Vicon V600-C Series Manuale utente
V600-C Series
COLOR DOME CAMERAS
About this manual
INSTRUCTION MANUAL XX166-03-00
Before installing and using the camera, please read this manual carefully.
Be sure to keep it handy for later reference.
This installation should be made by a qualified service person and should conform to
the National Electric Code, ANSI/NFPA 70 and all local codes.
Installers should use appropriate hardware mounting materials.
This equipment generates and uses radio frequency energy and if not
installed and used properly, that is, in strict accordance with the
manufacturer’s instruction, may cause interference to radio and television
reception. It has been type tested and found to comply with the limits for a
Class A computing device in accordance with the specification in subpart B
of part 15 of the FCC rules, which are designed to provide reasonable
protection against such interference in a commercial installation. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause interference to radio and
television reception, which can be determined by turning equipment off and
on, the user is encouraged to try and correct the interference by one or
more of the following measures:
• Reorient the receiving antenna.
• Relocate the equipment with respect to the receiver.
FCC Notice
Note: Complies with Federal Communications Commission Rules &
Regulations Part 15, Subpart B for a Class A digital device.
WARNING
Warning: Power must be removed from this unit before
removing circuit modules or cables.
Caution: This unit contains circuit cards with integrated
circuit devices that can be damaged by static discharge.
Take all necessary precautions to prevent static discharge.
• Relocate the equipment away from the receiver.
• Plug the equipment into a different electrical outlet so that the
equipment and receiver are on different branch circuits.
If necessary, the user should consult the dealer or an experienced
radio/television technician for additional suggestions.
The user may find the following booklet prepared by the Federal
Communications Commission helpful:
“Interference Handbook, Bulletin CIB-2”
This booklet is available from the U.S. Government Printing Office,
Superintendent of Documents, Mailstop SSOP, Washington, D.C. 20402-9328,
ISBN 0-16-045542-1.
Dimensions : inch (mm)
PRECAUTIONS
■Do not open or modify
Do not open the case except during maintenance and
installation, as it may be dangerous and cause damages.
■Do not put objects inside the unit
Make sure that no metal objects or flammable substances
get inside the camera. It could cause fire, short-circuits or damages.
■Be careful when handling the unit
To prevent damage, do not drop the camera or subject
it to strong shock or vibration.
■Install away from electric or magnetic fields
■Protect from humidity and dust
■Protect from high temperature
Be careful when installing close to the ceiling , in a kitchen
or boiler room, as the temperature may rise to high levels.
■Cleaning
Dirt can be removed from the case only by wiping it
with a soft cloth moistened with a soft detergent solution.
■Mounting Surface
The mounting surface material must be strong enough to support the camera.
TROUBLESHOOTING
Before sending the camera out for repair, check the items below.
If the problem persists after checking these items, contact
your service center.
■If no image appears
Is the coaxial cable attached securely?
Are the power and voltage normal?
Has the iris of the lens inside the camera been
adjusted correctly (with the level volume) ?
Is there adequate illumination?
■If the image is unclear
Is the lens in focus?
Is the lens dirty?
Dirt or fingerprints on the lens can adversely affect the
images. Gently wipe any dirt or fingerprints off the lens
with a soft cloth or lens cleaning paper and cleaning
fluid (commercially available).
Is the monitor adjusted correctly?
WARNING:
TO PREVENT THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
LENS ADJUSTMENT
1. Adjust the panning(360˚) and tilt(60˚) position.
2. Set the zoom position by using Zoom Lever Screw.
3. Set the focus by using Focus Lever Screw.
4. Loosen set screws to adjust roll (turns camera position top/bottom).
SPECIFICATION - V600-C
General Spec NTSC PAL
CCD Type 1/3" 410K Pixels Color 1/3" 470K Pixels Color
Total number of pixels 811(H) X 508 (V) 795(H) X 596(V)
Min illumination
Video Output
Resolution
S/N Ratio
Shutter speed 1/60~1/100,000sec 1/50~1/100,000sec
Sync System
White Balance
OSD Control
DNR OFF, LOW, MIDDLE, HIGHT
SENSE_UP OFF/AUTO (X2 ~ X256)
AWB
MIRROR OFF/MIRROR/V_FLIP/ROTATE
PRIVACY 6 ZONE / SIZE
Power Input
Video Output
Voltage
Power Consumption
Operation temp
In storage temp
Operation humidity
DC 12V (11V ~ 16V) AC 24V (20V ~ 28V)
0.013 fc (0.14 Lux ) @ F1.2, 30IRE
1.0Vp-p/75 ohm Composite
560 TV Lines
50dB (AGC off)
Internal / External
Auto
Under 90％(Non-condensing)
ATW/ AWC/ MANUAL/ PUSH LOCK
Connector
2 WIRE
BNC Cable
Electric Spec
DC 12V : Max 1.8 [W] AC 24V : Max 2.4 [W]
Mechanical Spec
14 ~ 131°F (-10 ~ 55°C)
-4 ~ 158°F (-20 ~ 70°C)
■CONNECTIONS
CONNECTIONS AND CAMERA SETTINGS
CAUTION
The use of a UL Listed Class 2 power supply is required to ensure compliance
with electrical safety standards.
Check for polarity when using a 12VDC power supply.
Indice
Altri manuali Vicon Telecamera di sicurezza
Vicon
Vicon XX152-02-00 Manuale utente
Vicon
Vicon ROUGHNECK V910 Manuale utente
Vicon
Vicon V1020-WIR-180-1 Manuale utente
Vicon
Vicon V992D-IR Manuale utente
Vicon
Vicon V840D Series Manuale utente
Vicon
Vicon XX247-10-01 Manuale utente
Vicon
Vicon Roughneck V894CSH Series Manuale utente
Vicon
Vicon Surveyor MKII Series XX282-20-00 Manuale utente
Vicon
Vicon V8360W Series Manuale utente
Vicon
Vicon Surveyor MKII Manuale del proprietario
Vicon
Vicon V960D-W Series Manuale utente
Vicon
Vicon SVFT-MSH23C Manuale utente
Vicon
Vicon Roughneck V2100B Series Manuale utente
Vicon
Vicon V672B Istruzioni operative
Vicon
Vicon V15CCM-IR-2 Series Rouchneck Manuale utente
Vicon
Vicon V662-D-1 Istruzioni operative
Vicon
Vicon V9360-1 Manuale utente
Vicon
Vicon ALU-2500/230 Manuale di servizio
Vicon
Vicon Roughnec V922D Series Manuale utente
Vicon
Vicon VN-755IPV4 Manuale utente
