IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of death, personal injury or property damage from fire, electric shock, falling
parts, cuts/abrasions and other hazards read all warnings and instructions included with and on the
fixture box and all fixture labels.
Before installing, servicing or performing routine maintenance upon this equipment, follow these
general precautions.
For Commercial Installation: Service and maintenance of this fixture should be performed by a
qualified licensed electrician.
For Residential Installation: If you are unsure about the installation or maintenance of this fixture,
consult a qualified, licensed electrician.
Do not mount the unit against flammable surfaces.
The motion detector will not operate correctly if it is
installed: Near the outlet of a central heating boiler
oNear an air conditioning unit
oPointing directly at moving vehicles
oWithin sight of reflection from moving water
oWhere other lamps could shine on the detector
Fixtures can NOT be used with a dimmer switch, motion or occupancy sensor and other electronic
switching devices unless otherwise designated. LED fixtures must be powered directly off a switch circuit.
Do not install more than one motion sensor light on one wall switch.
This fixture should not be used in areas with limited ventilation or high ambient temperatures.
This fixture is intended to be connected to a properly installed and grounded UL listed junction box.
These instructions do not claim to cover all details or variations in equipment or provide every possible
contingency to meet in connection with the installation, operation or maintenance. Should
further information be needed,
you may contact Customer Service at:
[email protected] WARNING: RISK OF ELECTRICAL SHOCK
Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
Verify that the supply voltage is correct. Connect fixture to a 120 volt, 60 Hz power source.
Make sure all electrical and grounded connections are in accordance with the National Electrical Code
and any applicable local code requirements.
All wiring connections should be capped with UL listed wire connectors.
CAUTION: RISK OF PRODUCT DAMAGE
Never connect components under load.
Do not mount or support these fixtures in a manner that can cut the outer jacket or damage wire insulation.
Avoid covering LED fixtures with insulation, foam, or other material that will prevent convection or conduction
cooling.
Never connect an LED product directly to dimmer packs, occupancy sensors, timing devices or other
related control device, unless individual product specifications deem otherwise.
Unless individual product deems otherwise: do not exceed fixtures maximum ambient
temperatures. LED products are Polarity Sensitive. Ensure proper polarity before installation.
Electrostatic Discharge (ESD) can cause damage to LED fixtures. Personal grounding equipment
must be worn during all installation or servicing of the unit.
Do not touch the individual electronic components, it may cause ESD, shorten lamp life or alter performance.
CAUTION: RISK OF INJURY
Wear gloves and safety glasses at all times when removing fixture from carton, installing,
servicing or performing maintenance.
Avoid direct eye exposure to the light source while it is on. LED LAMPS ARE EXTREMELY BRIGHT.
UNDER NO CIRCUMSTANCES SHOULD YOU STARE INTO AN LED BEAM, THIS MAY CAUSE
IRREPARABLE DAMAGE TO THE EYE.
Account for small parts and destroy packaging materials, as these may be hazardous to children
WARNING: RISK OF BURN
Allow fixture to cool before handling. Do not touch enclosure of light
source. Do not exceed the maximum wattage marked on the label.
Keep combustible and other materials that can burn away from the luminaries, fixture and lamp/lens.
2
