
with her for a while or after she is left alone for a short period, she
will change her status. The lights on the kitten’s head represent
different feelings:
Head Light Color What It Means What To Do
Yellow Happy Continue to play with
your kitten.
Red Loving. The kitten
loves your care.
Continue to take care
of your kitten.
Purple
Questioning. The
kitten wonders if your
action is correct.
Try another action
to take care of your
kitten.
Orange
Excited. The kitten is
excited and ready to
give you a stamp.
Put your hand under
the kitten’s paw to get
a glitter stamp.
Pink
Awesome. The kitten
feels awesome when
she stamps your
hand.
Enjoy the stamp that
the kitten gave you.
Green, Slow Flashes Sleepy
Pat the kitten’s back
or head 3 times to
make her sleep.
Green & Blue Hungry Use the milk bottle to
feed your kitten.
Orange & Blue Has the hiccups or
need to burp.
Pat the kitten’s back
3 times or press her
back for 3 seconds.
10
10
10
Blue, Slow Flashes Bored
Play with the kitten by
patting her head or
back, or feed her with
the milk bottle.
Purple & Blue Itchy
Find out if the kitten’s
back or head is itchy
and pat that spot 3
times to make the
kitten comfortable.
Rainbow Show time. The
kitten wants to sing.
Your kitten will sing
a song. Press the
Tummy Button to
alternate between
meows and real
words.
Stamp Feature
1. Put the two pieces of the Stamping Map
together as illustrated in the picture.
2. Then put the map on a desk or flat
surface, then place the kitten and your
left hand according to the prints on the
map. Try to keep your hand flat while the
kitten stamps it.
3. Press and hold the button on the
kitten’s head for more than 2 seconds.
A magical light will show on the kitten’s
head as it stamps.
4. When the kitten starts to stamp, you can
use your hand to hold the kitten’s head
to prevent the kitten from moving or
shifting. This will help the stamp transfer
more thoroughly.
Indice
Altri manuali V-tech Giocattolo
V-tech
V-tech Click Box - Xtreme Ice Manuale utente
V-tech
V-tech PAW Patrol Marshall's Read-to-Me Adventure Istruzioni di montaggio
V-tech
V-tech Little SmartPhone Manuale utente
V-tech
V-tech SWITCH&GO DIONS Burnout the Velociraptor Manuale utente
V-tech
V-tech Alphabet Alien Manuale utente
V-tech
V-tech Smellephant Manuale utente
V-tech
V-tech Style & Glam On Unicorn 5425 Manuale utente
V-tech
V-tech Cody The Smart Cub Manuale utente
V-tech
V-tech Go! Go! SmartWheels Revved Up Stunt Spiral Istruzioni di montaggio
V-tech
V-tech KidiCom Advance Istruzioni di montaggio
V-tech
V-tech Fun Phonics Yellow Taxi Cab Manuale utente
V-tech
V-tech SWITCH & GO DINOS Manuale utente
V-tech
V-tech Go! Go! Smart Wheels SmartPoint Vehicle Istruzioni di montaggio
V-tech
V-tech Talking Whiz Kid French Manuale utente
V-tech
V-tech nickelodion PAW PATROL Pups to the Rescue Driver... Manuale utente
V-tech
V-tech Whiz Kid CD - Dora the Explorer Manuale utente
V-tech
V-tech Smart Start Basic Plus Manuale utente
V-tech
V-tech Get Ready for School Learning Desk Manuale utente
V-tech
V-tech Tablet Notebook Manuale utente
V-tech
V-tech Animal Fun Treehouse Manuale utente
