VeriFone Commander Manuale
Hardware Installation Guide
CommanderTM Site Controller
P/N DOC149-003-01-R
Rev. A02
Commander™ Site Controller Hardware Installation Guide
February 6, 2013
VeriFone®, Inc.
2099 Gateway Place
Suite 600
San Jose, CA 95110
Telephone: 408-232-7800
http://www.verifone.com
Printed in the United States of America.
© 2013 by VeriFone, Inc.
No part of this publication covered by the copyrights herein may be reproduced
or copied in any form or by any means — graphic, electronic, or mechanical,
including photocopying, taping, or information storage and retrieval systems —
without written permission of the publisher.
The contents of this document and all features and specifications are subject to
change without notice. The information contained herein does not represent a
commitment on the part of VeriFone, Inc.
Publications are not stocked at the address given above. Requests for VeriFone
publications should be made to your VeriFone representative.
VeriFone, the VeriFone logo, and Ruby SuperSystem are registered trademarks
of VeriFone, Inc. Sapphire, Topaz, HPV-20, Ruby Manager, Everest, EASY ID,
Electronic Journal On-site, and Ruby Card are trademarks of VeriFone, Inc. in
the U.S. and/or other countries. All other trademarks or brand names are the
properties of their respective holders.
Battery Charging Notification
The unit should be powered up for at least 24 hours prior to initial
application download. This is to prevent loss of data and to ensure
that the battery pack is fully charged.
Important Information
Changes or modifications not expressly approved by VeriFone, Inc.
could void the user’s authority to operate this equipment.
This equipment is not intended to be repaired by the user.
Commander Site Controller Hardware Installation Guide i
Contents
1. Introduction
Choosing a Location . . . . . . . . . . . . . . . . 3
Unpacking Commander Site Controller. . . . 4
System Requirements . . . . . . . . . . . . . . . 5
Cables. . . . . . . . . . . . . . . . . . . . . . 5
Uninterruptible Power Supply . . . . . . 5
2. Commander Site Controller Diagrams
Front Panel . . . . . . . . . . . . . . . . . . . . . 7
CPU A Indicators and Controls . . . . . . 8
CPU A Device Port LEDs (RX/TX) . . . . 9
Rear Panel . . . . . . . . . . . . . . . . . . . . . 10
3. Service and Cleaning
Service . . . . . . . . . . . . . . . . . . . . . . . 11
Battery . . . . . . . . . . . . . . . . . . . . 11
Modem . . . . . . . . . . . . . . . . . . . . 11
Cleaning . . . . . . . . . . . . . . . . . . . . . . 12
4. Specifications and Parts
Commander Site Controller Specifications 13
Memory . . . . . . . . . . . . . . . . . . . . 13
Dimensions/Weight . . . . . . . . . . . . 13
Certifications and Environmentals . . 13
Parts List . . . . . . . . . . . . . . . . . . . . . . 14
Included Parts List. . . . . . . . . . . . . 14
Optional Parts List. . . . . . . . . . . . . 14
ii Commander Site Controller Hardware Installation Guide
Commander Site Controller Hardware Installation Guide 1
1 INTRODUCTION
The Commander™ Site Controller is a high-powered server that
increases the capacity and functionality of VeriFone’s ethernet
capable Point of Sale (POS) workstations by extending the processing
and communications bandwidth for managing peripherals.
Future needs are designed into the hardware to provide support for
additional serial ports and CPU boards along with additional fan and/
or power connection that may be needed as a result. Use of these
expansion capabilities will be determined by VeriFone.
System peripherals, such as fuel dispensers, dispenser card readers
(DCRs), and car wash controllers connect directly to the Commander
Site Controller.
Commander Console provides additional functionality with four
separate software modules: Journal Browser, Configuration Client
(for browser-based configuration), Transaction Manager, and Report
Navigator.
Figure 1: Command Site Controller and Workstations
Workstation
Workstation
SS
s
Commander Site Controller
2Commander Site Controller Hardware Installation Guide
The Commander Site Controller contains the functionality of a V950™
to perform on-site maintenance operations such as backups,
upgrades, restores, and reversions to previous software versions.
The addition of a router allows the Commander Site Controller, with
the functionality of the V950, to:
■Receive configurations remotely using available Internet
protocols and tools, including a Web browser interface.
■Connect with VeriFone Technical Support Center computers
for software downloads and diagnostics.
Commander Site Controller Hardware Installation Guide 3
Choosing a Location
Many sites place the Commander Site Controller under the counter or
in the back office.
The Commander Site Controller may be mounted on a wall or under a
counter using the brackets designed specifically for it. See the
optional Commander Site Controller Bracket Kit for complete
mounting instructions. When deciding where to place the
Commander Site Controller, make sure that the location meets the
following requirements:
■Power: 120 Volts AC, 60 Hz, 3 Amps
■Temperature:
–Operating: 32 to 104° F (0 to 40° C)
–Non-operating: -40 to 158° F (-40 to 70° C)
■Humidity: 15 to 95% relative humidity at 40° C with no
condensation
Avoid locations with the following characteristics:
Warning: To reduce the risk of fire, do not place the Commander
Site Controller near objects that produce excessive
heat.
■Direct Sunlight
■Moisture
■Excessive dust
■Electrical “noise” or devices that cause excessive voltage
variations, such as air conditioners, fans, or high frequency
security systems.
4Commander Site Controller Hardware Installation Guide
Unpacking Commander Site Controller
Carefully inspect the Commander Site Controller shipping carton and
its contents for any damage that may have occurred during shipment.
If an item appears damaged, immediately file a claim with the
shipping company or carrier, and notify your VeriFone representative.
Warning: Never use damaged equipment. A shock or fire hazard
may exist if equipment is energized in a damaged
condition.
Remove the following items from the shipping carton:
■Commander Site Controller
■Power cord
■Software licenses
■Commander Site Controller Hardware Installation Guide
Remove any protective plastic wrapping from the items and place
them on a table or countertop. Check to make sure that you have all
the parts listed above before you begin. Contact the VeriFone
Technical Support Center if you are missing any of the items.
Note: Keep the shipping carton and any packing material in case
it is necessary to move the Commander Site Controller
from one location to another, or to return the equipment
for service.
Indice
Altri manuali VeriFone Controllori
