Vaporti VOX Manuale utente
USER MANUAL
ENGLISH • ESPAÑOL
01
VAPORFI™ VOX 50 USER MANUAL
Thank you for purchasing the VaporFi VOX 50. In order to use your device correctly, efficiently
and safely, please follow the instructions it this manual.
THE VOX 50 INCLUDES:
»[ 1 ] 50 watts vaporizer
»[ 1 ] USB charger
03
FEATURES:
»Adjustable Output Power From 7 w - 50 w (in 0.1 w increments)
»Accepts Atomizer Resistance from 0.2 ohm (sub) - 3.0 ohm
»Digital OLED Screen
»Maximum Output Voltage: 3.0 v - 8.5 v
»Input Voltage: 3.2 v - 4.2 v
»Output Current: 22 Amps
»510 Threading with Adjustable Pin
»Replaceable Battery
»Output Short-Circuit Protection
»Reverse Battery Protection
»Auto Ohm Resistance Meter (Finds ideal voltage for RBA/RDA)
»Low Voltage Protection
»Low Resistance Protection
»Input High Voltage Warning
»Temperature Protection
»USB Pass Through Charging System
»Vented Battery Casing
»Pocket Sized: 95 mm x 42 mm x 22 mm
05
BATTERY OPERATION
The minimun battery requirement is 1 VaporFi 30 amp/2100 mah High Capacity Battery
(18650).
INSTALLING BATTERY
1. Unscrew and remove the top cap of the VOX 50 by turning the top counterclockwise.
2. Insert the battery into the VOX 50 with the positive side in first.
3. Screw the top back on by turning it clockwise until secure (make sure not to over
tighten).
TURNING DEVICE ON
Press the power button 5 times continuously to turn the device on. VaporFi will flash on the
screen indicating that the device is on.
TURN DEVICE OFF
Press the power button 5 times continuously to turn the device off.
CHARGING YOUR VOX 50
1. Connect the USB charging cable into the micro USB port on the side of the device.
2. Connect the other end of the USB charging cable to either the USB port located on the
wall charging adapter or to a fully powered USB port, such as on a computer.
3. During charging the light above the USB port turns red. Once the device is fully charged
the light turns green.
Please allow 3-4 hours for charging to complete.
NOTE: The device is not to be use while charging.
07
ADJUSTING WATTAGE
Output wattage can be adjusted from 7 w to 50 w.
INCREASING WATTAGE
Wattage can be increased by 0.1 ohm increments when pressing “+” until the desired
wattage is displayed.
Press and hold the “+” button to toggle through wattage quickly.
DECREASING WATTAGE
Wattage can be decreased by 0.1 ohm increments when pressing “-” until the desired
wattage is displayed.
Press and hold the “-” button to toggle through wattage quickly.
ERROR CODES:
Low Res=Low atomizer resistance(﹤0.2Ω)
Low-Bat=Low battery voltage(﹤3.2V)
HHHHHHHH=High input voltage(﹥5V)
TOO HOT= High temperature
Indice
Lingue:
