Vax 30000 Manuale utente

Wash ‘n’ Dry Canister

Get Cleaning...

What’s your Vax’s model number?

What’s your serial number? (Located on the handle of the machine)

Note these down in case you need them in future. Please keep instructions for further use.

vax.com.au 30000

User Guide

Vax Careline: AU: 1300 361 505

NZ: 0800 800 900

3 0 0 0 0

Vax Service line: AU: 1300 361 505

NZ: 0800 800 900 vax.com.au

Vax Service line: AU: 1300 361 505

NZ: 0800 800 900 vax.com.au 2

Machine Overview

Fig.1/1

1 Water pump button (green)

2 Power button (red)

3 Carry handle

4 Power cord

5 Container release clips

6 Casters

7 Suction hose connection port

8 Solution tube port

9 Exhaust lter

10 Hose

11 Solution tube

12 Suction hose connector

13 Solution tube to machine connector

14 Solution tube to wash head/upholstery tool connector

15 2 x stainless steel extension tubes

16 Fibreow carpet wash head

17 Upholstery wash tool

18 Vax Carpet Cleaning Solution

19 Combination oor head (for dry vacuuming)

20 2 x paper dustbags

21 Filter assembly

22 Crevice tool

23 Dusting brush

24 Upholstery tool

AAA

AN TI

AL L ER G E N

AD D I T I V E

General Safety Information

Vax Service line: AU: 1300 361 505

NZ: 0800 800 900 vax.com.au3

FOR HOUSEHOLD USE ONLY.

When using the vacuum cleaner, basic safety precautions should

always be observed, including the following:

1. Do not leave the multifunction machine unattended when

plugged in. Unplug it from the socket when not in use.

2. To prevent electric shock do not use outdoors.

3. Not to be used as a toy.

4. Children should be supervised to ensure that they do not play

with the appliance.

5. This appliance is not intended for use by persons (including

children) with reduced physical, sensory or mental capabilities,

or lack of experience and knowledge, unless they have been

given supervision or instruction concerning the use of the

appliance by a person responsible for their safety.

6. Use only as described in this manual. Use only Vax

recommended attachments.

7. Do not use the vacuum cleaner if it has been dropped,

damaged, left outdoors or dropped into water. Do not use the

vacuum cleaner with a damaged cord or plug. If the supply cord

is damaged, it must be replaced by the manufacturer or a

recommended service agent to avoid a hazard..

8. Do not handle the plug or multifunction machine with wet

hands. Do not use outdoors.

9. Do not pull or carry by cord. Do not use cord as a handle, close

a door on the cord or pull cord around sharp edges or corners.

Do not run the multifunction machine over the cord. Keep the

cord away from heated surfaces.

10. Do not put any objects into openings or operate with openings

blocked. Keep them free of anything that might reduce airflow.

11. Keep hair, loose clothing, fingers and all parts of body away

from openings and moving parts.

12. Do not vacuum hot coals, cigarette butts, matches or any hot,

smoking or burning objects including ash.

13. Do not use the carpet washing function without the solution

tank and dirty water tank in place.

14. Do not use the vacuum for dry cleaning without the dust

bag in place.

15. Turn off all controls before unplugging.

16. Do not vacuum harmful or toxic material (chlorine, bleach,

ammonia, drain cleaner etc.).

17. Do not vacuum hard or sharp objects such as glass, nails,

screws, coins, etc.

18. Do not vacuum plaster dust, concrete dust or any other building

or vitreous materials.

19. Do not vacuum baking soda or any other powder-based carpet

refresher or deodoriser.

20. Do not use the vacuum cleaner with blocked filters or without

all of the filters in place.

21. Use only SAA 10 amp extension cords. Non approved cords

may overheat. Care should be taken to arrange the cord so that

the cord cannot be tripped over.

22. Store the multifunction machine in a cool, dry area.

23. To prevent dirty water from running into motor, do not hold the

appliance upside-down or lay on its side. Use appliance in

normal vacuuming/carpet washing position.

24. Take extra care when cleaning on stairs.

25. Turn off the on/off switch before unplugging the

multifunction machine.

26. Do not carry appliance while motor is running.

27. We recommend the use of a residual current device with a

residual current rating of 30mA or less.

WARNING: Always switch off and unplug the multifunction

machine from the electrical outlet before assembling,

opening, emptying the dirt container, before connecting/

disconnecting the attachments, or carrying out maintenance

or troubleshooting checks.

NOTE: Carpets should be dry vacuumed thoroughly

before washing.

IMPORTANT: It is very important that filters are kept clean

to obtain maximum performance from your vacuum cleaner.

Not cleaning and not replacing the filters regularly can

reduce the suction power and cause overheating and

permanent damage to the vacuum cleaner. If your filters are

washable make sure they are completely dry before inserting

back into the multifunction machine.

IMPORTANT: If the hose or tools are blocked, switch off the

multifunction cleaner and remove the blockage(s) before

re-starting your machine. See maintenance.

DAMAGE TO THE VACUUM CLEANER CAUSED AS A DIRECT

RESULT OF NOT ADHERING TO THE GENERAL SAFETY

INFORMATION AND THE INSTRUCTIONS IN THIS USER GUIDE

INVALIDATES THE WARRANTY.

This machine is intended for household use only, and NOT for

commercial or industrial use.

PLEASE KEEP THESE INSTRUCTIONS FOR FURTHER USE.

Vax Service line: AU: 1300 361 505

NZ: 0800 800 900 vax.com.au 4

Operation

Unclip Container Release

Clips (A) on both sides

of machine.

Lift out and remove the

clean water solution tank.

Store safely away.

Remove the motor top

from the unit, turn on its

side and remove the oat

housing in an anti-clockwise

direction to unscrew.

Fit the pleated pre-motor

lter by pushing and lightly

twisting the lter on the

motor top.

Remove the solution

connector tube by turning

anti-clockwise by 90

degrees. Store in a safe

place.

Fit the dust bag by aligning

the front of the dust bag

with the inlet slots, and

position the dust bag to ll

the inside of the base.

Fit the plug to the solution

intake port.

Replace the motor top,

ensuring that the dust bag

is not trapped. Ensure the

motor top is secured to the

base with the two clips.

Dry Vacuuming

IMPORTANT: Always remove the power plug from the wall outlet before assembling, servicing

or removing accessories.

IMPORTANT: Only the red power button should be “ON” when the machine is in dry vacuuming mode.

The green pump button should be “OFF”.

Vax Service line: AU: 1300 361 505

NZ: 0800 800 900 vax.com.au5

Operation

Dry Vacuuming Continued

On/O Button Carpet Cleaning Hard Floor Cleaning

Insert the exible hose into

the inlet on the main body

of the vacuum cleaner.

Push in and twist clockwise

a quarter turn until tight.

Push the extension tubes

onto the end of the handle.

Fit the combination oor

tool by pushing on to the

extension tube.

Fully unwind the power cord and

plug the cord into the electrical

outlet. Turn the vacuum cleaner on

by depressing the button located on

the top of the carry handle. The

vacuum cleaner can be turned o

by pressing the on/o button again.

For carpet cleaning, press the

rocker switch on the combination

oor tool as shown to raise

the brushes.

For hard oor cleaning, press the

rocker switch on the combination

oor tool as shown to lower

the brushes.

Vax Service line: AU: 1300 361 505

NZ: 0800 800 900 vax.com.au 6

Operation

Accessories

The accessories can be attached

directly to the handle by removing

the extension tubes and pushing in

the desired accessory.

The accessories can also be

attached to the extension tubes

for extra reach. Remove the

combination oor tool and push

on the desired accessory.

Crevice Tool: for crevices, corners, cracks etc.

Dusting Brush: for delicate surfaces.

Upholstery Tool: for carpet, upholstery, stairs etc.

Vax Service line: AU: 1300 361 505

NZ: 0800 800 900 vax.com.au7

Operation

Preparing the Carpet for Washing

IMPORTANT: Do not use the cleaner as a dry vacuum when set up in carpet washing mode.

1. Dry vacuum carpet thoroughly.

2. Remove as much furniture from the room as possible. If unable to remove the furniture, place plastic or foil

under and around the legs until the carpet has dried completely.

