Page 9 of 47 Version 2.0
DO600000191 November, 2006
12 Volt
Nominal 24 Volt
Nominal 48 Volt
Nominal
Valere Valere Valere
Parameter Description Default Default Default
LANGUAGE The language in which the controller will
display English English English
FLOAT V The voltage to which the rectifiers will
regulate the plant during float mode 12 Vdc 27 Vdc 54 Vdc
BATT. CL
status* Enables the battery current limit feature Disabled Disabled Disabled
BATT. CL I* The controller will limit the current to the
batteries at this setpoint 255 A 255 A 255 A
RECT. CL status Enables the system current limit feature Disabled Disabled Disabled
RECT CL I The controller will limit the current of the
rectifiers to the value 200 A 200 A 200 A
FALLBACK
status
Enables or Disables the Fallback feature.
Fallback provides a safe voltage to which the
rectifiers will output when they lose
communication with the controller for more
than one minute. Disabled Disabled Disabled
FALLBACK V
The safe voltage to which the rectifier will
fallback to in the event communication is lost
with the controller for more than one minute 11 Vdc 25 Vdc 50 Vdc
HVSD The controller will shut down the rectifiers if
the plant voltage exceeds this setpoint 14 Vdc 29 Vdc 58 Vdc
HIGH V
The controller will issue a High Voltage
Alarm if the plant voltage exceeds this
setpoint 13 Vdc 28.25
Vdc 57 Vdc
BD ALARM
The controller will issue a Battery-On-
Discharge alarm if the plant voltage falls
below this setpoint 11 Vdc 24 Vdc 48 Vdc
LVD Warning
The controller will issue a Low Voltage
Warning if the plant voltage falls below this
setpoint 10 Vdc 22 Vdc 44 Vdc
CAPACITY
status
An alarm is set if the number of installed
rectifiers will not support N+1 redundancy
required by the load. Disabled Disabled Disabled
I SHARE status
A minor alarm is set if the output current of
any rectifier exceeds current sharing
tolerances Enabled Enabled Enabled
COM FAIL
status
An alarm is set if any rectifier either stops
communicating or is removed from the shelf.
User action is required to clear the alarm Disabled Disabled Disabled
BOOST status
Enables or Disables the boost charge tests.
The boost feature will increase the output
voltage of the rectifiers for a short period of
time, usually to charge the batteries. Disabled Disabled Disabled
BOOST V The voltage at which the boost charge test will
increase to once the feature is activated 13 Vdc 28 Vdc 56.5 Vdc
BOOST H The length of time the boost charge test will
run 12 hours 12 hours 12 hours