Helpful hints for cleaning carpet:

1. Only use Vax recommended solution with this machine.

2. Do not oversaturate carpet with cleaning solution while using the machine.

3. For heavily soiled areas, additional applications may be necessary.

4. Allow plenty of time to dry carpet thoroughly.

5. Wipe cleaning solution from woodwork to prevent any damage.

6. Try not to walk on carpet until it is completely dry.

7. After carpet is thoroughly dry, vacuum the carpet using a vacuum cleaner with a revolving brushbar. ie.

Vax turbo brush.

8. Before cleaning, determine where to start and end, making sure not to walk over previously cleaned areas.

Check for colourfastness

Before cleaning carpet, test for colourfastness. Dampen a white cloth with solution. Test on a small

inconspicuous area prior to washing. Gently rub the cloth over the area. Check each colour for colour bleeding.

If the cloth remains clean, it should be safe to clean the carpet.

After cleaning

• Allow carpet to dry completely. Try not to walk on the carpet until it is dry.

• If it is necessary to walk on the carpet, place white towels on the areas to be walked on.

• If the carpet is not dry and the furniture must be placed back in the room, use plastic or foil under

the furniture to prevent staining the carpet.

• Thoroughly clean the dirty water tank with warm (max 40ºC) tap water.

Vax Service line: AU: 1300 361 505

NZ: 0800 800 900 vax.com.au 8

Operation

Getting Ready to Wash

Unclip Container Release Clips (A)

on both sides of machine.

Replace clean water tank (A) inside

dirty water tank (B) taking care to

ensure that the space to allow the

dirty water back into the tank is

lined up with the solution port (C).

Lift o motor container and remove

lter assembly. Remove the plug

from the solution intake port and

replace the solution connector tube.

The machine can be used for

washing by placing the clean water

tank (A) back inside the dirty water

tank (B).

Replace motor container (A)

ensuring that the solution pump

hose (B) is aligned with the hole

in the clean water tank (C)

so that it goes inside when the

motor container is clipped back

into position.

Remove clean water tank (A) from

inside the dirty water tank and

ll with warm (max 40°C) water

to point indicated on the tank.

Add 1 capful of Vax Carpet Cleaning

solution per litre of water (unless

otherwise stated on the bottle).

WARNING: Machine must

not be plugged in during

this stage.

Vax Service line: AU: 1300 361 505

NZ: 0800 800 900 vax.com.au9

Operation

Assembly

Push solution tube connector (A)

rmly into solution port (A1).

Twist solution tube connector (A)

a quarter turn to the right to lock

into place.

Wrap solution tube (A) around

hose (B). Ensure that the solution

tube is wrapped loosely enough

to allow the solution to ow freely

through the tube.

Push hose connector (B) rmly into

hose connection port (B1). Twist to

the right until hose connector locks

into place.

After wrapping the tube around the

hose, ax solution tube (A) to hose

(B) using clips provided (C) to hold

it in place.

Push one end of the extension tube

into the handle of the hose.

Push the second extension tube

into the wash head to be used and

push the end of the solution tube

onto the connection port on the

Wash Head / Upholstery Tool.

Indice

Manuali Aspirapolvere popolari di altre marche

Bissell

Bissell LittleGreen Proheat 1425 Series Manuale utente

Panasonic

Panasonic MC-YL637S147-AE Manuale utente

NEFF

NEFF N17XH10 0 Series Manuale utente

LG A9 Series Manuale utente

Oreck

Oreck Cordless Captura BK51700 Series Manuale utente

Kogan

Kogan KAVACROBVWA Manuale utente

Kränzle

Kränzle VENTOS 50 ID Guida utente

EVVO

EVVO Ai35 Manuale utente

DeWalt

DeWalt DWH200D Manuale utente

Pontec

Pontec Pondomatic Vacuum Cleaner Manuale utente

Cleanmaxx

Cleanmaxx PC-P007E Manuale utente

Exido

Exido 240-114 Manuale utente

RIDGID

RIDGID WD1685AU0 Manuale utente

Ezviz

Ezviz RE4P Manuale utente

STG global

STG global TANVAC HDV3000 Manuale utente

Shark

Shark ROTATOR PRO COMPLETE NV550 Series Manuale utente

Factory

Factory M3340 Manuale utente

Shop-Vac

Shop-Vac VN92 SERIES Manuale utente